過熱管 的英文怎麼說

中文拼音 [guòrèguǎn]
過熱管 英文
superheater pipe
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  1. The afterheat, which is collected by recovery devices, in winter can be used as the low level thermal source of heat pump, and in summer can preheat feed water, thus equivalent an economizer. because energy flows in the system so reasonably that energy is used to the most, therefore, its energy conservation effect is significant, and the operating expenditure declines consequently. the sewage can be reused after due treatment, thua it has a certain social and ecological benefit, too

    本研究中選用分離式熱管裝置提供洗浴用水，利用水源熱泵裝置，一機兩用，進行空間供熱和製冷，並通過余熱回收器對系統內的余熱進行回收，冬季可作為水源熱泵的低位熱源，夏季可對鍋爐給水進行預熱，起到「省煤器」的作用。這樣實現系統內的能量合理流動，從而達到節能的目的，同時洗浴污水經適當的處理后可以回用，因而還具有一定的社會和生態效益。
  2. Blowout reason analysis of low - temperature superheater tube

    低溫段過熱器管爆裂原因分析
  3. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  4. Structured with glass or plastic transparant pipe, and directly make it into thermotube, which makes the whole thermotube become visible for our naked eyes to observe the work state of the working substance in the interior of thermotube ; fully transparent thermotube research and tutorial appliance also offers the metal and nonmetallic pipes of the same shape used for contrasting, from which we can conclude their diathermancy in different conditions, demonstrate intuitionistically and testing the different performances of the thermotube, which makes the study and the testing about the thermotube ' s performance more deep and easy

    採用玻璃或透明塑料的管，並直接將其製造為熱管使得熱管的全部都是可以用肉眼觀測到熱管內部的工作介質工作的狀態，全透明熱管科研教學器具還給出了與熱管同樣外形的用於作對比的金屬管和或非金屬管，可以通過對比確定不同條件下的熱管與金屬或非金屬的傳熱性能，可以直觀的演示、測試熱管的各種性能，更深入、易懂地學習、試驗熱管的各種性能。
  5. Manufacturers ' data report for watertube boilers, superheaters, waterwalls, economizers

    水管鍋爐過熱設備爐壁水管排和熱力裝置的生產商數據報告
  6. The difference of heated area between tubes is very small, so the thermal deviation mainly results from inhomogeneous endotherm and flux

    但由於管子毛間的受熱面積差異很小，過熱器的熱偏差主要由於吸熱不均勻和流量不均勻造成。
  7. In the paper, theoretic transfer heat model of hhchp is established. after comparing experimental value and estimative value, we deduce that theoretic transfer heat model accords with actual condition, so we can estimate the heat performance of hhchp by theoretic calculation formula

    同時建立了蜂窩熱管平板式太陽能熱水器的理論傳熱模型，通過對實驗值和理論值的比較，得出進行簡化后的理論模型在一般情況下與實際的情況是符合的，因此可以用理論計算公式對蜂窩熱管平板式太陽能熱水器的熱性能進行估算。
  8. However, in its process of development, china ' s convention and exhibition industry has encountered some undeniable problems, such as fraudulence, overlapping and redundancy, ipr infringement, deficiencies in the management system, lack of legal regulations, overheated exhibition facility construction, disruptive competition and the lagging behind of industrial associations

    但同時，當前我國的會展業發展中也出現了一些不容忽視的問題，比如：騙展、重復展和侵權現象時有發生，管理體制不順，缺乏法律規范，展館建設過熱，市場競爭無序，行業組織建設滯后等等。
  9. It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test

    加熱管選用耐高溫氧化鎂作絕緣介質，不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理，形成一種特殊的氧化層，提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高，熱輻射能力強。產品經長達3000h的壽命試驗后，仍能正常工作，安全性能好。
  10. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  11. Heaters of high temperature, such as soldering irons, should be kept away from the vinyl insulation sleeve of capacitor which to avoid the cause made over heat or break down to sleeve

    電烙鐵等高溫發熱裝置應與電解電容器塑料外殼保持適當的距離，以防止過熱造成塑料套管破裂。
  12. Welding of phenethylene superheated steam heater

