退化變值 的英文怎麼說

中文拼音 [tuìhuàbiànzhí]
退化變值 英文
regressive metamorphism
  • 退 : 動詞1 (向後移動) retreat; draw back; move back 2 (使向後移動) cause to move back; remove; wit...
  • 退化 : become vestigial; degenerate; deteriorate; retrograde; devolution; retrogradation; retrogression;...
  1. In unfed adults, the acini were small ( 34. 79um ) and their surface had many folds. on the d2 after attachment, the gland and its acini increased sharply and reached its peak ( 97. slum ), which was about 2. 8 times of unfed female. during this period, the surface of acini was relatively smooth

    饑餓雌蟲唾液腺腺泡小( 34 . 79 m ) ,表面有人量的突起和凹陷;吸血后2d腺體和腺泡明顯增大:交配期腺泡達到最大( 97 . 81 m ) ,約為饑餓期的2 . 8倍,腺泡表面明顯得光滑;飽血后腺泡逐漸萎縮,發生自溶現象,飽血后4d唾液腺明顯退
  2. On this basis, adopt the plural linear regression method, regard peasant ' s per capita income as the dependent variable, per capita agricultural land area, unit agricultural land area chemical fertilizer use amount, agriculture total value account for gdp proportion and land degradation the index data ( land degradation fictitious variable, land degradation percentage and land degradation the array variable of the degree ) as the independent variable

    在此基礎上,採用多元線性回歸方法,以農民人均收入為因量,人均農業用地面積、單位農業用地面積肥使用量、第一產業總佔gdp比例和土地退指標(土地退與否的虛擬量、土地退百分比和土地退程度的序列量)為自量來分析。
  3. The results indicate that these parameters in profile change closely with geotectonic cycles as follows : sulfur, colloid and asphaltene contents keep the lowest values in devonian, triassic, jurassic and tertiary ; they are in accordance with regressive geotectonic phases, of which the maximum values appear to be correspond to the largest - scale marine transgressions occurred in caledonian cycle, hercynian cycle and middle phase of alpine cycle

    指出,這些石油參數在剖面上的與大地構造旋迴有密切關系:硫,膠質和瀝青質的含量在泥盆紀、三疊紀、侏羅紀和新近紀為最低,它們與海退構造階段相一致;石油學成分最大與加里東旋迴、海西旋迴和阿爾卑斯旋迴中期的最大海侵相一致。
  4. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改引起的負結深的對深亞微米槽柵pmosfet性能的影響進行了分析,對所得結果從器件內部物理機制上進行了討論,最後與由漏源結深導致的負結深的改對器件特性的影響進行了對比.研究結果表明隨著負結深(凹槽深度)的增大,槽柵器件的閾電壓升高,亞閾斜率退,漏極驅動能力減弱,器件短溝道效應的抑制更為有效,抗熱載流子性能的提高較大,且器件的漏極驅動能力的退要比改結深小.因此,改槽深加大負結深更有利於器件性能的提高
  5. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中,氯釕濃度、溶液ph、陳時間、溶液溫度對電鍍效果均有影響,其中溶液ph是最主要的影響因素;在儀器的使用條件探索中,理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍,並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧物的共沉澱是目前研究熱點,在此選用與釕同一族的銥作為共沉澱元素,銥的加入會阻礙氧物的沉積速度,銥的比例超過50 %會使沉積作用停止,但是二元氧物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕物轉成混合價態的氧釕,從而提高活性物質的穩定性。
  6. Based on the insurance actuarial theory and the classic financial engineering theory, the paper analyses the value of life insurance policies with embedded surrender option, and finds out that whether the surrender option is exercised is related to several factors in a certain policy, in which the relation varies with the change of factors ' value

    摘要利用保險精算和金融工程理論對含有退保期權的壽險保單價進行了分解,發現退保期權的行使與否和某一特定保單的若干參數相關,這種關系隨著保單參數
  7. Comparing of the ratio of 550nm emission intensity to 525nm in samples annealed at different temperature and times, the results obtained from a fit of the integrated intensity for these two emission indicated the change of radiative transition probability at different energy level are different

    通過比較不同退火溫度和時間樣品的兩者發光的不同,發現兩者的激發機理不同。通過比較不同樣品的525nm和550nm發射強度比退火條件的以及這兩個發光的積分強度的溫擬合結果說明退火對不同能級的輻射躍遷幾率的影響不同。
  8. The development and decline of subsurface flow in soil changing slope due to rainfall infiltration were studied with numerical analysis

    摘要用數解析研討了降雨滲透坡面的地下水流的進展和衰退過程。
  9. In numerical calculations, the effects of rainfall pattern, shape of slope layer and changing slope to the development and decline of subsurface flow were examined

