輻射聲壓 的英文怎麼說

中文拼音 [shèshēng]
輻射聲壓 英文
radiation sound pressure
  • : 名詞(車輪中車轂和輪圈的連接物) spoke
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  • : 壓構詞成分。
  • 輻射 : radiation; exposure; radio; beaming
  1. Introducing the theory and application of boundary element method on the sound radiation, giving the process of solving vibration noise radiation problem using boundary element analysis software ; presenting the coupling theory and the combination analysis of finite element method and boundary element method, and doing relevant analysis based on close drum shell ; programming the noise data simulation program using the numerical calculation software, simulating the acoustic and pressure data of a key point in the transient response acoustic field of the close drum shell, realizing the audibility of the noise, using the virtual reality tools to simulate the vibration noise of the drum shell ; combining the finite element method and boundary element method to analyze the vibration noise radiation of some gear box, and completing the whole simulation process of the vibration noise of the gear box

    綜合介紹了邊界元法在問題上的理論及應用;並給出了運用邊界元法分析軟體求解振動問題的過程。闡述了有限元法和邊界元法的耦合理論及組合分析方法,並以封閉鼓形薄殼為分析對象進行了相應的分析。利用數字計算軟體編制了噪數據模擬程序,並模擬了通過組合方法分析封閉鼓形薄殼瞬態響應場而獲得一關鍵點的數據,實現音的可聽化,隨后通過虛擬現實工具實現了該情形下橢球殼振動噪的虛擬模擬。
  2. First, it was taken that a discuss about the effects of geometry parameters of each piezocrystal on direction parameters ( main lobe width, side lobe amplitude, elimination of grating lobes ), amplitude of ultrasonic pressure, element viberation pattern, mutual radiation among elements, efficient test regions, ability to keep accurate and near - field distance and so on. based on the direction of ultrasonic field in ulpa deduced by ourselves. in addition, on the base of integrating all kinds of factors, it was put forward that the principle and method for optimized design of geometry parameters of piezocrystals in ulpa transducer, and its design programme and interface were compiled

    首先在推導超相控線陣換能器場的指向性的基礎上,就各個晶片幾何參數對指向性指標(主瓣寬度、旁瓣幅度、消除柵瓣) 、幅值、陣元振動模式、陣元間互、有效檢測區域、精確控制能力、近場長度等方面的影響進行了論述,並在綜合各方面影響的基礎上,提出了晶片幾何參數優化設計的原則和方法,編寫了設計程序和界面。
  3. Firstly it discusses the value, meaning, background and method of this topic. then it deducts the single - bubble sound pressure, spectrum of sound pressure, power spectrum. according to the real situation of traveling bubble cavitation noise around a schiebe body, the mathematical model of single - bubble collapse is selected, furthermore, the mathematical model of mass traveling bubbles without interference effect is established, and the multi - peaks and rebound phenomenon while bubbles collapse is also analyzed with statistical method

    首先論證了本項研究的意義,價值,背景和方法,然後推出了單空泡譜和功率譜,針對回轉體流動泡空化噪的具體情況,選擇了雙指數模型作為單空泡潰滅的數學模型,進一步建立了無干涉條件下的群泡的數學模型,並用統計的方法分析了空泡潰滅時的多峰值和反彈現象。
  4. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測熱計在施加偏置電的情況下,電熱效應與紅外的共同作用使它表現出與其他紅外探測器完全不同的一些特徵,文中給出了響應率、噪、噪等效功率、噪等效溫差、光學增益、探測率等參數的計算方法,這些參數中的部分是微測熱計獨有的,或者與其他的紅外探測器的同一參數有所區別。
  5. Since there exists ill - posedness in reconstructing velocity on the surface and reconstructing pressures in the field, this paper attempts to introduce an iterative regularization method to resolve such inverse problems

    輻射聲壓重構結構表面振動速度和存在解的離散病態問題,試圖利用一種迭代正則化方法來解決此類逆問題。
  6. Piezoelectric elements were bonded on the plate as actuators and the input voltage of each actuator was determined by the velocity of its position and volume velocity of the plate was made zero, through which the sound radiation from the plate could be controlled

    在簡支薄板表面粘貼電片作為致動器,根據所處位置的速度確定輸入控制電,並使平板的體積速度為零,從而達到控制的目的。
  7. More often than not the combustion noise refers to the noise radiated from the cylinder cap, piston, rod, crankshaft to the engine body propelled by the pressure vibration generated out of the combustion inside the cylinder

    燃燒噪和機械噪很難嚴格區分,通常將由於氣缸內燃燒所形成的力振動通過缸蓋、活塞-連桿-曲軸-機體向外的噪稱之為燃燒噪
  8. Numerical simulations were performed and results show that significant attenuation of radiated acoustic power can be obtained, and sound radiation cancellation performance becomes better in low and medium frequencies

