送氣裝置 的英文怎麼說

中文拼音 [sòngqìzhuāngzhì]
送氣裝置 英文
air supply plant
  • 送 : 動詞1 （運送; 傳送） deliver; carry 2 （贈送） give as a present; give 3 （伴送; 送別） see sb of...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. The pulse pneumatic conveying system has been a important transporting method for grain material, because of lower velocity, higher ratio of blend and a littler gas, as well as shattering less materiel, abrasing pipeline and easy recovery

    脈沖氣力輸送裝置以其低速、高混合比、低耗氣量等一系列持點，並由此帶來的被輸送物料破碎少、管道磨損小、產生粉塵少並且易於回收等優點，成為新一代粉粒料氣力輸送設備，並且被廣泛使用。
  2. General speaking, if it is the drying of the electuary and granular materials, which have relative large proportion, only the cyclone separator is needed

    一般來說，比重較大的物料只需選擇旋風分離器。比重較輕的物料需配套布袋除塵器，並備有氣力送料裝置供選擇。
  3. A heating unit in the basement of a house burns gas to heat air or water, which is then forced through the house or building to raise it ' s temperature

    居於樓房地下室的一個供熱裝置通過燃燒氣體釋放熱量來給水和空氣加熱，加熱的水或空氣則靠壓力運送到樓房或大樓來提高它的溫度。
  4. The machine adopts mechanical transmission in cutting pressing and transferring the paper and is provided with pneumatic cushions and photoelectric safety feature in the middle of the front machine body is installed adisplaying scale, which conveniences the operator for surveying

    本切紙機送紙均採用機械傳動，並有氣墊及光電安全裝置，標尺顯示和顯示均在前機架正中，使操作者觀察方便。
  5. A rocketpowered device telemeters heating data obtained on flights through the atmosphere.

    一種以火箭推動的裝置將其在大氣中飛行時熱度增加的資料以遠距離記錄儀傳送回來。
  6. On the base of the analysis on the advanced technology of hard ferrite in foreign country, the main procedures of preparing hard ferrite pre - sintering material are determined as follows : first, the ferrite oxides coming from the main cold rolling line and strontium carbonate are conveyed to storage tank by gas power and weighed automatically according to the demands of constituent composition. and then they are mixed and grinded by using method of wet treatment. finally the mixtures is transported to the devices of storage by transporting pump

    在分析國外先進的永磁鐵氧體生產工藝的基礎上，確定了生產高檔永磁鐵氧體預燒料的主要過程：首先，利用攀鋼冷軋鐵紅為主要原料，將氧化鐵紅及碳酸鍶採用氣力輸送至貯料料倉，經自動稱量裝置，按工藝配方稱量後分別由氧化鐵紅及碳酸鍶發送罐氣力輸送進入預混攪拌筒加水攪拌，然後再送入混磨機濕法混磨；最後，混合物經輸送泵輸送至料漿存儲裝置，經定量進料泵定量輸送至回轉窯進行濕法預燒，預燒料經緩冷至室溫后，再球磨。
  7. Ventilation for buildings - air handling units - ratings and performance for units, components and sections

    建築物的通風.空氣排送設備.裝置部件和型材的額定值和性能
  8. Special tool motivated by gas, liquid or pipeline conveyance medium to cleanup the pipeline, which can carryover the electronic launcher instrument and the ground tracking device

    由氣體、液體或管道輸送介質推動，用以清理管道的專用工具。它可以攜帶電子發射裝置與地面跟蹤儀器。
  9. Coal. sampling of pulverized coal conveyed by gases in direct fired coal systems

    煤.直接燃煤裝置氣體傳送的霧化煤的取樣
  10. Components for containment enclosures - transfer systems such as plain doors, airlock chambers, double door transfer systems, leaktight connections for waste drums

    密封箱室部件.第3部分:轉運裝置如簡易門氣閘室雙開門用傳送系統和廢物桶密封連接件
  11. In the new dryer, the air guiding device with an orderly increased air guiding radius was introduced to improve the uniformity of airflow distributed in bed ; a three - blade device was installed to get a good pulse - fluidizing effect ; an vibrating device and a conducting device were additionally set up to make materials flow fluent and to overcome " reverse flow " respectively

