運算放大電路 的英文怎麼說

中文拼音 [yùnsuànfàngdàdiànlù]
運算放大電路 英文
operational amplification circuit
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 放 : releaseset freelet go
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 運算 : [數學] operation; arithmetic; operating
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Using domestic strained integrated resistor as weighing sensor, at89c52 single chip as control unit, combined with arithmetical magnification, analogtodigital conversion ( a / d ), real time clock, liquid crystal display ( lcd ), and series communication interface, a minitype automatic weighing lysimeter is developed. that made measurement of evapotranspiration become conveniently and effectively in studying on water use of crops

    為了方便、有效地測定植物的蒸散，為水分利用研究提供價廉物美、簡單易用的儀器，本研究利用國產的集成電阻應變式稱重傳感器，採用at89c52單片機作為控制單元，結合運算放大、模數轉換、實時時鐘、液晶顯示、數據存儲、串列通信等外圍介面電路，研製了小型自動稱重式蒸散儀。
  2. Detail specification for electronic components. semiconductor integrated circuit - cf3080 type transconductance operational amplifier

    電子元器件詳細規范.半導體集成電路cf 3080型跨導運算放大器
  3. To solve the problems above, this dissertation supported by the project of national natural science foundation ( nnsf ) : research on piezoceramic micro - actuator ’ s polarity modeling and controlling method ( code : 60274053 ) focuses on the research of driving and control technique of piezoceramic. the drivers based on voltage, current control had been designed with the high voltage amplifier as core component

    針對壓電陶瓷驅動存在的上述問題，本文結合國家自然基金項目「壓電陶瓷微驅動器件極化模型與驅動方法的研究」 （編號: 60274053 ） ，以高壓運算放大器為核心元件，通過分析電壓、電流型驅動器原理及電路參數，提出了一種彌補其不足的復合型驅動方法。
  4. Semiconductor integrated circuits. detail specification for type jf3140 and jf3140a bimos operational amplifiers with high input impedence

    半導體集成電路. jf3140 jf3140a型bimos高輸入阻抗運算放大器詳細規范
  5. In the texts of electrical circuits and electronics they will also show how to build simple filter circuits using op - amp

    在電路和電子技術的文獻中可以找到如何用運算放大器構造簡單的濾波器。
  6. D / a conversion chip and isolation amplifiers are used to obtain the comparative levels required by isolation channels, which could be set with actual requirement ; it can enhance flexibility of the module. otherwise, four - channel isolation signal sources are exported using d / a conversion chip and isolation amplifiers as well

    另外還利用d / a轉換晶元和隔離運算放大器輸出四路隔離信號源，該隔離信號源能與隔離比較電平通過繼電器進行程式控制切換，這樣擴展了該計數器模塊的功能。
  7. The simulative circuits of active network elemellts and analog signal operation based on ota are induced systematically

    論文研究跨導運算放大器及其濾波器電路的原理和設計。
  8. The paper first reviews the research background and actuality of the filter " s design in china and other country, introduces the meaning of the project and the work of the paper, narrates the theory of the switched - capacitor network and the basic switch building blocks, analyses the related factors of the design of sc filter. such as the selection of the architecture, the trade off of the opamp " s gain, bandwidth, phase margin, slew rate and setting time, the effect of the switch " s on resistor, how to reduce the charge injection and the clock feed - through, the power consumption and the selection of the sampling frequency and so on

    本文首先回顧了濾波器設計的國內外研究背景和現狀，介紹了本課題提出的意義以及本文的主要工作，論述了開關電容網路原理和基本開關模塊，分析了開關電容濾波器設計的相關因素：電路結構的選擇，對運算放大器設計中高增益、寬帶寬、相位裕度、轉換斜率和建立時間等的折中考慮，開關的打開電阻對電路的影響，開關電容電路中怎樣減少電荷注入和時鐘饋通，以及整個電路的功耗問題和采樣頻率的選擇等。
  9. In order to obtain high resolution of the instrument, the effect of input noise of amplifier must be decreased. hereby, an amplifier circuit based on the chopping theory was developed for it

    由於該微摩擦測試儀要求的分辨力很高，而運算放大器本身的輸入噪聲嚴重影響系統的解析度，為此設計完成了基於斬波放大原理的放大電路。
  10. This product is a full electron construction in which its front - end adopts pressure sensor with baffle filled oil chip. output signal is sent the data to microprocessor from high - precision, low temperature drift and high - reliability amplification circuit and a d convert circuit, after operating, to transform by high - precision d a convert circuit into standard signal output

