轉動特性 的英文怎麼說

中文拼音 [zhuǎndòngxìng]
轉動特性 英文
rotational characteristic
  • : 轉構詞成分。
  • : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • 轉動 : 轉動turn; run; twirl; roll; revolve; rotate
  • 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
  1. This paper mainly discusses about the acceleration response of the artillery that is caused by the plainness causes under traveling condition. and according to the system aspect of the matching between the tractor and artillery which composes the artillery train, it also presents the characteristics of the steering, braking stability and manipulating stability which affects the artillery moving maneuverability

    本文在火炮設計領域首次對火炮牽引列車系統進行力學分析,重點研究了火炮牽引行駛狀態下的路面不平度對火炮的加速度響應,並從牽引車與火炮匹配組成火炮列車的系統角度,研究了影響火炮行駛機、制穩定和操縱穩定
  2. This paper researches diathermancy and fluidity of condenser, evaporator, compressor, and capillary in detail. maths models of condenser, evaporator, compressor, and capillary are established and model predigesting and modifying methods are done methods are given in this paper, which can transfer the practical system into the simulating system. in the basis of refrigerating system character, components models are modified in the system administrative levels

    本文詳細研究了蒸發器、冷凝器、壓縮機和毛細管的傳熱和流,建立和發展了蒸發器、冷凝器、壓縮機和毛細管數學模型,並進行了相應的模型簡化和修正方法研究,建立了從實際系統到模擬系統的換方法;本文針對各製冷系統的點,在系統層次上進行了部件模型的修正研究,建立了相應的修正模型和演算法。
  3. Analysis of dynamic characteristics of the crack rotor

    裂紋子振的研究
  4. Methods of test for ancillary components for masonry - determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connection

    圬工輔助砌塊的試驗方法.剪切桿和滑桿的拉伸和壓縮負載容量和負載的測定
  5. The aerodynamic characteristics of a projectile with wrap around fins are studied systematically in this paper, as follows : 1. the lift coefficients 、 drag force coefficients 、 pitch moment coefficients 、 pitch damping moment derivatives and roll damping moment derivatives are obtained from engineering calculation through looking wrap around fins as flat fins of the same projection aera

    本文對某卷弧尾翼彈氣進行了系統研究,主要內容與結論為: 1 .將卷弧翼按照相同投影面積的平板翼進行工程估算,得到升力系數、阻力系數、俯仰力矩系數、俯仰阻尼導數、滾阻尼導數曲線。
  6. Variable diameter rotor is an effective method to improve the aerodynamic performance of tilt - rotor in both hover and cruise state. on the basis the research before, the variable diameter tilt rotor structure design has been finish, and in virtue of the technology of virtual prototyping to simulate and analyze the kinetic, dynamic and intensity property of it

    變直徑傾旋翼能有效的改善傾旋翼機懸停和巡航狀態下的氣效率,本文提出了變直徑傾旋翼試驗模型設計方案,完成了可變直徑傾旋翼的結構設計,並利用虛擬樣機技術對變直徑傾旋翼的運、結構力學以及結構強度進行了分析、研究。
  7. Steel wire ropes - determination of rotational properties

    鋼絲繩.轉動特性的測定
  8. The nonlinear electromagnetic force may cause the large oscillations of the rotor in some parameter regions. thus, the studies on the properties of the nonlinear dynamics and the stability for the rotor - ambs system play an important role in the engineering

    非線力的作用使子在某些參數域中產生相當大的振,因此分析該類系統的非線和穩定一直是電磁軸承-力學研究的重要課題。
  9. In this dissertation, according to the theory of mechanical dynamics and multi - body dynamics, a simulation model of nj2046 light off - road vehicle including suspension system, steering system and tires is built with the software carsim and so the vehicle steering characteristics are analyzed with the step angle input of steering wheel. it is found that the steering characteristics are different when the velocity and load are different, and the relationship between steering characteristics and velocity and load is presented

    本文根據機械繫統力學、多體力學理論,運用力學模擬軟體carsim建立了包括懸架系統、向系統和輪胎等模型的nj2046越野汽車整車模擬模型,在此基礎上分析了nj2046越野汽車在方向盤角階躍輸入時的,通過對不同車速、不同載荷條件下的模擬計算,得出了在這些條件下該車具有的不同表現徵,揭示了與車速、載荷和輪胎的內在關系。
  10. The following results are obtained : ( 1 ) the flow in rotating helical pipes are affected by dean number, curvature, torsion ( or germano number ), the ratio of the coriolis force to the centrifugal force f number ( or rossby number ) and the geometry of the cross section

    研究結果表明: ( 1 )旋螺旋管道流受dean數、曲率、撓率(或germano數) 、科氏力與離心力之比f數(或rossby數)以及截面的形狀五種因素的影響。
  11. When the front section length is equal to that of the back section, the torsional characteristic of the system is studied

    結合階梯形變幅桿兩段長度相等的情況,分析了系統的扭,得出了過渡段參數和階梯形變幅桿參數的關系圖像。
  12. The influence of the eccentricity mass moment, position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3. to verify the exactness of fem and learn the principle of vibration of dredge pump further, the orbit of the rotor shaft of the pump in the dredger is measured, the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition

    模態分析確定了泥泵的振(固有頻率和振型) ;諧響應分析確定了泥泵子軸在偏心力的作用下軸截面處的最大響應位移;研究了子軸的質心位置、軸承剛度和質量偏心矩對子軸振的影響; 3 、採用軸心軌跡法,實船測量了泥泵軸工作時振響應值。
  13. Strength and vibration analysis of a francis turbine

    混流式輪靜強度和振分析
  14. Study on modeling and turning performances for electric drive tracked vehicle propulsion system

    電傳履帶車輛驅系統建模與研究
  15. A semi - empirical tire model of transient cornering properties with carcass elasticity considered

    考慮胎體彈的輪胎半經驗模型
  16. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的點設計了頻率測量單元,根據pid調節各個環節的點,以及調速器、靜態對頻率測量的實時和精度要求的不同,利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路,實現了水輪發電機組頻率的測量;在軟體上,對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析,選用改進的pid演算法實現了變參數、變結構的pid調節模式;調速器的機械液壓隨系統具有步進電機電液換元件,採用五相反應式步進電機,根據其驅設計了變頻調壓驅器,實現plc與步進電機驅器之間數字介面。
  17. Analysis of the stick - slip vibration induced by rotating friction

    摩擦誘發粘滑振分析
  18. Vibration characteristics of a cracked rotor with initial deflection

    含初始彎曲裂紋子振
  19. Vibration characteristics of cracked rotor and crack identification

    裂紋子的振與裂紋參數識別
  20. Work peculiarities and movement characteristics of revolving water decanter were studied and hydraulics and kinematics calculation were given in this paper, which could be referenced when revolving water decanter was studied, operated and managed

    摘要對旋式潷水器的工作點和運進行了研究,給出了其水力學計算公式和運學計算公式,可供設計計算和運行管理旋式潷水器時參考。
分享友人