連續激光器 的英文怎麼說
中文拼音 [liánxùjīguāngqì]
連續激光器
英文
c. w. laser- 連 : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
- 續 : Ⅰ形容詞(連接不斷) continuous; successive Ⅱ動詞1 (接在原有的后頭) continue; extend; join 2 (...
- 激 : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
- 光 : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
- 器 : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
- 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
- 激光器 : [光學] (光激射器) laser (縮自 light amplification by stimulated emission of radiation); optic...
- 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
-
Continuous wave laser abbr. cw laser
連續式激光器The noise proprieties of cw intracavity doubling - frequency blue laser were studied in theory and experiments
從理論和實驗兩個方面研究了連續波腔內倍頻藍光激光器的噪聲特性。In the aspect of output characteristics, after applying the boundary conditions and the continue condition of two segments, the correlative dependence of average photon density in each segment has been obtained. combining this dependence with the threshold conditions, the theory foundation is settled
在兩段式dfb激光器的輸出特性研究方面,利用邊界條件以及兩段之間的連續條件,導出了兩段平均光子數密度之間的依賴關系;這和兩段式dfb激光器的閾值條件表達式相結合,構造了本文研究激光器輸出特性的理論框架。Continuous wave gas laser
連續波氣體激光器High - power high - efficiency nd yvo4 ktp intracavity - doubled green laser end - pumped by a diode - laser - array
腔內倍頻連續綠光激光器研究2 、 the influence to the quality of array ccd camera under the irradiation of cw and pulse laser was investigated experimentally. the result of experiment shows that the ccd easily damaged by pulse laser to cw laser. the thresholds of ka - 320 model ccd saturation and sub - damage were measured
2 、系統地開展了脈沖與連續激光干擾面陣ccd光電探測器實驗,實驗證實:與連續激光相比,脈沖激光僅需較低的能量即可將ccd破壞,得到在破壞面陣ccd探測器方面脈沖激光優于連續激光的結論。Traditional laser iff has poor security because of low frequency of laser beam coded pulse. this can be greatly improved when the pulses are modulated by continuous wave laser, but the power of this laser beam output is so low that it ’ s difficult to be detected and received by laser warning subsystem
傳統的激光敵我識別器激光編碼脈沖頻率低,通信保密性差,使用連續波激光器經調制后激光編碼脈沖頻率高,保密性好,但輸出激光功率較低,難以達到激光告警分機探測接收的要求。The main limitation of a intensity - modulated - continuous - wave laser rangefinder is the leakage distortion created by the high frequency current source which modulates the laser diode
在調強連續波激光測距系統中,調制激光器的高頻電流源產生的泄漏干擾是影響測距精度的主要因素。Continuous - wave optical parametric oscillators ( cw opos ) are an attractive source of coherent radiation in applications for which laser sources are unavailable or for which wide tunablity is needed, cw opos have remarkable features of operating with narrow linewidth and broad tunablity
連續波光學參量振蕩器( cwopos )可以用來拓寬激光的波長范圍,有較寬的調諧區域,是一種理想的產生相干輻射的裝置。由於它的窄線寬和寬調諧的輸出特性,也被用於光譜學、相干光通訊、量子光學等領域。Using fiber grating to substitute traditional wavelength - selecting components, the 8nm tuning range is realized at a repetition frequency of 2. 5ghz. ( 5 ). the wavelength - tuning methods of an active mode - locked fiber laser using a ld as a modulator are researched, and two tuning methods including temperature tuning
( 4 )對主動鎖模光纖激光器的波長調節技術進行了研究,用光纖光柵代替傳統的波長選擇器件實現了主動鎖模光纖激光器的波長調諧,並獲得了波長連續調諧范圍達8nm 、重復頻率2 . 5ghz的穩定的光脈沖輸出。The heat sources are analyzed in theory and calculated under some hypothesis. a thermal conductive model is built and by solving the model equation, the numerical values of the 1 - active region laser, 2 - active region laser, 3 - active region laser and 4 - active region laser are obtained. the dynamical temperature distribution plots are obtained, too