    該產品為全電子結構，前端採用帶隔離膜充油芯體的壓力傳感器，輸出信號由高精度低溫漂和高可靠性的放大電路和模數轉換電路將數據送入微處理器，經運算後由高精度數模轉換電路變換為標準信號輸出。
  11. Finally the module is accomplished successfully after installation and debugging. it mainly consists of the minimum system of dsp, a / d conversion circuit, cpld control logic, watchdog circuit, op amplifier and filter circuit

    該模塊主要由數字信號處理器最小系統、模數轉換電路、復雜可編程邏輯器件控制邏輯、看門狗電路、運算放大器電路和模擬濾波器電路構成。
  12. Digital design ： binary system, boolean algebra, logic gates, simplification of boolean functions, combinational logic. analog design ： amplifiers, frequency response, feedback, operational amplifier

    數位設計：二進位制、布氏代數、邏輯閘、布氏函數的化簡、組合邏輯電路。類比設計：放大器、頻率響應、反饋系統、運算放大器。
  13. In this part the signal from the infrared sensor was amplified by common collector amplifier, and the demodulator was built by filter. in which the signal got demodulated. because we just need the frequency of the signal, filter may achieved

    通過信號通路，傳感器生成的調幅波信號轉變為與脈搏頻率相同的方波。先由運算放大器接共集電極電路完成信號放大，通過濾波得到脈搏信號的頻率，從而用濾波器電路完成了解調功能。
  14. Firstly, the system has a good snr and high accuracy, which is owed to wideband operational amplifier being used, accurate adjustment by da, 12 - bit high sampling ad converter being applied. secondly, data transmission becomes less by using forecasting code technology and dictionary compress technology, which are run by dsp on board

    本採集系統採用400mhz增益帶寬積的運算放大器，運用da高精度校準技術，並選用高采樣率低噪聲的12位ad轉換晶元進行模擬電路和ad轉換電路設計，既保證了數據採集系統的信噪比，又提高了系統測量精度。
  15. Based on the study of circuit cells which are applied in sige bicmos operational amplifier, the telescope cascode configuration is selected to realize high speed and high gain

    其次，通過對sigebicmos運算放大器中電路單元的研究，並結合運放實際設計指標，選擇套筒式共源共柵結構作為運放的主體結構以確保高速、高增益的實現。
  16. Rc oscillator ’ s frequency is 1khz. the voltage reference of ic is 2. 2v, which can keep stabilization when the power supply is bigger than 2. 3v. in that case circuits can insulate yawp from power supply

    在穩壓源電路設計中，採用了運算放大器負反饋的形式，使參考電壓源為2 . 2v ，並在電源大於2 . 3v時保持穩定，隔離了電源噪聲。
  17. The current in the dac ’ s output can drive the load, and the structure can save a buffer consisted of operational amplifier, so the structure can achieve high speed with no close - loop and feedback in this circuit

    該10位分段式電流舵型數模轉換器的輸出端可直接用電流輸出來驅動負載阻抗，省去運算放大器構成的輸出緩沖，整個電路中沒有形成閉環和反饋，因此這種電路結構可以達到很高的速度。
  18. The paper studies the theoretics and synthesis of current feedback operational amplifier ( also called transirapedance operational amplifier, for short cfoa ) and cfoa - c filter circuit, introduces the present state of the research of analogy integrated circuit

    本文研究電流反饋運算放大器（又稱跨阻運算放大器，簡稱cfoa ）及其濾波器電路的原理和設計。
  19. And the ways to optimize the circuit architecture, minimize the circuit nonidealities and improve the circuit performance are analyzed combined with the characteristics of the modulator architecture. based on it, the switched - capacitor integrator, class a amplifier, nonoverlap clock, voltage reference, comparator, feedback dac have been designed. in the end, the layout design is shown

    調制器採用全差分開關電容電路實現，並根據系統結構特點就如何優化電路結構、克服電路中存在的非理想特性、提高電路性能作了具體分析，在此基礎上完成了開關電容積分器（開關、電容、運算放大器） 、參考電壓源、比較器、兩相非交疊時鐘、反饋dac等模塊的電路結構和參數設計。
  20. These chips based on this design may be used for mobile communication, personal digital assistant, portable audios etc. in this thesis, developing situation and characteristic and basic application of operational amplifiers are introduced in chapter l

    這些運算放大電路可望用於移動通訊，個人數字助理，便攜式音響系統，電池監測系統等產品中。第一章介紹了運算放大器的發展概況、特點以及基本應用。
分享友人
分享到 Line

分享到臉書