連續校正法 的英文怎麼說
中文拼音 [liánxùjiàozhēngfǎ]
連續校正法
英文
method of successive corrections- 連 : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
- 續 : Ⅰ形容詞(連接不斷) continuous; successive Ⅱ動詞1 (接在原有的后頭) continue; extend; join 2 (...
- 校 : 校名詞1. (學校) school 2. (校官) field officer3. (姓氏) a surname
- 正 : 正名詞(正月) the first month of the lunar year; the first moon
- 法 : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
- 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
- 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
-
After analysising three existed methods for phase difference correction on discrete spectrum, it is recommended to correct the spectrum containing small noise in engineer practice by the first phase difference correcting method ( performing fft analysis on two continuous original sequence ) with harming window
綜合分析現有三種離散頻譜相位差校正方法,推薦在小噪聲工程實際中加hanning窗的第一種相位差法(采連續兩段信號作相同點數fft的相位差校正法)進行校正。During the solving process, simple method is adopted, and the pressure is weighted according to every phase ' s mass
求解過程中採用壓力校正法,校正壓力根據每相連續性方程按照質量加權計算獲得。Gas analysis. preparation of calibration gas mixtures. dynamic volumetric methods. part 4 : continuous injection method
氣體分析.校正混合氣的制備.動態容量法.第4部分:連續注入法Also discussed the methods on how to realize the cwt both in time - domain and frequency - domain and how to design the gm - c bandpass filter used in realization of cwt. in order to optimize the performance of gm - c filter, linearization techniques are investigated and proposed. due to process variation and parasitics, an automatic tuning is designed for center frequency / 0 and quality factor q also, in this thesis, 16 - channel analogue cmos cwt circuit has been realized
論文圍繞連續小波變換的模擬電路實現這一熱點問題,討論了連續小波變換的時域和頻域實現方法;具體分析了并行結構與串列結構的優缺點;研究了頻域法中的跨導-電容帶通濾波器的設計;給出了改善跨導輸入級傳輸特性的線性程度並擴大線性范圍的具體方法;設計了片內自校正(可調諧)環節使濾波器參數自動調整到設計標準值;最後給出了16通道濾波器組實現小波變換的方法。The method is to measure the cable in transmission and to infer the characteristic of the cable from a set of three pairwise measurements and get the correction factor to correct the measured data
該方法將三條電纜線兩兩組合成三對,進行三次連續的測量,從而得出電纜線的傳輸特性和校正因子,對測得的信號進行校正。分享友人