輻射計數管 的英文怎麼說

中文拼音 [fúshèjìshǔguǎn]
輻射計數管 英文
radiation counter tube
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 輻射 : radiation; exposure; radio; beaming
  • 計數 : count; tally; counting計數卡 numbered card
  1. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  2. The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method

    本文系統的介紹了速調管的工作原理、主要特點、發展概況、主要性能指標和技術特點，解析的研究了電子束在相對論速調管放大器的調制腔和漂移管中的預群聚;用粒子波互作用的場方法導出了在輻射腔中預群聚電子束產生輻射的自洽方程，同時對線性區的增益進行了計算。理論分析表明，場分析法可用於計算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調管輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因數等特性參數。
  3. External diameters of cylindrical radiation probes containing geiger - m ler or proportional counter tubes or scintillation detectors

    裝有蓋格-彌勒計數管或正比計數管或閃爍探測器的圓柱輻射探頭的外徑
  4. At the same time, the author briefly analyses the distribution of original provinces, tourism motives and tourism purposes about these domestic tourists. in chapter five, taking xidi village and hongcun village for examples, based on lots of statistical data, the author summarizes the temporal characteristics of tourist flows to ancient villages and makes a comparison with others. he also discusses the reasons affecting it, such as events, social factors, natural environmental factors, radiating effect of mt

    第五章以西遞、宏村為例，在大量旅遊客流統計數據的基礎上總結出古村落旅遊客流時間分佈特徵；從事件、社會因素、自然環境因素、黃山的輻射效應、管理體制及經營管理水平等方面對西遞、宏村客流時間變化的影響因素展開深入探討；文章進一步討論了不斷攀升的客流所帶來的影響，並提出了相關建議與對策。
  5. The compact algorithms for heat release from floor, indoor thermal environment, control characteristic and energy efficiency of room with imbed pipe floor heating system were studied in this dissertation. the heat release from floor is key nodes in designing of imbed pipe floor heating systems. the existing plate fine model is corrected to improving its accuracy by amending the temperature of fine root

    文中對原有的平面肋片簡化演算法採用了肋基溫度修正，提高了其計算準確度；根據埋管低溫熱水輻射地板結構特點，利用地板導熱形狀因子計算地板當量熱阻，首次提出了更為簡便的當量熱阻演算法，該演算法將影響地板傳熱的物性參數和各種結構參數歸結到當量熱阻中，方便於工程分析和計算。
  6. The author chose two typical rooms to study floor radiation heating system, analyzed change of temperature of every radiation surface in detail, and computed and analyzed the exchanged quantity of heat and room quality of room comfort. the paper analyzed the running parameters - temperature, flux, cop etc - of the gshp combined floor radiation heating system of four conditions which depend on the amounts of the turned on single vertical u - tube heat exchanger. the four conditions are as follows : condition that turning on 26 heat exchangers, condition that turning on 12 heat exchangers, condition that turning on 16 heat exchangers, condition that turning on 20 heat exchangers

    本論文選擇了兩個典型房間主要對地板輻射採暖房間的各輻射面的溫度變化情況進行了詳細的分析，並對地板的散熱量和房間的舒適性進行了計算分析;並且以開啟不同數量的地源熱泵埋管換熱器進行了四個工況的測試並進行了詳細的分析和計算，分別為開啟全部地下埋管、開啟埋管12組、開啟埋管16組、開啟埋管20組。
  7. The main work and the conclusion are as follows : based on the parameter of the 10kw space solar power system designed by our own country. built up the dynamic math model of the heater, radiator, thimble reheat, single turbine. and then applied the acsl language to compiled the corresponding simulation program, analyzed the steady state parameter

    本文的主要工作和結論如下：在我國自行研製的10kw空間熱動力電源系統設計方案的幾何參數和熱力學參數的基礎上，建立了包括吸熱器、輻射器、管式回熱器、單級壓氣機在內的系統動態數學模型，並應用acsl語言編制了相應的模擬程序。
  8. With the operation conditions, the adsorber, the evaporator, the condenser, the receiver and the throttle are disigned. the adsorber is of the most importance in the adsorption system, so we provide the non - dynamic equilibrium model of active carbon fibre ( acf ) - methanol adsorption refrigeration pair. the numerical simulation is carried out based on the recorded solar radiation data measured in nanjing and daily ambient temperature for the typical clear days. the temperature field, the pressure field, the methanol concentration and the temperature of evacuted tube, and water tube are caculated

    吸附床是吸附製冷系統的核心，本文以活性炭纖維?甲醇為工質對，建立了吸附床非動態平衡吸附傳熱傳質數學模型，以南京夏季典型一天中的輻射強度和環境溫度為條件，模擬計算了吸附床在通水冷卻和自然冷卻兩種狀態下，吸附床內各點壓力、溫度、吸附率、吸附總量及真空管和冷卻水管壁溫隨時間變化關系。
  9. Radiation protection instrumentation - in vivo counters - classification, general requirements and test procedures for portable, transportable and installed equipment

    輻射防護測量儀表.體內計數管.便攜式可運輸和已安裝設備的分類一般要求和試驗過程
  10. In the thesis, i choose the horizontal and symbiotic industrial cluster basing on the natural resources as the objects to study, and make full use of knowledges from many subjects, including : economy, management, complex science, math, computing simulation, etc. through the idea of " down to up ", i make every individuality ( company ) inside the industrial clusters as a cell ; and choose techological support, labor supply, natural resourses reserve, maket overlay, intermediary service, public foundation, govenment policies as the outside influencing features ; and choose total assets, total production value, output ratio of capital as the indexes of system characters. then, i establish a computing simulation model on the optimal scale of industrial clusters basing on cellular automata model by matlab software, and simulate the shifts of characters of sigle cell according to the changing environments

    本文主要以基於自然資源稟賦的水平共生型產業集群為研究對象，綜合應用現代經濟學、管理學、復雜性科學、數學和計算機模擬方法等多學科的知識，吸納「自下而上」的思想，選取技術支撐、勞動力供給、自然資源、市場輻射、中介服務、公共基礎、政府政策七個變量作為集群成長的外部影響因素以及總資產、總產值和資金產出率作為集群的系統特徵指標，以產業集群（系統）內部的個體企業為單位元胞，參照自適應、自組織的自然演化機制模擬單位元胞自身特質受到周邊環境的變化而改變，採用元胞自動機模型和matlab軟體，建立一個基於元胞自動機模型的產業集群規模演化的計算機模擬模型。
分享友人
分享到 Line

分享到臉書