    苯乙烯過熱蒸汽爐管的焊接
  13. But when the wind - speed becomes above 1m / s hereafter, wind - speed increase for the cpu thermal siphon of transmit heat the ability ' s gain result the deceleration. so it is considered perfect when the wind - speed is 1m / s. through this experimentation we found that when the cpu thermal syphon cooling machine used acetone as working fluid, wind - speed 1m / s, cpu chip caloricty 60w, its volumetric heat release rate came to 1. 3 104w / ( m3k )

    通過本次實驗測出所使用的cpu重力熱管散熱器在使用丙酮為工質，風速1m / s ， cpu晶元發熱量為60w時，其體積散熱率達到1 . 3 104w / （ m3k ） ，能保證晶元溫度與環境溫度之差小於40 ，能很好的適應pentium -計算機長期運行的要求。
  14. This paper set up mathematics model for this compound heat pipe and analyzes its heat transfer process to provide theoretic thereunder

    本文為這種復合型熱管結構建立了數學模型，並對它的傳熱過程加以分析，為其改進建立理論依據。
  15. In addition, that building experiment setting is used for experiment and analyzed performance of the heat pipe radiator that using five different working substance

    並為該熱管散熱器建立了試驗臺，通過使用五種不同的工質對該種熱管散熱器的性能加以試驗及分析。
  16. An integrated process of wastewater treatment and utilization is presented. the process is made up of heating the soft water of room temperature by high temperature printing and dyeing wastewater via heat exchangers, reusing the low level base decrement wastewater of water washing for dust control and desulphurizing of stack gas and anaeration - aeration biological treatment of printing and dyeing wastewater. this process has fair economical benefit on the principle of so called waste control by waste itself. this might be an ideal process for printing and dyeing wastewater treatment and disposal, the effluent of this process is quite enough to meet the requirement of urban sewer collector. additionally also many advantages are attractive such as the complete return of biological sludge to digestion, no chemicals dosage and free of secondary pollution

    介紹了高溫印染廢水通過熱交換加熱常溫軟水、低濃度堿減量水洗廢水用於煙道氣除塵脫硫、厭氧-好氧處理一般印染廢水等印染廢水綜合處理技術，該技術具有較好的經濟效益，達到了以廢治廢的目的，生物污泥全部迴流硝化，不加任何藥劑，無二次污染，處理后水質達到城市截污管網標準要求，是一種較為理想的印染廢水處理工藝。
  17. The product adopts the infalling through system on the structure of boiler pipe line, if equips safely valve an will stop working automatically in case hyperthermal, super - pressure and low water lever

    安全採用水管貫流式爐膽結構，並配備安全閥，溫度過熱，水位過低，壓力過高等四重保護，絕對安全可靠。
  18. Connecting with the practice of a certain power plant in shanxi province, this paper analyzes on the mechanisms and reasons of the leakages caused by the burst of high - temperature superheater tubes of the boiler, and advances some feasible measures for guaranteeing the normal operation of the boiler superheater

    結合山西某電廠實際，分析了鍋爐高溫過熱器爆管泄漏的機理、原因，提出了一些可行的措施來保證鍋爐過熱器的正常運行。
  19. A nonlinear mathematical model is developed to determine the flow rate distribution in the parallel tubes of boiler superheater and reheater by depending on the relation of pressure drop among individual tubes and accounting for the static pressure variations in the inlet and outlet headers

    根據並聯管組各根管子進、出口壓力降之間的關系，並考慮到分配集箱與匯集集箱中流體的靜壓變化，建立了鍋爐過熱器、再熱器流量分配的非線性數學模型。
  20. It is widely in sectors of petroleum, chemical engineering, power, printing and dyeing textile for heating and steaming system, condensation water recycling and over heating steam projects

    該閥廣泛用於石油、化工、電力、紡織印染、等行業的各種蒸汽加熱設備，蒸汽管網、凝汽管網、凝結水回收工程和低過熱蒸汽工程。
分享友人
分享到 Line

分享到臉書