通道孔隙度 的英文怎麼說

中文拼音 [tōngdàokǒngxìdù]
通道孔隙度 英文
channel porosity
  • 通 : 通量詞（用於動作）
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 通道 : thoroughfare; passageway; pass; enterclose; gallery; drong; tunnel; avenue; alure; way; row; key ...
  • 孔隙度 : amount of porosity
  1. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  2. The cross-sectional areas of the pore openings vary along their length.

    孔隙通道的橫截面面積沿其長度方向變化。
  3. Observation of drilling cores and casting - sections and the characters of pore structures and permeability of the matrix of the lower - ordovician carbonate in comparing with the lower limit of a reservoir for matrix reveal that the porosity, permeability, maximum pore diameter, saturation and median throat diameter in the matrix with undeveloped fissures, holes and solution pores are far lower than those of a reservoir limit although some micro - pores are developed in the matrix which therefore has no capacity of storing and producing oil - gas

    摘要通過鉆井巖心和鑄體薄片觀察，根據下奧陶統灰巖基質的孔滲特徵和孔隙結構特徵，並與基質作為儲層的下限對照裂隙、洞穴和溶蝕孔洞不發育的灰巖基質，發現盡管有微孔隙的發育，但其孔隙度、滲透率、最大孔喉半徑、飽和度、中值喉道半徑等參數值遠低於儲層下限值，基本不具備儲集和生產油氣的意義。
  4. The analyses of the microstructures as well as the characterizations of microcracks, deposition defects and residual pores of 3d c / sic composites have been done to determine the main diffusion channels of oxygen into the composites at different temperature domains. 2

    對3dc sic復合材料的顯微結構進行了表徵，對材料中的各種微裂紋、缺陷和孔隙進行了分析，研究了不同溫度區間內氧化性氣體在復合材料中的主要氣相擴散通道。
分享友人
分享到 Line

分享到臉書