在一定的假定條件下對其內部的熱產生率進行了定量計算,並分別針對一、二、三、四有源區激光器建立了熱傳導模型,得出數值解,畫出激光器內部瞬態溫度分布圖,推導了激光器連續工作條件。The laser give out 10. 7mw green light, pumped 900mw. we observed it for 40 hours, the noise of green power is lower than 1 %. we optimized the laser cavity later
激光器工作在相互平行的多縱模模式下,在900mw的泵浦輸入功率下得到倍頻光功率為10 . 7mw , 40小時連續輸出光功率噪聲1 。In this thesis, by changing the position of laser, increasing the operation velocity and adding the experimental materiel, the images data under the different operational condition are gotten. visual analysis of the different area of flow field is done, using a serial of images about the typical sate of flow field
試驗過程中,通過改變激光器照射截面,提高操作風速,變化物料高度,獲得不同工況下的圖像數據,並針對不同的流動區域,將獲得的典型流動狀態的連續圖像進行了可視化分析。Regard the ni - based high - temperature alloy as substrate and the mixed powder by oneself as layer cladding, the microstructure of laser cladding layers under different craft parameters was studied by cw co2 laser
摘要為了研究工藝參數時激光熔覆層微觀形貌的影響,以co2連續激光器為熱源,在鎳基高溫合金基體表面熔覆自配粉末,對不同工藝參數下熔覆層的微觀形貌進行了分析。Based on the requirement and target of the projects, firstly, pcf bragg grating are investigated theoretically and experimentally. moreover, the effects of filling high refractive index material ( nematic liquid crystal, nlc ) in pcfs on the transmission mechanism and propagation properties are studied by using plane - wave method and finite - element method ( fem ), farther, several novel pcfs are proposed and designed. lastly, we propose and demonstrate a clad - pumped er3 + / yb3 + - codoped fiber laser, which integrate all performances of broad - band tunable wavelength, uniform output power spectrum, high repeat frequency and high average power to together
本論文選題于國家973 、 863以及國家自然科學基金等項目,結合課題的要求和主要目標,在對光子晶體光纖( pcfs )傳輸特性研究的基礎上,首先對光子晶體光纖光柵進行了理論和實驗研究;然後,採用平面波展開法和有限單元法分析了在光纖的空氣孔中填充高折射率液晶對光纖傳導機制和傳輸特性的影響,提出並設計了幾種新型光子晶體光纖;最後,提出並研製成功連續可調諧、輸出功率譜均衡的全光纖化、高功率包層泵浦鉺鐿共摻光纖激光器實驗樣機。The rate equations of theb3 + doped crystal laser in cw operation were solved. we analyzed several factorshich influenced the laser output and obtained the optimum value by calculation
建立了摻yb ~ ( 3 + )晶體激光器的速率方程,對影響連續激光器輸出功率的因素進行了分析,得到了各種優化值。We find that it is a 1319nm laser pulse that damage the ccd
實驗發現: 1319nm連續激光器點燃瞬間產生的一個1319nm長脈沖光可以破壞ccd 。Dpss cw uv laser at 355 nm
紫外連續激光器3. study on the phenomenon that ccd in light channel is damaged when cw laser is kindled
3 . 1319nm連續激光器點燃瞬間光路中工作著的可見光ccd被破壞現象的實驗研究。A laser diode with 976nm center wavelength and 2. 03w maximum cw output power is pumping unidirectionally through the couple - imaging system on a double - clad yb - doped silica fiber with a yb - concentration 0. 65 mol % circular inner core, a d - shaped inner clad, and 15m length by f - b cavity. the center wavelength of the fiber laser is 1130nm, and the maximum cw output power is 130. 7mw. an optical - to - optical conversion efficiency of 42 % and a slope efficiency of 63. 4 % are obtained
用中心波長976nm 、最大連續輸出功率為2 . 03w的ld泵浦源,通過成像耦合系統,單端直腔式泵浦纖芯摻雜濃度為0 . 65mol % 、內包層截面形狀為d形、長度為15米的雙包層摻鐿石英光纖,實現了中心波長1130nm 、最大功率為130 . 7mw的連續激光輸出,光纖激光器的光光效率為42 . 0 % ,斜效率達到63 . 4 % 。分享友人