輸出器 的英文怎麼說

中文拼音 [shūchūqì]
輸出器 英文
take off case
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. In this paper, the concept of acceleration ambiguity function ( aaf ) and acceleration resolution is put forward for the first time. using aaf, the effects of target ' s relative acceleration on several outputs of a linear - phase matched filter are analyzed, such as the output signal - noise - ratio loss, the doppler resolution, the constraint on optimal accumulative time ( opt ) and their tolerable limits

    論文首次提出並研究了加速度模糊函數和加速度分辨力的有關概念，並以加速度模糊函數為分析工具，詳細討論了加速度對線性相位匹配濾波器的輸出信噪比的損失程度、對多卜勒頻率分辨能力的影響程度、對最優相參積累時間的約束關系以及線性相位匹配濾波器輸出受加速度影響的容限等問題。
  2. The outputs of these accelerometers are the three coordinates of the inertial velocity of the vehicle with the exception of gravity effects.

    這些加速度計的輸出是三個沒有重力影響的飛行器慣性速度座標。
  3. Its tunable wave - region is over 100nm ( 701 812nm ) with the characteristics of simple manufacture and compact structure ; pulse with high energy can be obtained through q - switch for longer life ( 260us ) particles in upper level in this paper, tunable and q - switch mechanism and principle of working material alexandrite ( cr3 + : beal204 ) is firstly expatiated and analyzed. the experiment of tenability ( et ) and experiment of q - switch ( eq ) is proved feasible

    該激光器波長在701 - 826nm之間，製作容易，結構緊湊；上能級粒子壽命長（ 260 s ） 、調q容易得到大能量輸出本論文首先對激光工作物質?紫翠寶石（ cr ~ （ 3 + ） ： beal _ 2o _ 4 ）的調諧與調q原理和機制進行了解釋與分析，確定了調諧與調q實驗的可行性。
  4. Part of the output of an amplifier can be fed back to get rid of sound distortion.

    放大器部分輸出可以進行反饋以消除聲音的失真。
  5. A facsimile of the original amplifier outputs is then reconstructed inside the computer.

    一個放大器原來輸出的復製品就送到處理裝置中去。
  6. Abstract : radiate thermometer uses a high definitive operation circuit in the modulation and linerization of weak optical signals. the theory of colorimetry was used in measuring the temperature. analogic channel and digital interfaces were added in order to expand the instrument. a kind of double channel ' s photocolorimeter including its hardware and software is introduced

    文摘:輻射測溫計採用高精度運算電路，對光弱信號進行調制和線性化處理，運用比色法原理對溫度進行檢測.為了便於儀器擴展，增加了模擬量輸出和數字介面，並對光纖式雙通道比色高溫儀的硬體與軟體的關鍵部分作了簡要介紹
  7. The theory of wilkinson power combiner and ratrace coupler is analyzed by using the odd - even mode method in this thesis. on the basis of the theoretical analysis, we designed and tested the wilkinson power divider, the modified wilkinson power divider and ratrace coupler, good agreement is observed. in addition we propose a power combiner based on a waveguide - to - microstrip transition using antipodal finlines. this structure united the two functions of transition and equal power division, it can not only be used in the circuit power combiner but also be used in spatial power combiner

    另外提出一種基於鰭線波導微帶過渡功分器，該結構將過渡與功分兩種功能完全結合，不但可以用於電路合成式功率合成，也可用於空間功率合成中。對功率合成器，其主要指標是輸出功率和效率，其中提高輸出功率和效率的一個方法是在輸出端抑制諧波，主要是對二次諧波的抑制。
  8. If this output does not switch between h and l anymore a hard-ware reset is produced and the processor is initialized again.

    如這個輸出不再在高電平和低電平間作切換，硬體復位就會產生，並將處理器再次初始化。
  9. Type bcc audio frequency output transformers

    Bcc型音頻輸出變壓器
  10. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  11. One new type double backspin rotor type sand mixing machine passes technique appraisal of qingdao tianheng machinery co., ltd. this machine adopts double rotor configuration researched internationally ; the rotor is installed on different output axis of same reducer, which produces comparative cross cutting speed by using rotors with different speed that makes sands get strong cutting and friction force. therefore, it can reduce clay and quicken sand mixing

    一種新型雙逆轉子式混砂機在青島天恆機械有限公司通過技術鑒定，該機採用國際首創的雙轉子結構，其轉子安裝在同一減速器的不同輸出軸上，利用兩個軸的不同轉速使轉子間產生相對交叉剪切速度，使砂子受到的沖剪及搓擦力加強，從而減少粘土團，加快砂子的混合。
  12. The output signal from the detector may be the blackening of a photographic emulsion.

    探測器的輸出信號可以是照相乳膠的黑度。
  13. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  14. Bootstrap cathode follower

    自舉陰極輸出器
  15. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  16. 3. we also provided algorithms to get non - electrical contacts and exporting / importing components from relay control systems ; depending on generic engineering drawing expression, these algorithms can identify non - electrical contacts

    3 .本文利用繼電控制線路的通用工程圖表達方式，設計了獲取繼電控制系統的非電氣聯系和輸入輸出器件的演算法。
  17. Cathode follower circuit

    陰極輸出器電路
  18. Cathode follower probe

    陰極輸出器探頭
  19. Fibre optic fan - outs - part 1 : generic specification

    纖維光學扇形輸出器.第1部分:總規范
  20. Iec 61314 - 1 - 2005. fibre optic fan - outs - part 1 : generic specification iec 61314 - 1 : 2005 ; german version en 61314 - 1 : 2005

    光纖扇形輸出器.第1部分:總規范
分享友人
分享到 Line

分享到臉書