    計算驗算了降雨的方式,斜坡地層的形狀以及坡度的對地下水位進展和衰退過程的影響。
  10. Now if we suppose that the rated temperature limit of any chip were identical, confining the highest temperature in the rated limit is the most important, for this purpose i apply the principle of annealing algorithm to the optimization of place distribution design. under the unvaried condition of thermal dispersion, we can get the least temperature of the maximum value in some kind of chip array

    為了使得電子元件最大溫度負荷在特定散熱狀態下達到最低(低於額定的最高溫度) ,我們將模擬退火演算法的優設計思想應用到電子元件陣列的布局優中,使得在不改外部散熱條件的情況下,僅僅通過電子元件位置分佈的改就取得降低其最高工作溫度的效果。
  11. Secondly, by low - cycle and reverse horizontal loading test, their properties including strength property, deformation property and energy property are studied. we study the loading characteristic values ; the property of hysteretic curve and skeleton - frame curves ; the ductility property and stiffness degradation. at last we analyze the destroy principle and affection reasons of hollow shear wall of r. c with vertical seams in different height and loading measures, we also give the bearing capability calculation formulas and design advises for new type hollow shear wall of r. c

    首先運用ansys有限元程序分析彈性階段水平外荷載施加后,帶豎縫鋼筋砼空心剪力墻板內應力分佈及形情況,再在試驗數據的基礎上,研究低周反復水平加載條件下,各試件的強度、形、能量特性;各試件的荷載特徵;各試件的滯回曲線、骨架曲線;延性及剛度退等參數;最後,分析了不同剪跨比和加載條件的帶豎縫鋼筋砼空心剪力墻板的破壞機理和承載力影響因素,並給出不同剪跨比和加載條件的帶豎縫鋼筋砼空心剪力墻板承載力計算公式及設計建議。
  12. With the decoupling average technique and high - temperature approximation, we obtain the graph of the system magnetization evolving, which clearly exhibit the critical slowing phenomena of xy model near the phase transition region

    運用退耦平均技術,在高溫近似下數模擬得出的平均磁強度的時間演,清楚地展示了xy模型在相發生區域內的臨界慢現象。
  13. The sandwiched films with the structure of 2. 5um / 2um / 2um and 2u m / 2um / 2 u m have been prepared by covered - module method. gmi effect will be studied in deposited and annealed samples with variation of magnetic field, driving frequency and current

    用掩膜法制備了每層厚度為2 m和2 . 6 m的三明治膜,將研究退火前後樣品的gmi效應,包括隨磁場、驅動頻率、交流幅
  14. In succession, tini thin film is deposited on single - crystal silicon substrate using optimized parameters utilizing sputtering, and its transformation temperature ( a * ) is 72 ? indicated by dsc curve after being annealed in an ultra - high vacuum ( uhv ) chamber. in addition, the composition of the silicon - based tini film was analyzed by an energy dispersive x - ray spectroscopy ( eds ), and the ti content in the film is approximately 51at %

    按照改進的工藝參數,在單晶硅襯底上濺射-淀積了tini薄膜,並進行了超高真空退火, dsc法測得其馬氏體逆相溫度為72 ,利用能譜分析( eds )技術測得其ti含量約為51at ,通過對非晶tini薄膜與單晶硅襯底之間的界面進行eds及x射線衍射( xrd )分析,發現在用大功率( 2000w )直流磁控濺射法制備tini薄膜過程中,存在ti 、 ni與si的雙向擴散,發生了界面反應,並有三元合物ni _ 3ti _ 2si生成。
  15. In this paper, a aero - engine performance tracking filter is designed by kalman filter algorithm. the filter estimate the ecdp ( engine component deviation parameters ) which reflect the deterioration of engine and the variation between engines. the estimate parameters are used to tune the embedded model to make the model consistent with the engine which respect

    本文利用卡爾曼濾波原理設計了發動機性能跟蹤濾波器,對反映發動機性能退和不同發動機之間性能差異的部件性能偏離參數( ecdp , enginecomponentdeviationparameters )進行估計,用估計修正機載模型,通過修正後的模型計算發動機性能參數的
  16. We divide document image into two parts - text and background. text area is regarded as a series of random variables with 0 - 1 distribution and background area as a series of random variables with degenerate distribution. because the median filter is robust for degenerate distribution, it can reduce the noise

    文本圖像通常可以轉換成二圖像,我們可以把文本圖像的文字區域和空白區域分別理解為兩個相互獨立的隨機量序列的依次觀測,其中一個是服從兩點分佈,而另一個服從退的單點分佈。
分享友人