輸出阻抗 的英文怎麼說

中文拼音 [shūchūzǔkàng]
輸出阻抗 英文
impedance, output
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  • 阻抗 : [電學] impedance
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. A novel high output resistance current source based on negative resistance

    一種基於負電阻的高輸出阻抗的電流源
  3. This effects can be explained as follows : the radiation conditions are actually impedance matching condition in terms of microwave network, for a fixed dimension of a resonator and output transformer, only below the critical plasma density ", the matching condition can be satisfied in the smith circle map

    我們提出，這一現象可從阻抗匹配的角度來解釋。對於一確定尺寸的腔體、阻抗變換器，存在一個等離子體密度的臨界值，只有在等離子體密度低於這個臨界值時，腔體的輸出阻抗和波導的特性阻抗才能滿足匹配，即滿足所謂的輻射條件。
  4. This paper introduces several dielectric foil switches, analyzes their characteristics in respect of the output pulse shape, switch mechanism and output impedance etc

    摘要介紹了國內外幾種絕緣薄膜開關，從開關的結構、對應的輸出方波波形和輸出阻抗等幾個方面進行了比較，分析了其各自的優缺點。
  5. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  6. Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s output impedance

    技術上，阻尼因子就是指定的負載阻抗（實踐中，也就是揚聲器系統）除以放大器的輸出阻抗。
  7. Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s [ i ] output impedance [ / i ]

    技術上，阻尼因子就是指定的負載阻抗（實踐中，也就是揚聲器系統）除以放大器的輸出阻抗。
  8. By the means of theory, simulation and experiment, the second part of this paper is then analyzed which is on the equivalent output resistance and inductance of the selected inverter and the effect to the output voltage ' s amplitude and phase caused by the different values of the inverter ' s component. it is concluded that by selecting certain precision level components, the difference of the output voltage amplitude is much greater than that of the output voltage phase

    其次通過理論、模擬和實驗分析了本文所採用的電壓電流雙閉環瞬時控制方式逆變器的等效輸出阻抗和兩臺逆變器器件差異對輸出電壓的幅值差和相位差的影響，從而得出選用一定精度的器件，兩臺逆變器輸出電壓的幅值差比相位差大得多的結論。
  9. While low voltage and low power is realized when designing the operational amplifier in this text, great efforts have been devoted to increasing the input common mode range and the swing of output signal, and lowing the output resistance at the same time

    只是實現低壓低功耗而不實現良好的性能顯然是錯誤的。本文在設計實現低壓低功耗的運算放大器的同時，也想法提高輸入共模範圍和輸出信號的幅度，同時降低輸出阻抗。
  10. One of the things about amplifiers that affects how they can drive a speaker system is the amplifier ' s output impedance

    輸出阻抗是能夠影響放大器如何推動揚聲器系統工作的諸多因素之一。
  11. It also has a low impedance, which assures that the typical unbalanced output impedance is between 100 and 1000 ohms

    同時它的低阻抗可以確保典型的非平衡輸出阻抗保持在100到1 ， 000歐姆之間。
  12. The use of this instrument by both engineering and production permits quick and accurate characterization of the input and output impedance, gain, reverse isolation of individual units and the degree of match between units

    工程以及產品通過使用這種儀器可以迅速準確的獲得輸入/輸出阻抗、增益、獨立單元的反向隔離以及兩個單元之間的匹配程度。
  13. The condition that exists when two coupled circuits are adijusted so that the outp - ut impedance of one circuit equals the input impedance of the other circit connec - ted to the first, there is a minimum power loss between two circuits

    指一個存在的條件，當調整兩個偶合電路使得其中一電路的輸出阻抗與另一電路的輸入阻抗相等進稱之，當他們連接的阻抗相等時，兩電路間的能量損失最低。
  14. Transistor hi - fi power amplifier, the output impedance is low, can actuate the speaker well

    高速晶體管hi - fi功率放大器，輸出阻抗低，能更好地驅動揚聲器。
  15. During the exaltation of output signal swing, the adoption of the resistance connecting across can reduce the output resistance

    在提高輸出信號幅度的同時，採用跨接電阻的方式減少輸出阻抗。
  16. One of the things about amplifiers that affects how they can drive a speaker system is the amplifier ' s [ b ] output impedance [ / b ]

    輸出阻抗是能夠影響放大器如何推動揚聲器系統工作的諸多因素之一。
  17. The maximum output impedance only occurs at the volume control maximum, and quickly goes to a low figure below the maximum level position

    最大的輸出阻抗只會在最大音量時出現，並且當音量低於最大值時它會迅速降低。
  18. The lower it is, the better the amplifier can present needed current to the speaker system, assuming that in other ways ( such as frequency response ) the amplifier performs well

    假如其他因素對放大器的工作狀態沒有影響的話，輸出阻抗越低，放大器就能夠更好地為揚聲器系統提供所需的電流。
  19. Power : put to say to, and the sum settle the power to is just valid index sign that evaluate the to put the function. it points within the scope of certain of the wave lose true, and the make longer a work can biggest power of the output s. enlarger while connecting into the box of the different resistance that exportation power can have different, usually the enlarger can mark clearly its sum to settle the exportation resistance ; for example a sum that set enlarger while loading a resistance to settle the exportation power to the, and load the resistance to may increase the the above. because the power there is method of various marks, some and illegal factory to can have intention to exaggerate the data, purchase or choose the hour to want with physically hear the to take in to distinct, comparison

    它是指在一定的諧波失真范圍內，功放長期工作所能輸出的最大功率。放大器在接入不同阻抗的音箱時的輸出功率會有所不同，通常放大器會標明其額定輸出阻抗例如一臺放大器在負載音箱阻抗為時的額定輸出功率為，負載阻抗為時就可能增加到以上。因為功率有多種標法，某些不法廠商會有意誇大數據，購買或選配時要以實際聽音加以區別比較。
  20. If the speaker needs more current ( its overall impedance drops ) then a lower amplifier output impedance will allow that current to be drawn out of the amplifier without causing much of a change in the applied voltage - and that means less distortion

    如果揚聲器需要更大電流（揚聲器的整體阻抗降低） ，那麼一個低輸出阻抗的放大器可以容許在輸出相應電流的同時，所施加的電壓變化更小，這也意味著失真更小。
分享友人
分享到 Line

分享到臉書