轉到結束點 的英文怎麼說

中文拼音 [zhuǎndàojiēshùdiǎn]
轉到結束點 英文
go to end
  • 轉 : 轉構詞成分。
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 轉到 : go to
  • 結束 : finish; closure; foreclosure; end; terminate; conclude; wind up; close; come to an end; come to a...
  1. In this paper, ackerman steering linkage of double - wishbone suspension is taken as the study object, choosing the splitting joint and steering lever joint to carry out the design of optimization the mathematics models are established based on the multi - body system dynamics, applying its analysis method of kinematics to study the mechanism kinetic principles owing to more spatial factors considered, and calling off many hypotheses affecting the accuracy, compared with the traditional methods, the models are better to reflect the realistic motion principles, the results are more exact and applicable moreover, the force analysis is applied to the conduct mechanism the analysis method of dynamics in the multi - body dynamics is applied to study the forces applied on every component, working out the constraint reaction force of up and down ball joints, and developing the current computation program in the end, produce the upper wishbone geometry model in the ansys software package, meshing and carrying out the fea, testifying if the intensity of the wishbone meet with the requirements

    本文以雙橫臂獨立懸架的轉向傳動機構作為研究對象，選擇對斷開點和節臂球銷的位置進行優化設計，在此基礎上建立了基於多體系統動力學的導向機構和轉向傳動機構的數學模型，運用該學科的運動學分析方法研究機構的運動規律，編制了通用優化設計軟體。由於考慮了更多的空間因素，取消許多影響準確性的假設，因此建立的數學模型與傳統的方法相比更能反映實際運動規律，得到的優化結果也更加精確實用。此外，本文還針對導向機構進行受力分析，在建立該機構的空間動力學模型后，運用多體動力學中的動力學分析方法研究各個桿件的受力，計算出上下球鉸的約束反力，並開發出了相應的通用計算程序。
  2. First, the nonlinear ls problem without constraint is converted to that subjected to inequality constraints by putting constraints on the do as of the received signals and toas of the first arrived signal with geometrically based single - bounce ( gbsb ) statistical channel model and cost - 207 model. then, a penalty function is used in the estimation of ms position

    首先，用基於幾何結構的單次反射圓模型和cost - 207模型，對期望定位用戶的各條多徑信號的波達方向和最先到達多徑信號的時間進行約束，將傳統的解無約束的非線性最小二乘定位問題或近似線性最小二乘定位問題轉化為解不等式約束的非線性最小二乘定位問題；然後，用內點罰函數法估計移動臺的位置。
  3. The time complexity is low because only shortest paths connected to relay nodes is compared. simulation results show that fairly good cost performance is achieved. there is trade - off between complexity and performance

    由於比較了通過中轉節點后的最短路徑，因此運算的復雜度大大降低，且通過模擬得到了較好的性能，模擬結果表明sp - dvma演算法是一種低復雜度的時延和時延差約束的多播路由演算法。
  4. When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved

    分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。
  5. On the day that extreme high price of a move is reached after a big advance, if option closes near the low of the day or closes below the halfway point of the day ' s range or closes below the opening, it indicates that the selling is better than the buying and that the option is getting ready to turn the trend down, at least temporarily

    在一輪大牛市結束到達極限高點價格的那天，如果當天開盤價接近收盤價，或者收盤價低於當天中價（應該是最高一最低的一半） ，或者收在開盤價下面，那麼預示賣者多於買者，至少行情準備轉勢了。
  6. An algorithm to resolve the coupling effect problem is proposed during the cross point assignment ( cpa ) stage. in the algorithm, the priority queue concept and the rip - up and reroute strategy are combined to control crosstalk noise caused by interconnect coupling capacitance. first, the nets are arranged into different priority queues according to their weighted sum of their length and criticality. then, the cpa problem for one queue of nets is translated into a linear assignment problem. after the assignment of one queue of nets, a post - cpa checking routine is performed to check and rip up the net pairs which violate the crosstalk noise constraint and then push them into the next queue to be reassigned. the algorithm is tested by a set of bench mark examples, and the experimental results are promising

    提出了一種在過點分配階段解決噪聲耦合效應問題的演算法.該演算法採用優先隊列同拆線重布策略相結合的方法，控制由互連線耦合電容引起的串擾噪聲.演算法中，首先按照線長和約束限制，將線網劃分到若干個優先隊列中.然後，將每個優先隊列的過點分配問題轉換為線性分配問題.在完成一個線網隊列的分配后，通過過點分配后處理過程檢查串擾約束滿足情況，對違反約束的線網對進行拆除，放入后續線網隊列進行重新分配.實驗數據表明，該演算法能夠取得好的效果
  7. Abstract : an algorithm to resolve the coupling effect problem is proposed during the cross point assignment ( cpa ) stage. in the algorithm, the priority queue concept and the rip - up and reroute strategy are combined to control crosstalk noise caused by interconnect coupling capacitance. first, the nets are arranged into different priority queues according to their weighted sum of their length and criticality. then, the cpa problem for one queue of nets is translated into a linear assignment problem. after the assignment of one queue of nets, a post - cpa checking routine is performed to check and rip up the net pairs which violate the crosstalk noise constraint and then push them into the next queue to be reassigned. the algorithm is tested by a set of bench mark examples, and the experimental results are promising

