轉矩相加器 的英文怎麼說

中文拼音 [zhuǎnjǔxiāngjiāqì]
轉矩相加器 英文
torque summing member
  • 轉 : 轉構詞成分。
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 相加 : addition; adding; add together
  1. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換，建立了系統較精確的數學模型，編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究，實驗和模擬結果進行比較，說明實驗和理論較為一致，並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上，對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究，由於減少了低次諧波，改善了系統性能。
  2. From single - phase power supply, the shocks have driven two of the permanent cigang rotor rotary rotary magnetic field, and reducer with calculated design to export different rotational speed and moment, with the corresponding reduction in rotational speed increase moment

    由單相電源供電，振蕩產生兩相旋轉磁場驅動永久磁鋼轉子旋轉，與減速器配合，根據計算設計可以輸出不同的轉速和力矩，隨著轉速減少的相應的力矩增加。
  3. The paper research a predominant variable torque clutch ? hyperboloid clutch with rollers. the clutch makes convert mutually between force and torque reality to control transmission with special geometry relation and friction transmission. it is satisfy with the request of modern industry

    本文所研究的是一種性能優越的可變扭矩加載器?雙曲面滾柱加載器，利用加載器接觸表面特殊幾何關系，通過接觸表面的摩擦傳動，實現軸向力與轉矩之間的相互轉換，從而達到控制制動和傳遞動力的目的，可滿足現代工業對加載裝置的要求。
  4. The contributions done are as follows : according to the mathematical model of doubly fed motor and the theory of vector control, a unit power factor of rotor control scheme is proposed. in the doubly fed adjustment system, in order to control magnetic torque of motor this scheme is designed by controlling the reverse direction between rotor voltage and current to keep the vertical direction between rotor current and flux. it is known from theoretical analysis that for partly decoupling this scheme is only effective under sub - synchronization speed, but not control the system and obtain steady state since speed adjustment system ca n ' t adjust the magnitude of rotor flux under sup - synchronization

    而傳統的無速度傳感器雙饋調速矢量控制系統，由於採用磁鏈定向方法，在同步速附近存在較大的工作死區，針對上述問題，本文做了如下的研究工作：本文從雙饋電機的數學模型出發，根據矢量控制的基本原理，提出了一種轉子側功率因數為1的雙饋電機矢量控制方案的設想，即在雙饋調速時採用轉子電流定向的方法，並控制外加轉子電壓與轉子電流始終反相，以保持了轉子電流與轉子磁鏈矢量垂直，通過控制轉子電流的大小來達到控制電機電磁轉矩的要求。
  5. This product acquires engine crank corresponding phase signal and rotating speed signal, which after ecu treatment, are used together with signals collected from other load sensor ( such as shutter location sensor ) to achieve electronic control over engine ignition timing. compared with mechanical ignition timing control, this is more precise and reliable, resulting in optimized performance of engine in oil consumption, exhaust, output and torque

    Fdw465b型電噴分電器總成採集發動機曲軸相位信號及轉速信號，同其它負荷傳感器（如節氣門傳感器等）採集到的信號，經電控單元ecu計算處理后，實現對發動機點火正時的電子控制，較之機械式點火正時控制更加精確、可靠，使汽車發動機系統的綜合性能得到較大提高，特別是發動機的燃油消耗率、排放、輸出功率、扭矩等方面都得到較大優化。
  6. Simulations and experiment results show that this system is provided with high speed and satisfactory precision besides getting rid of both torque and speed sensors. therefore it is particularly fit for those occasions for which torque and speed sensors are difficult to amount

    模擬和試驗結果表明，本系統不僅有較快的測試速度，而且具有相當的精度，再加上其無需轉矩轉速傳感器的優點，特別適用於一些不適合安裝轉矩轉速等非電量傳感器和需要進行快速測試的場合。
  7. Secondly, the dynamic features, surplus torque and loading gradient features of ptss are analyzed by the couple model between the rudder and the eals. it can be concluded that the surplus torque is related directly to the velocity of the rudder, and the loading gradient is the disturbing inverse ratio from the surplus torque to the closed - loop model, which shows the scaling relationship between the input and the disturbance signal act on the eals. it also can be concluded that, under the same dynamic specification, it is more difficult to realize the small loading gradient

    然後，採取把系統模型轉化為舵機和負載模擬器相互耦合作用的形式，對被動式力矩伺服系統動態特性、多餘力矩和加載梯度一一進行理論分析，得出:多餘力矩與舵機運動速度直接相關;加載梯度是在系統閉環模型中，與多餘力矩相關部分模型幅值大小成反比的系數，體現了被動式力矩伺服系統的指令信號和擾動信號之間的比值關系，從而在相同的動態指標下，小加載梯度實現更為困難。
分享友人
分享到 Line

分享到臉書