透鏡組 的英文怎麼說

中文拼音 [tòujìng]
透鏡組 英文
battery of lens
  • : Ⅰ動詞1 (滲透; 穿透) penetrate; pass [seep] through 2 (暗地裡告訴) tell secretly; let out; lea...
  • : Ⅰ名詞1 (鏡子) looking glass; mirror 2 (幫助視力或做光學實驗的器具) lens; glass 3 (姓氏) a s...
  • : Ⅰ名詞1 (由不多的人員組成的單位) group 2 (姓氏) a surname Ⅱ動詞(組織) organize; form Ⅲ量詞(...
  • 透鏡 : [物理學] lens; optical lens
  1. This setup, known as a conoscope, is shown in figure 14. 2 and consists of two stress - free plano - convex lenses a and b

    此裝置稱為錐光,如圖14 2所示,它由a和b兩個無應力平凸透鏡組成。
  2. This setup, known as a conoscope, is shown in figure 14. 2 and consists of two stress - free plane - convex lenses a and b and a diaphragm c having a small aperture

    此裝置稱為錐光,如圖14 2所示,它由a和b兩個無應力平凸和一個帶小孔的光闌c成。
  3. Using numerical - approaching method to study the potential of assembled electron lens

    用數值逼近方法研究合電子的電勢
  4. I copied a reproduction of the silverpoint using a homemade epidiascope based on a small circular concave mirror and direct solar illumination, and when i deliberately “ bumped ” my own epidiascope, i found such a mismatch to be very conspicuous

    我用小型的圓凹與陽光成的自製幻燈機,從銀尖筆畫復制了一張畫,而當我蓄意碰撞自己的設備后,我發現位移結果是非常醒目的。
  5. In the ostra field, venezuela, oil is produced from lenticular sandstone beds of the oligocene oficina formation.

    委內瑞拉奧斯特拉油田的產油層,為漸新世奧菲西那狀砂巖層。
  6. This setup, known as a conoscope, is shown in figure 14. 2 and consists of two stress-free plano-convex lenses a and b.

    此裝置稱為錐光,如圖142所示,它由A和B兩個無應力平凸透鏡組成。
  7. The temperature gauge consists of high performance single chip microcomputer, excellent optical lens.

    該測溫儀由高性能的單片機優異的光學以及高質量的電子元器件成。
  8. Lode country assume silllike - similar silllike, and the next big anastigmatic, ground and west branch river set strench are consistent. it suffer the gravel silica rock, arena silica control. a handful of lode country or main lode country byway little orebody assume vein, or have the characteristic of balk reappear, compound of branch. these manifest the obvious characteristic of ore construct control

    礦體以層?似層狀產出為主,其次為大的狀,地表延伸與西岔河地層一致。受礫屑硅質巖、含礫砂屑硅質巖控制。少數礦體或主礦體旁側小礦體呈脈狀、或具尖滅再現、分支復合特徵。
  9. This setup, known as a conoscope, is shown in figure 14. 2 and consists of two stress-free plane-convex lenses a and b and a diaphragm c having a small aperture.

    此裝置稱為錐光,如圖142所示,它由A和B兩個無應力平凸和一個帶小孔的光闌C成。
  10. Meanwhile, in north america, the earthscope project is establishing a continent - wide network of gps locators, seismographs, and other instruments to study what ' s happening below the crust

    與此同時,在北美開展的「地球」計劃正在建立一個包括全球定位系統定位儀、地震儀和其他儀器所成的洲際范圍的網路,以研究地殼下面的活動情況。
  11. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光器的發展狀況、主要特性及其應用,從四能級速率方程出發,推導了ld泵浦nd : yag激光器的閾值、輸出功率和斜效率的表達式,並簡述了激光器的工作原理、結構型式和倍頻方法;其次,以空間相關的速率方程為基礎,提出了ld端面泵浦nd : yag激光器的設計方法,給出了一定泵浦耦合方式下,振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據,以此為依據,設計了自聚焦耦合小功率ld泵浦nd : yag激光器和透鏡組耦合高功率ld泵浦nd : yag激光器,對激光器的輸出功率和功率穩定性等特性進行了實驗研究;再次,在帶尾纖輸出的高功率ld泵浦nd : yag激光腔內插入一隻空液晶盒,觀察到了激光器以單縱模運轉;最後,根據泵浦光焦斑端面位置對激光輸出功率的影響規律,提出了ld端面泵浦nd : yag激光位移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時,激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律,測量范圍和靈敏度依賴于泵浦功率,隨著泵浦功率的增加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大輸出功率為1 . 926w )時,激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  12. A method of solving the initial structure of a three - thin - lens null corrector

    無光焦度3貼合薄透鏡組初始結構參數求解方法探討
  13. Optics and optical instruments - test lenses for calibration of focimeters - test lenses for focimeters used for measuring contact lenses

    光學和光學儀器.焦距計校正用檢驗頭.測量接觸透鏡組用焦距計用檢驗
  14. Optics and optical instruments - test lenses for calibration of focimeters - test lenses for focimeters used for measuring spectacle lenses

    光學和光學儀器.焦距計校正用檢驗頭.測量柔性焦距透鏡組用焦距計用檢驗
  15. Objectives which consist only of one lens can be used for visual and photographic observations.

    由單透鏡組成的物可作目視和照相觀測用。
  16. 3. because traditional coupling system composed with cylinder lens and focus lens has the disadvantages of difficult to encapsulation and modulate, a new practical method brings forward : the output light from laser diode is collimated using a section of optical fiber with the diameter of 600 m instead of cylinder lens, and a sphere ? end lens

    3 .針對由柱和聚焦透鏡組成的耦合系統中存在的封裝和調試困難等問題,提出了:用一段直徑為600 m的裸石英光纖代替柱,對半導體激光器輸出光束進行準直整形;用球光纖對準直后的光束進行聚焦,直接實現和光纖耦合,來代替聚焦和光纖耦合的環節。
  17. In this thesis, the basic operation in the optical computation was studied by analyzing the course of laser beams transmitting through a vmm, which is composed of an array of vertical cavity surface - emitting lasers, spherical and cylindrical lens, an array of multiple quantum well spatial light modulators and an array of the detectors

    本文研究的光學矢量-矩陣乘法器主要是由垂直腔面發射激光器( vcsel )陣列、球面和柱面透鏡組、多量子阱空間光調制器( mqwslm )及ccd陣列構成。作為小尺寸的集成光學器件,必須要考慮衍射的作用。
  18. A mirror, lens, or combination of lenses used to gather light and direct it upon an object or through a projection lens

    聚光器用於聚光並將光引向某物體或通過一凸透鏡組子、透鏡組
  19. The design of the laser and its bracket, neutral density filters, lens, and digital camera are complete in the hardware design ; the image collection and centroid calculation are complete in the software design ; and the experiment of straightness calibration is accomplished. the possible errors are analyzed about the whole system, and some methods to decrease the errors are put forward

    硬體部分主要完成了激光器及其支架、衰減片透鏡組和數字相機的結構設計;軟體部分主要完成了圖像的採集和質心的求取;最後進行了直線性校準實驗,並對實驗過程進行了誤差分析,提出了減小誤差的方法。
  20. In film emulsion, an area exposed in some way other than directly through the lens, such as internal reflections between the various surfaces of the lens component

    在膠片感光乳劑中,不是直接經過的某種方法曝光的區域,例如透鏡組成部分各表面間的內部反射。
分享友人