    文摘:提出了一種在過點分配階段解決噪聲耦合效應問題的演算法.該演算法採用優先隊列同拆線重布策略相結合的方法，控制由互連線耦合電容引起的串擾噪聲.演算法中，首先按照線長和約束限制，將線網劃分到若干個優先隊列中.然後，將每個優先隊列的過點分配問題轉換為線性分配問題.在完成一個線網隊列的分配后，通過過點分配后處理過程檢查串擾約束滿足情況，對違反約束的線網對進行拆除，放入后續線網隊列進行重新分配.實驗數據表明，該演算法能夠取得好的效果
  8. You may not transfer your domain name registration to another registrar during a pending administrative proceeding brought pursuant to paragraph 4 or for a period of fifteen business days as observed in the location of our principal place of business after such proceeding is concluded

    在依照章節4提起的未決行政訴訟期間或訴訟結束后的十五（ 15 ）個工作日期間（見我方主要辦公地點） ，你方不可以轉換你方的注冊域名到其他的注冊機構。
  9. This method connects the discrete points processed in the level set method to form a smooth curve, thus transforms the discrete problem to continuous one. constraint entry is added to the curve according to the actual demand, and satisfactory result is obtained in experiments. the results show that the algorithm is effective in the actual applications

    基於鏈碼的水平集方法把原先水平集方法中處理的離散點，利用鏈碼易於表示曲線的特點，連接成一條光滑的曲線，這樣就把離散問題轉化為連續問題，利用曲線的連續性和光滑性，根據實際問題的需要，對曲線加入外部約束項控制，在實驗中獲得了滿意的結果，在實際應用中達到了預期的效果。
  10. This paper studies the least redundant solutions of two - dimensional array system by using the simulated annealing algorithm. two ideal thinning solutions for the two - dimensional circle array were discussed intensively in this paper. one solution uses half - circle configuration with very much reduced number of elements and taking an image by rotating the array ; the other selects element positions around the full circle to provide a roughly uniform coverage in the spatial frequency domain

    在一維天線陣設計的基礎上，本文利用模擬退火演算法給出了兩種最小冗餘二維圓環天線陣的結構設計方案，一種方案利用天線旋轉，在半圓周內稀疏天線；另一種方案通過將空間頻率采樣點的均勻分佈作為優化的約束條件，在全圓周上使天線單元分佈達到最優。
  11. According to the structural feature of polarizing prisms, we transform the parameters related to the structure of prisms into geometric model, and use this model to solve the problem of the relation of different angles. along with fresnel formula and multiple - beam interference, we get the formula of light transmission

    根據棱一鏡的結構特點，將與棱鏡結構有關的各參量轉化為數學模型，利用此數學模型來解決各角度之間的關系問題，並結合菲涅耳公式和多光束干涉理論得到了棱鏡的光強透射比分析公式。
  12. Given the multicast request, the optimal object of the problem is to minimize total number of conversions required. in wavelength assignment, we should consider the requirements that the number of needed converters along the path from multicast source node to any member cannot be larger than specified value because of the signal distortion introduced by wavelength converters. at last, we present several dynamic programming to get the exact optimal wavelength assignment scheme under session blocking policy and destination blocking policy

    考慮到波長轉換器引入的信號失真和噪聲，引進了失真約束，即要求從組播源結點到每個組播成員的路徑上使用的波長轉換器數目均在指定的范圍之內;對于給定的組播需求，優化目標是在滿足失真約束的基礎上使整個組播樹上使用波長轉換器的數目最少;並使用動態規劃給出了sbp和dbp兩種連接建立策略下精確的最優波長分配演算法。
  13. A job that performs one of the following log shipping operations : backing up the transaction log of the primary database at the primary server the backup job, copying the transaction log file to a secondary server the copy job, or restoring the log backup to the secondary database on a secondary server the restore job

    恢復路徑是一組特定的轉換，使數據庫隨時間演化，但仍保持數據庫的一致性。恢復路徑描述的是從開始點（ lsn ， guid ）到結束點（ lsn ， guid ）的一組lsn 。恢復路徑中的一組lsn可以遍歷從開始到結束的一個或多個恢復分支。
分享友人
分享到 Line

分享到臉書