輸出電 的英文怎麼說

中文拼音 [shūchūdiàn]
輸出電 英文
output resistance
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Indicator for working status, level adjusting point and level testing point are on the front panel

    模塊前面板有工作狀態指示燈及電平調整點電平檢測點，輸出電平大於108dbuv 。
  2. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  3. In this paper, a kind of output current feed - forward circuit is added into the input of the current loop. by adding this compensatory circuit, the output character of the inverter is improved greatly

    本文還研究了一種提高逆變器輸出電壓外特性的思路，通過將負載電流正反饋給逆變器的電流環輸入端，從而達到提高輸出電壓的外特性的目的。
  4. In addition, we analyse the dead time effects of pwm control on the output waveform

    另外還分析了逆變橋上下管驅動信號上的死區對輸出電壓波形的影響。
  5. Hello, these photos had been sended, both were producted for users before, our main product is pcba. because each of users ' s demand is different, for example production ' s input / output voltage, could you send more information about demandable product to me, please

    你好，你發給我的這些圖片都是我們以前為客戶生產的，我們主要是做pcba ，因為每個客戶的需求不一樣，比如說產品的輸入輸出電壓，請問你可以把你需要的產品的詳細資料發給我嗎？
  6. When the voltage of the primary fluctuated is within the range of 5 %, with mediating the saturation of the magnetic flux, this new interfluent stable power supply can retain the outputting power of the secondary invariable

    當一次側電壓在5 %額定電壓范圍內波動或偏移時，通過調節磁路的飽和程度，保持二次側輸出電壓不變。
  7. High output level, low noise and low non - linear distortion

    輸出電平高，低噪音和較小的非線形失真。
  8. Uses philips modules and high quality, sensible pin photo - diode, provides high rf output, low noise and low non - linear distortion

    採用飛利浦光電模塊和優質量高靈敏度pin光電二極體，輸出電平高，低噪音和較小的非線性
  9. With the stringent requirement of low output voltage and high output current, semiconductor diode is necessarily replaced by synchronous rectifier to minimum voltage drop. because the existed driving schemes can not drive srs properly, two novel driving schemes for synchronous rectifiers in magnetic amplifier post regulating circuit are proposed in this paper

    已有的同步整流管驅動電路主要面對多路輸出的主輸出電路，而應用磁放大器調節的輔助輸出電路同步整流管的驅動，現有的方法存在磁放大器調節與同步整流管驅動的失配，降低了開關電源的效率。
  10. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  11. Mol maximum output level

    最大輸出電平
  12. Ohmic resistance measured between the output voltage connections

    輸出電路測得的電阻歐姆
  13. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬帶放大器頻帶寬度的因素，通過分析mosfet的本徵參數、寄生參數對頻率特性的影響，提出了採用短溝器件、使mosfet工作在飽和區、抬高柵源電壓等提高mosfet特徵頻率的方法；分析了不同電路組態對放大器頻率特性的影響、節點電壓對電壓模電路、電流模電路頻率特性的不同影響，根據應用於雙極晶體管電路的跨導線性原理，提出了採用mosfet構成的電流模放大電路、電流傳輸電路、輸出電路以及由它們所組成的寬帶放大器，獲得了良好的頻率響應。
  14. Carries created by ultra - fast laser pulse accelerate in the field of the photoconductor and form a transient photocurrent. the shape of the photocurrent lies on the movement of the carriers, as well as the movement of the carrier ' s lies on the field in the photoconductor

    光電導體中的載流子在光電導體內的運動情況決定了所輸出電脈沖的波形，而載流子的運動是在光電導體內部電場的作用下進行的，所以光電導體內的電場對光電導開關的性能有顯著的影響。
  15. In the part of detector, it mainly introduces the design of liquor tubes, heater, pressurize, and thermocouple ; in the part of controller, this design uses tms320lf2407 as the cpu. the design part mainly introduces controller circuit design which mainly contains data collection circuit, prepositive magnifying circuit, a / d convert circuit, failure self - diagnosis circuit, the tms320lf2407 interface circuit, temperature control circuit, display circuit, 4 ~ 20ma standard signal output circuit ; in the software part, it mainly introduces software chart of main program and partly linearization subprogram design

    檢測器部分重點介紹了導流管的設計、加熱器的設計、密封技術的設計以及測溫電路的設計;控制器部分以tms320lf2407為核心，重點介紹了控制器電路設計，主要包括數據選擇電路、前置放大電路、 a / d轉換電路、故障自診斷電路、 tms320lf2407介面電路、控溫電路、顯示電路、 4 20ma標準信號輸出電路共八個部分;軟體設計重點介紹了主程序軟體設計及分段線性化子程序設計。
  16. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  17. It enables the rotor with constant speed for maintaining steady output voltage.

    它使轉子能以恆定速度轉動，保持輸出電壓穩定。
  18. The secondary current will be distorted when the ct undergoes saturation, which will bring some influence on the distance relay inevitably. furthermore more and more people pay attention to this problem

    飽和后的電流互感器二次側輸出電流產生畸變，不可避免地對距離繼電器造成一定的影響，而且這個問題越來越受到保護工作者的重視。
  19. Switching on avr self - detecting fuction : to keep outupt voltage correct, this fuction will avoild any output immediately while the avr just swith on

    開機自我檢測功能：可防止開機馬上送電輸出，以確保輸出電壓之正確性。
  20. The approximate computation method is used in float point computation of system ' s control algorithms on fixed - point dsp after comparing several methods in respect of running time and program space involved, which attains quick computation besides high precision and implements output voltaic with low harmonic and high control precision of frequency

    通過從運行時間和佔用空間等方面比較在定點dsp上實現浮點數運算的幾種方法，並選擇了近似計演算法作為系統控制演算法浮點數運算的方法，在保證足夠計算精度的前提下達到計算的快速性，實現低諧波和頻率控制精度高的輸出電壓。
分享友人
分享到 Line

分享到臉書