    進行了數值模擬,模擬結果表明,應用電片能有效地抑制吶設備中障板,抑制中低頻的效果更好。
  9. According to the integral characteristic of pvdf film, two pvdf sensors are designed to measure adjoint coefficient of sound radiation mode in this paper. based on the theory of sound radiation and two - dimensional modal sensors equation, and taking a simply supported plate as example, we measure mode l, mode 2 and mode 3 adjoint coefficient of its sound radiation by the sensors

    本文是在模態理論以及兩維分散式電傳感器方程的基礎上,利用pvdf獨特的積分特性,以簡支矩形板為例,設計了pvdf電薄膜傳感器用於測量簡支板第一、二、三階模態伴隨系數。
  10. Matlab procedure is coded to compute the far - field sound pressure levels of the shell excited by radial point force. the influences of modal truncation, stringers, bulkheads and damping on the shell ' s far - field sound pressure are analyzed, laying down the basis for accurate analysis of the sound radiation from fluid - loaded reinforced double cylindrical shells

    本文用matlab編製程序求解了單層殼在徑向激勵力作用下的遠場級,分析了模態截斷數、縱骨、艙壁板、結構阻尼等因素對殼體遠場輻射聲壓的影響,為準確計算加筋雙層殼在水下振動和特性奠定了基礎。
  11. Based on the acoustic radiation mode analysis, the transfer matrix relating the pressure at every field point to normal component of surface velocity is formed

    摘要基於模態分析,建立了外部場和結構表面振動速度之間關系的傳遞矩陣。
  12. Modal analysis of k5206nm compressor block is done, and the acoustic radiation modal parameters are calculated, then the acoustic radiation properties of the compressor block can be obtained, which provide the basis for the low noise compressor block design

    對k5206nm縮機機體進行了模態分析和模態參數計算,獲得了機體的特性,從而為機體的低噪設計提供了依據。
  13. Using finite element and boundary element method, a modal analysis model of complex structural acoustic radiation in light fluid is proposed for computing modal acoustic radiation frequency, farfield sound pressure, modal radiated acoustic power and acoustic radiation efficiency

    摘要採用有限元和邊界元方法建立了輕流體介質中復雜結構振動的模態分析模型,可計算結構的模態頻率、模態場點、模態功率和效率等場特性參數。
  14. This paper is aimed to provide a computational method of sound radiation from the pressure and non - pressure hulls of submarines subjected to harmonious point forces. it is significant for reducing vibration and sound radiation of the submarine hull, guiding the optimization design of submarine and enhancing its battle ability

    本文尋求潛艇耐和非耐船體結構受激振動的計算方法,分析潛艇結構的影響因素,對降低艇體振動和的噪,以及潛艇結構進行隱身優化設計、提高其戰鬥力具有十分重要的理論指導意義。
  15. Currently, zno is attracting attention for its application to uv light - emitters, varistors, transparent high power electronics, surface acoustic wave devices, piezoelectric transducers, gas - sensing and as a window material for display and solar cells

    目前, zno由於在紫外光、變阻器、透明高功率電子器件、表面波器件、電傳感器、氣敏傳感器及作為顯示器件和太陽能電池窗口材料方面的廣泛應用而引起人們極大關注。
  16. Squeezing effects of the atom, one very important quantum effect in its interaction with light have also attracted much attention due to its significance in decreasing the quantum noise caused by atomic movement

    原子縮效應是原子與場相互作用中呈現的重要量子效應。研究縮的原子對于了解減小原子行為的量子噪的途徑具有重要意義,因此該領域也受到人們的廣泛關注。
  17. Radiation pressure and directional pattern of flexural vibrating air - borne ultrasonic transducer

    氣介式彎曲振動換能器的輻射聲壓及其指向特性
  18. Then acoustic radiative pressure level is computed with a 3 - d fe acoustic - field model and bounary conditions imported from the result of vibration response by infinite fem

    建立齒輪箱外場二維有限元模型,導入齒輪箱振動響應結果作為學邊界條件,並採用無限有限元法計算了輻射聲壓級。
  19. The research of this paper starts from mechanical vibration, then goes deep into the noise radiation caused by vibration and calculates the relevant acoustic and pressure field. the purpose of this research lies in the virtual reality of the mechanical vibration and noise based on the above acoustic and pressure field

    本文的研究目的在於,從對機械結構的振動的研究開始,深入到對由振動引起的噪的研究,計算得到相應的場,並據此實現對機械振動噪的虛擬再現。
  20. The authors have observed the progress of deformation and destruction of coal bodies in the experiment, carried out the macroscopic and microscopic research of the destruction progress of coal samples under load by means of servo electro - hydraulic loading test and electromagnetic radiation and audio emission monitoring, analyzed the cracking rate of coal samples under different situation, investigated the formation and development of cracking by use of fracture and elasticity mechanics, and thus established a sound experimental basis for the prediction by using gray classification

    摘要進行了煤體變形破壞過程實驗,利用電液伺服加載試驗、電磁監測手段,從宏觀、細觀、微觀三個方面對煤樣受載破裂過程進行試驗研究,分析煤樣的裂隙發展速度及其所處的不同的狀態,並參照目前的預測方法提出了煤與瓦斯突出危險狀態灰色分類方法。
分享友人