輸出力 的英文怎麼說

中文拼音 [shūchū]
輸出力 英文
force
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  1. A large member of experimental findings was analyzed. the output torque of rera and plate er actuator were compared. the results showed that the torque transferred by ripple actuator is larger decuple than that of plate actuator

    本文通過對大量的實驗數據進行分析,對波紋式與平盤式電流變傳動機構的輸出力矩進行比較,得波紋式要比平盤式所傳遞的矩大十倍的結論。
  2. The experiment apparatus has been developed, which is based on software ( labview ) and hardware ( pci board ni 6024e ). the displacements and generative force at the tip of the ipmc actuators were measured with respect to the different voltages, frequents and various waveforms which include square, sinusoidal, and triangular wave

    實驗選取了不同電壓幅值,不同頻率的方波、三角波、正弦波三種波形作為電激勵信號,利用高速攝像記錄ipmc的位移變形,並通過傳感器實測了ipmc試樣末端的輸出力
  3. It is concluded that maximum bending displacement becomes larger as the input voltage gets larger and the frequency becomes lower, while the curve of bending displacement is affected by waveform. in comparison with the little effect by various waveforms, the generative force at the tip of the ipmc actuators increases as the input voltage gets larger and the frequency becomes lower

    結果表明,電壓幅值和頻率對其位移變形的大小影響較大,波形對其位移變形的軌跡影響較大;電壓幅值和頻率對其輸出力的大小影響較大,而波形對其輸出力影響較小。
  4. Nibco actuators are manufactured in a wide range of output torque and operating speeds to fit your specific requirements

    美國尼伯科執行機構輸出力矩和運轉速度范圍大,能夠滿足用戶的各種要求。
  5. By using the larger magnetic permeability, magnetic fluid was used to improve the magnetic circuit efficiency in torque motor, enlarge the output torque and displacement of torque motor, and the output flow of servo valve. correspondingly, the ability of noise - overcoming and system damping was enhanced due to the property of magnetic fluid. as a result, the stability of servo valve and servo - control system can be improved

    由於磁流體具有較大的導磁率,可提高矩馬達磁路效率、增大矩馬達的輸出力矩和位移,從而增加伺服閥的流量;同時,利用磁流體的粘度特性,可增強矩馬達阻尼及抗干擾能,從而增強伺服閥及伺服控制系統的穩定性。
  6. Firstly, the hertz contact theory is used to design the export moment of the prototype ; deformation status of the flexspine under the elliptical cam wave generator action is analyzed using the column shell theory, whose boundary condition is four force action. design proposal of the wave producer put forward considering the precision theory of rolling friction transmission

    首先用赫茲接觸理論對樣機的輸出力矩進行了設計;應用四作用下的光滑圓柱殼體理論分析了在橢圓凸輪波發生器作用下柔輪的變形狀況,結合滾動摩擦副傳動精度理論提了波發生器總體設計方案。
  7. Mainly used for home appliances such as electric stove, electric oven grill oven and roasting jack features : high performance, low mechanical noise, high output torque, and long life

    此種機型常應用電烤爐烤箱烤肉叉轉動器。具有輸出力矩大性能穩定噪聲低壽命長的特點
  8. The relations of recoil mass to output force and recoil force was obtained based on the experiments

    摘要在試驗的基礎上得手提式電磁鉚槍回彈體質量對輸出力和后坐的關系。
  9. When the electrohydraulic push rod works, if the external force suffered by the piston rod is more than the setting output torque, the piston moves to the end ; oil pressure in the oil pipeline increases rapidly to the setting value, the safety valve overflows rapidly, to achieve overload protection

    電液推桿工作時,當活塞桿所受外超過調定的輸出力距活塞運動到終點;油路中的油壓迅速增高至調定值,安全閥迅速溢流,實現過載保護。
  10. Firstly, this paper proposes the mathematical model and finite - element analysis model of torque motor with mf and without mf. secondly, the electromagnetic field of torque motor is analyzed using the ansoft maxwell software ; static output torque of torque motor with mf and without mf is calculated. then the rotary angle of torque motor with different input electric current and mf is measured using three - coordinate measurement device

    本文首先給了添加磁流體和不添加磁流體的矩馬達磁路數學模型及有限元分析模型,其次,利用ansoft公司的maxwell電磁場分析軟體進行了矩馬達的二維和三維磁場有限元分析,對添加磁流體和不添加磁流體的矩馬達靜態輸出力矩進行了計算,並採用三坐標位移測量儀對不同入電流作用下、添加不同特性磁流體時矩馬達的轉角進行了測量,從而對輸出力矩特性進行了實驗研究。
  11. A gearing mechanism of a motor vehicle engine that reduces the power output required to maintain driving speed in a specific range by lowering the gear ratio

    (汽車的)超速檔機動車輛的一種齒輪裝置,通過降低齒輪比率來減少為將車速保持在一定范圍內而需要的輸出力
  12. Magneto - rheological ( mr ) fluid dampers have recently emerged as enabling technology for implementing semi - active control in a variety of application because of their mechanical simplicity, low operating power requirements, environmental robustness, and demonstrated potential for developing forces sufficient for applications

    實踐證明,磁流變阻尼器具有結構簡單、消耗功率小、抗污染和輸出力大等優點,有可能在實際的半主動控制中得到應用。
  13. The main contributions of the dissertation are as follows : on the basis of experimental results, the operational effects, such as the magnitude of magnetic field, the temperature and the rate of shear strain, on the shear stress of the mr fluid are shown and models of the quasi - bingham model and a nonlinear model for the shear stress of the mr fluid also are developed, in which the characteristic of " shear - thin " of the mr fluid is described

    論文的主要貢獻如下:通過測試磁流變液剪切應與磁感強度、剪切應變速率、溫度的變化規律,建立了能反映磁流變液剪切變稀現象的剪切應與剪切應變速率的磁流變液模型。根據磁流變液模型,從理論上建立了能在較寬的電壓內范圍比較準確地預報磁流變阻尼器輸出力的近似公式。
  14. The thesis studies the displacement and force characteristics of the ipmc actuator

    本文研究了ipmc的一些重要特性,如位移特性和輸出力特性。
  15. Air braking systems ; air - pressure cylinder ; brake chamber, method of measurement of the output - force over the stroke

    空氣制動系統.氣壓缸.第10部分:制動箱沖程輸出力
  16. Relation between temperature and output force displacement is determined by constitutive relation of sma

    Sma驅動器溫度與輸出力位移之間的關系由sma本構關系決定。
  17. This new - active member includes a piezoelectric actuator, a micro - placement sensor to measure the output placement and output force

    該主動構件由壓電作動器、傳感器等組成,具有位移和輸出力的功能。
  18. The experimental results showed that under certain conditions of preloaded press and bias magnetic field, a satisfied static characteristic was obtained

    試驗結果表明超磁致伸縮致動器在合適的偏置磁場及預壓作用下,能達到較佳的電流-位移及電流-輸出力響應特性。
  19. Meanwhile, the output control forces are identical if the used actuators have the same capacity limitation, and those certainly simplify the design of controllers and let the multi - control system not to be used

    並且當採用同樣容量限的多個作動器時,控制輸出力一致,從而避免設計多個控制系統,簡化了控制器設計。
  20. A new type piezoelectric active member adopted in the thermo - modality control of intelligent structure was designed and manufactured. and the relations between its working properties, output displacement, output force, etc. and various influence factors were studied through experiments

    設計製造一種可用於智能結構熱動態控制的新型壓電主動構件,並通過實驗研究其工作性能:位移、輸出力特性與各種影響因素之間的關系。
分享友人