速制轉換開關 的英文怎麼說

中文拼音 [sùzhìzhuǎnhuànkāiguān]
速制轉換開關 英文
speed regime change-over switch
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 轉 : 轉構詞成分。
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 轉換 : change; transform; convert; switch
  1. Electric - controller is nubbin in developping. we are based on designing to structure of circuit, we are dead against in time and stabilization for controlling and communications, precision and rapidity for transformation etc. we have completed to select on microprocessor, clock - frequency and a / d transfer. it carry out transformation for valve position signal, and select on solid - switch ac

    在控制器的電路結構設計的基礎上，考慮到通訊、控制的及時、穩定、轉換的精度和速度等幾方面，主要完成對微處理器的選擇、時鐘頻率和a d轉換器的選用，閥位變送功能的實現，固態交流開關和顯示器的選擇等。
  2. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  3. The relays may lack the high speed switching characteristic of the solid - state state switches used by other preamplifiers, but they also have none semiconductor distortions and noise which accompany analog gates and voltage controlled amplifiers

    與其他前級放大器所用的半導體開關相比，這些繼電器缺少高速轉換的特性，但它們沒有隨著模擬開關和電壓控制放大器所帶來的半導體失真和噪聲。
  4. This thesis is about the torque ripple minimization of switched reluctance motors ( srm ) under the base speed. based on the instant torque control strategy, aiming to minimize the torque ripple of srm during commuting and to obtain excellent dynamic and steady state performances

    本文主要研究開關磁阻電動機（簡稱sr電機）在基速范圍以下轉矩脈動的抑制問題，研究時以瞬時轉矩控制為基礎，旨在減小換相期間sr電機的轉矩脈動。
  5. The load - control apparatus adopted a single - chip microcomputer system, whose mcu was a kind of high - speed processor - ds80c320, whose a / d switched apparatus was max180, whose low - pass filter was max293, whose f / v transformed circuit was lm331, whose controlled silicon phase - shift touch - off circuit was tca785, and whose communicating interface of rs232 was max202. the watchdog of the mcu was max705 and the system used an on - off electrical source to supply power

    球磨機負荷控制儀採用了單片機系統， mcu採用ds80c320高速處理器，採用max180作為md轉換器，低通濾波器為max293 ， f v轉換電路利用lm331 ，可控硅移相觸發電路使用tca785 ， rs232通信介面晶元採用max202 ， mcu監控電路為max705 ，系統使用開關電源供電。
  6. During unit startup and load is lower than 15 %, drum level is controlled by feedwater control valve, feedwater pump remains at minimum safety speed ; when load is between 15 % and 25 %, feedwater control valve is closing at fixed speed determined by function module, main motor - operated - valve is opened automatically, control mode of drum level is transferred to feedwater pump automatically and bumplessly ; when load is between 25 % and 50 %, control valve is closed fully, and main motor - operated - valve is open fully, drum level is controlled by one pump ; when load is more than 50 %, first pump is kept in operation, second pump is putting into operation automatically and

    在機組啟動、沖轉及機組並網至15 %負荷階段，給水泵維持在最低安全轉速下運行，汽包水位由低負荷給水調節閥自動控制; 15 %至25 %負荷階段，給水調節閥由函數模塊按照一定的速率自動平滑關閉，主給水電動門自動打開，汽包水位控制方式自動無擾切換為給水泵自動控制;負荷在25 %至50 %階段時，給水調節閥已完全關閉，主給水電動門已完全打開，水位控制已全由單臺給水泵承擔;負荷大於50 %后，在第一臺給水泵運行的同時，第二臺給水泵自動無擾投入。
  7. The task of realtime display on lcd and the complicated control arithmetic are implemented in this smps system, and a microcontroller with high resolution, high speed, high integration, large memory is necessary. in this paper, the design theory of s / h ware module which forms the smps control module and the design scheme is discussed in detail. in this system, the digital compute - control module is implemented with samsung ’ s high resolution, high integration, arm core microcontroller s3c44b0 and ad converter with 16bit resolution produced by ad company, ad7705. the ad7705 implements the data acquisition of the voltage and current feedback signal, and transfer the data to microcontroller through spi bus, which is implemented with s3c44b0 ’ s gpio, for computation and display

    本開關電源系統不僅完成lcd的實時顯示，還要完成復雜控制演算法，需要高速度、高精度、高集成度、大存儲空間的微控制器的支持。本文詳細的論述了構成電源控制模塊的各個軟硬體模塊的設計原理和設計方案。本系統提出了以samsung公司的高速度、高集成度的基於arm架構的微控制器s3c44b0與ad公司具有16位解析度的模數轉換器ad7705晶元構成數字採集運算控制模塊。
  8. Comparing with voltage - domain d - a converter and charge - domain d - a converter, current - steering d - a converter has its high - speed superiority, which is only influenced by the speed of current switch. because the structure is based on current replication while not on current division, it can overcome the defects of current - domain d - a converter

    電流舵型數模轉換器只受到電流開關速度的影響，相對于電壓型和電荷型結構具有高速的優勢，並且這種結構是基於電流復制而非電流劃分，可以很好地克服電流型結構的缺陷。
分享友人
分享到 Line

分享到臉書