進氣室 的英文怎麼說

中文拼音 [jìnqìshì]
進氣室 英文
air admission chamber
  • 進 : 進構詞成分。
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 進氣 : air admission; admission; inlet; onflow; charging; access of air; admittance; air in; air intake;...
  1. Numerical simulation of flows in a dual - inlet dump combustor

    雙側進氣突擴燃燒室流場數值模擬
  2. Also, it helps to prevent dust and other airborne contaminants from flowing into the room.

    它還有助於阻止塵埃和空氣所帶的其它污染物進入室內。
  3. Am i supposed to march you off to the gas chambers as well

    我是不是應該把你放進毒氣室里？
  4. Everyone hopes the serial killers gets the gas chamber

    大家都希望將那連環殺人犯送進毒氣室。
  5. The interstices between the bricks let in cold air

    冷空氣透過磚縫進入室內
  6. This engine consists of an inlet, a combustor, and a nozzle.

    這臺發動機由一個進氣道，一個燃燒室和一個尾噴管組成。
  7. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明，預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果，局部努謝爾數隨預旋角的增大而有所減小；隨旋轉雷諾數的增加，不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低：當軸向中心進氣質量流量不變時，隨預旋進氣的質量流量增加，內轉靜腔室的轉盤盤面上的換熱基本沒有變化，而預旋腔室的轉盤盤面上的換熱效果增強；當預旋進氣質量流量不變時，軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  8. By using the design concept of construction integrating with equipment and dangerous equipment isolating from construction object, the outdoor installing cage is designed for the gas stove, which includes installing burning chamber, waste gas ventage and gas inlet

    以「建築與設備互動」和「危險設施與建築主體隔離」為設計思想，對多功能燃氣具室外安裝箱進行了具體設計，包括燃氣具安裝燃燒室、廢氣排放通道、進氣道3部分。
  9. Deep covered balconies or verandahs shade and cool incoming air and provide pleasant outdoor living space

    帶蓋的長陽臺或走廊，既可遮陽又冷卻了進入室內的空氣，並提供了舒適的室外生活空間。
  10. The results indicated that the department had complied with the requirements of four key elements indicating the quality of indoor air as recommended by the environmental protection department, namely the intensity of carbon dioxide, air - borne dust particulate, radon and total viable count

    本局委託了機電工程署就本局位於稅務大樓的辦公室進行室內空氣質素測量，結果顯示大樓的室內空氣質素，符合環境保護署建議的四個空氣質素主要成分的規定。這四種含量分別是二氧化碳、空氣微塵粒子、氡和總活菌素。
  11. M111 test method for evaluating gasoline detergent in use part 6 : engine dynamometer test method for influence of intake valve and combustion chamber deposit tendencies of gasoline detergent m111 method

    評價汽油清凈劑使用效果的試驗方法第6部分:汽油清凈劑對汽油機進氣閥和燃燒室沉積物生成傾向影響的發動機臺架試驗方法
  12. Ford 2. 3l test method for evaluating gasoline detergent in use part 5 : engine dynamometer test method for influence of intake valve and combustion chamber deposit tendencies of gasoline detergent ford 2. 3l method

    評價汽油清凈劑使用效果的試驗方法第5部分:汽油清凈劑對汽油機進氣閥和燃燒室沉積物生成傾向影響的發動機臺架試驗方法
  13. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  14. For studying the performance of solid rocket ramjet under the influence of different flight conditions, it ' s significant to simulate the integrated flow field of inlet and combustor

    因此，開展超聲速進氣道/補燃室流場一體化數值模擬研究對于考查飛行狀態對於火箭沖壓發動機性能的直接影響具有重要的現實意義。
  15. Pour water into drain outlets regularly to prevent foul air and insects in the sewage pipe from entering the premises

    定期注水進排水口內，以防昆蟲及臭氣經排水口進入室內。
  16. Results show that all the geometric parameters have remarkable effects on combustion performance ; the swirl of intake air generated by skew intake holes enhances fuel - air mixing, minimizes dead zone and stabilizes the flame with reverse flow, but the excessive reverse flow can cause overheat in combustion chamber and exhaust ; the consistency of flow resistance in intake and exhaust system is conducive to the stability of heater performance

    研究表明，燃燒室進氣孔的孔徑、孔數、孔的分佈及方向等均對燃燒性能影響很大；斜孔所產生的旋轉進氣，雖具有強化燃氣混合、消除死區和迴流穩焰的作用，但迴流過度會使燃燒室及排溫過高；保證進排氣系統流動阻力（壓力）的一致性，有助於保證加熱器性能穩定。
  17. The method is described as follows : the velocity of the moving part and the gas chamber pressure were measured with a dynamic test measurement system ; a dynamic model was built on force analysis of the moving part ; the total kinetic resistance replaced the horizontal friction and water resistance ; then the resistance - velocity relation curves at moving stages were obtained ; with the empirical formula of the gas chamber pressure and the resistance - velocity relation curves, the preliminary dynamic characteristics were analyzed and the structural form and key parameters of an underwater assault rifle were determined

    具體方法為：由動力學測量系統測得活動件速度和氣室壓力；分析活動件的受力，建立動力學模型；以運動總阻力代替水平方向上的摩擦阻力和水阻力，獲得各運動階段的阻力速度關系曲線；利用氣室壓力經驗公式和阻力速度關系曲線，對水下突擊步槍進行初步的動力學分析，確定其構造型式及主要參數。
  18. In his own family. would he have gassed himself

    .他會怎麼做。他會把自己送進毒氣室嗎？
  19. . . in his own family. would he have gassed himself

    . .他會怎麼做。他會把自己送進毒氣室嗎？
  20. Finally, the inlet port and combustion chamber designed and machined is tested on 4100qb. the paper mostly investigates the change of performance targets of the engine that three different grooved chambers including two different re - entrant model and one w model match with various intake port and nozzles, in order to realize the influence of chamber geometry on combustion process. the results analyzed have indicated that re - entrant grooved chambers can enhance the turbulent intension in the chamber, improve the combustion proces of diesel engine on the altiplano, being groove, re - entrant and convex, and have the farther developing potential

    著重研究兩種縮口、一種直口矩形環槽燃燒室與不同進氣道、噴油嘴的組合方案發動機的動力性、經濟性及排放指標的變化，確定燃燒室的幾何形狀對燃燒過程的影響。分析結果表明，由於有矩形環槽、燃燒室縮口以及燃燒室底部凸臺，縮口矩形環槽燃燒室中的紊流得以加強，改善了高原柴油機的燃燒過程，這種燃燒室有進一步發展的潛力。
分享友人
分享到 Line

分享到臉書