轉差調整器 的英文怎麼說

中文拼音 [zhuǎnchādiàozhěngqì]
轉差調整器 英文
slip regulator
  • 轉 : 轉構詞成分。
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中，首先介紹模數轉換器的各種參數的意義，以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案，引入級聯結構調制器，特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器，調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計，包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等，並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後，利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  2. In hardware designing, the feasibility to use a / d acquisition board, signal conditioning board and the relay output board which are more professional at present to construct the hardware of the computer control system was explored, the algorithm pid was used to advance the respond to error and stability of the whole system, through selecting proper a / d, d / a, di / do board cards, a special computer control system was constructed. in software designing, the language borland c + + was

    在硬體設計上，探索採用目前較為專業化的a / d轉換卡、信號調理板和繼電器輸出板構成計算機控制系統硬體結構的可行性，並採用pid控制以提高系統對誤差的響應和整個系統的穩定性，通過選用適當的a / d 、 d / a 、 di / do等板卡，構成一個很有特色的計算機控制系統。
  3. Fpga and dvb standard are introduced firstly, dvb - c standard and composition of its system are analyzed completely, development of modulator structure and dvb - c digital modulator composition are presented, more over, analysis of respective modular are given. then, principle of dvb - c digital modulator system are presented, they are error control technique 、 mqam 、 nyquist rule and root raised cosine filter 、 window design method for fir filter 、 multi - rate signal processing ( integer interpolating, conversion of fractional sampling, equal conversion of net structure, polyphase structure for filter, poly - phase structure for interpolator, multi - stage implementation of samplying conversion ) 、 distrubited algorithm 、 cic filter 、 dds 、 cordic algorithm

    接著，專門利用一個章節闡述了dvb - c前端調制系統原理，他們了差錯控制技術、多進制調制（ mqam ） 、 nyquist準則與平方根升餘弦濾波器、有限沖擊響應濾波器的窗函數設計法、多抽樣率信號處理包括（整數倍內插原理、分數倍抽樣率轉換、網路結構的等效結構、濾波器的多相表示、內插器的多相表示、抽樣率轉換的多級實現） 、分散式演算法、 cic濾波器、直接數字頻率合成（ dds ） 、 cordic演算法。
  4. The main function of a governor is to monitor the speed deviation of a hydro turbine unit and convert it into the displacement deviation of the servomotor according to a specific characterisic. it is used to control the opening of the guide apparatus and to ensure the unit run steadily at fixed speed under a given load

    調速器的主要功用是檢測機組轉速偏差，並將它按一定特性轉換成接力器的行程偏差，藉以調整機組導水結構的開度，使機組在給定的負荷下以給定的轉速穩定運行。
  5. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換器的新型晶元aduc824 ，實現了電流（電壓）采樣?數據處理?電流控制的閉環控制結構；地電位的抬升解決了a / d轉換器對負高壓迴路電流采樣時的輸入范圍匹配問題；控制信號反相的同時進行幅度壓縮，使得輸出調整電壓的解析度提高；根據常規的比例?積分?微分（ pid ）調節模型，針對陀螺系統的特性，給出了一種可以滿足系統要求、據采樣值偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法；不同條件下系統穩流性能的對比、分析在論文最後給出，並據此找出了決定該系統穩流精度的關鍵因素，提出了系統的改進意見。
  6. The real - time automatic gain control makes full use of the delay feature of signal channel, and controls the synchronization of adc precisely, and adjusts the signal gain in real - time, and compensates the error in digital domain, at last, this kind of technology expands the dynamic range of system adc

    採用的實時自動增益控制電路利用信號通路的延遲特性，精確控制模數轉換器同步，實時調整信號增益，在數字域補償誤差，擴展系統動態范圍。
  7. Convert fuzzy rules into algebraic expression to solve the deficiency of the two former, which cannot adjust control rules online. by putting emphasis on error - in - slip, look - up table of weight values on error - in - slip is established to adjust real - time control rules and simulated to regulate braking pressure

    針對前面兩種模糊控制器無法實時調節控制規則的缺陷，將模糊規則轉化為解析式的描述，並以滑移率誤差為著眼點，通過建立滑移率誤差權值查詢表，實時調整控制規則，達到調整制動壓力的目的，並對演算法進行了模擬。
分享友人
分享到 Line

分享到臉書