    它採用導流半徑依次增大的導流裝置，改善了氣流在床層內分配的均勻性；採用三葉片式脈動裝置，改善了脈動效果；增設了振動裝置，使物料輸送流暢；增設了導料裝置，從根本上解決了物料的「反流」問題。
  12. Degassed furnace, sealing furnace, stabilizing oven, mask annealing lehr, blackening furnace, bulb roaster, primary annealing lehr for colour tube funnel, secondary annealing lehr for colour tube funnel, annealing lehr of single - press, annealing lehr of double - press, funnel annealing lehr, colour tube panel annealing lehr, tube - neck sealing and annealing lehr, cut - off machine, necking machine, funnel - loader, lehr preheating unit, neck - loader, funnel auto - pickup, auto - pickup conveyor, funnel auto - loader, neck seal loader, neck - delivery conveyor, rough grinder, fine grinder, fine - polish grinder, panel pickup, button sealing machine, pin sealing machine, funnel annealer loader

    彩管、彩玻設備系列：排氣爐、封接爐、穩定爐、蔭罩退火爐、黑化爐、焙燒爐、彩色玻錐一次退火爐、彩色玻錐二次退火爐、雙壓機退火爐、單壓機退火爐、彩色玻屏退火爐、管頸封接退火爐、割頭機、接頸機、錐裝載裝置、退火爐預熱裝置、管頸裝載機、屏自動取出裝置、自動取出傳送帶、錐自動裝載機、管頸封接裝載機、管頸供給傳送帶、粗研磨機、細研磨機、精拋光研磨機、取屏機、陽極帽封接機、銷釘封接機、錐退火爐裝載機。
  13. Design of new pneumatic conveying system for filter rod

    新型濾棒氣力輸送裝置的設計
  14. Abstract : the paper introduces briefly the retrofit of the cleaning equipment and the operating results of the cylinder type bag filter in the fluidization systems for the copper smelting flash furnace

    文摘:簡要概述了閃速爐氣力輸送系統收塵裝置的改造和圓筒型布袋收塵裝置在氣力輸送系統中使用的效果。
  15. Technical reformation actuality of home - made shuttle loom is analysed in this paper with their application study result of shedding, weft inserting, beat - up, let - off and, warp stop motion as well as electronic driving unit and developing trend introduced

    摘要分析了有梭織機技術改造的現狀，列出了開口、引緯、打緯、送經、停經、電氣驅動裝置的應用研究及應用成果，闡述了有梭織機技術改造的發展方向。
  16. Solid particle erosion is an important reason of material failure in a number of engineering systems such as material transport pipe lines, coal liguefaction / gasificaion plants, thermal power plants, aircraft gas turbine engines

    固體粒子沖蝕磨損在一些工程應用中是導致材料失效的重要原因，如物料輸送管道、煤液化氣化裝置、熱能裝置、航空器噴氣引擎、等。
  17. The heimeier gunmetal lockshields, regulux and regutec, are now also available with press connections for 15 mm piping. and in order to ensure that the safety factor figures prominently in the equation, the press connection is equipped with the viega

    當然， c型標準溫控閥也適用於所有型號的heimeier emo系列執行器，由於具有反向功能，可以用在風機盤管裝置送氣裝置和天花板輻射製冷裝置中。
  18. Manufacturer of connectors, snap - action switches, contactors, control devices and power supply equipment for traffic technology and industrial applications

    -生產用於製造送線機飲水機醫療電動床健身器等電氣裝置的馬達產品。
  19. The machinery house air is pressurized and fil - tered by two fan units, one of which is thermostatically con - trolled

    機房空氣為正壓，並有兩層風扇送風裝置進行空氣過濾，其中一個具有恆溫控制。
  20. Signalling on low - voltage electrical installations in the frequency range 3 khz to 148, 5 khz - part 2 : low voltage decoupling filters - safety requirements

    頻率范圍3khz到148 . 5khz的低壓電氣裝置的信號傳送.第2部分:低壓去耦濾波器.安全性要求
分享友人
分享到 Line

分享到臉書