通道摩擦系數 的英文怎麼說

中文拼音 [tōngdàomócāxìshǔ]
通道摩擦系數 英文
coefficient of padrssage friction
  • 通 : 通量詞（用於動作）
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 通道 : thoroughfare; passageway; pass; enterclose; gallery; drong; tunnel; avenue; alure; way; row; key ...
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  2. Using vogel ' s wear index as the rail side wear index, the paper analyzes the side wear variations of rail head when the parameters in the wheel / rail system vary, analyzes the influences of track irregularity on rail uneven wear on gauge corner emphatically. this paper analyzes the rail side wear dates measured by track division of shan hai guan since 1990, then gains the relationship between side wear and traffic volume and sums up the characteristics and regularities in the formation and development of side wear. in the end, some measures for regarding the side wear on curves are put forward

    從輪軌摩擦、輪軌接觸幾何關系、輪軌接觸應力和輪軌蠕滑等方面對鋼軌側面磨耗機理進行了探討，從軌道幾何參數、機車車輛運營條件等方面對鋼軌側面磨耗的影響因素進行了重點分析和總結；應用輪軌系統動力學，建立了輪軌空間耦合振動時變模型，採用vogel側磨指數作為鋼軌側磨指標，系統分析了輪軌參數變化的情況下，軌頭側面磨耗的變化規律，重點分析了軌道不平順對鋼軌不均勻側磨的影響；對山海關工務段1990年以後現場測得的曲線鋼軌側磨數據進行了分析，通過擬合得到了鋼軌側磨量與運量的關系曲線，並總結了曲線上股鋼軌側面磨耗的特徵和發生、發展規律；最後提出了一些減緩曲線鋼軌側面磨耗的措施。
  3. Chapter two constructed the mathematical model of robot and its environment solved by the fem analysis. the functions or relations between the robotic parameters and its drive forces, thickness or its velocities were given, and also the functions or relations between the environment and the robot force, friction, robot velocity, minimum thickness of film or sustain force of dynamic films were given

    論文第二章通過建立機器人和環境的數學模型，利用有限元方法求解其中的n - s方程，得出管道中微型機器人的各種設計參數與機器人的驅動力、形成的最小潤滑油膜厚度和機器人的運行速度之間的關系曲線，研究了管道環境與機器人驅動力、摩擦阻力矩、機器人運行速度、形成的最小潤滑油膜厚度、油膜的承載能力之間的關系。
  4. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  5. According to the the regression analysis on the bloting and shotcreting roadways of henan pingmei group, the regression equation on the degree that absolute grade and area of roadway influence coefficient of frictional resistance is built in the paper. the notable character test of the regression equation is completed. at last, the degree that absolute grade and area of roadway influence coefficient of frictional resistance is discussed and summed up. the practical and guiding sense in choosing coefficient of frictional resistance of congeneric roadways is given in the paper

    通過對平煤集團大量的錨噴巷道的回歸分析，建立了巷道壁面絕對粗糙度和巷道斷面積對摩擦阻力系數影響程度的回歸方程，並對回歸方程作了顯著性檢驗，最後對巷道粗糙程度和斷面積對錨噴巷道摩擦阻力系數的影響程度進行了討論和總結，對同類巷道摩擦阻力系數的選取具有實踐指導意義。
  6. At first, the soft of bridge structure, gqjs, is used to calculate the structure of prestressed concrete continuous beam bridge and the deformation and stress of the concrete box beam are given out ; then by measuring and analyzing the datum of the stress in the prestressed steel rope and the stress of section in the concrete box beam, this article presents two ways to identify the reasonable friction deviation factor k between longitudinal prestressed tendons and the wall of duct ( indirectly and directly ), and discover the regular pattern of prestressed friction loss

    首先運用橋梁結構分析專用軟體gqjs對預應力混凝土連續梁橋進行結構計算，得到了各施工工況下混凝土箱梁的撓度和截面應力；然後給出了識別引起結構預應力損失的孔道偏差系數k的兩種方法（間接法和直接法） 。通過對測得的預應力索沿程應力和混凝土箱梁截面應力數據的分析處理，得到了合理的預應力孔道摩擦偏差系數及預應力摩阻損失規律。
分享友人
分享到 Line

分享到臉書