配位聚合物 的英文怎麼說

中文拼音 [pèiwèijùgěwù]
配位聚合物 英文
coordinate polymer
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 聚合物 : [化學] polymer; polymerizate; polymeric compound; polymeric substance; polymeride; polymerized su...
  • 聚合 : 1 （聚集到一起） get together2 [化學] （單體結合成高分子化合物） polymerization; polymerize 3 [生...
  1. Progress of pyridine - 2, 6 - dicarboxylic acid coordination polymers

    二甲酸配位聚合物的研究進展
  2. Coordination polymers containing imidazole moieties

    咪唑基配位聚合物
  3. This thesis was composed in three parts : ( 1 ) the performance of the catalysts for the oligomerization and polymerization of ethylene ; ( 2 ) the comonomer effect of the in - situ copolymerization of ethylene by the bis ( imino ) - pyridyl iron complexes and metallocenes ; ( 3 ) the in - situ copolymerization of ethylene by cobalt - based catalysts and metallocenes

    本論文共分為3部分：催化劑性能的評價，雙亞胺基吡啶鐵配合物與茂金屬復配催化乙烯原位共聚中的共單體效應以及雙亞胺基吡啶鈷配合物與茂金屬復配催化乙烯原位共聚。
  4. In chapter 1 of this paper, simply introduces material polymer materials, organometallic polycondensate, organometallic coordination polymer and organometallic polymeric magnetic materials

    本文第一章簡要介紹了材料、高分子材料、金屬有機高分子材料、金屬有機縮聚高分子、金屬有機配位聚合物和金屬有機高分子磁性材料。
  5. In part 3, the in - situ copolymerization of ethylene was investigated by the combinations of the cobalt - based catalyst and the metallocene to prepare short - branched polyethylene. the major oligomers catalyzed by the cobalt - based catalyst 5, 6 and 7 werel - butene, and the minor were 1 - hexene. the comonomer effects were also observed

    在雙亞胺基吡啶鈷配合物與茂金屬復配催化乙烯原位共聚制備短支鏈支化聚乙烯中，合成了3種雙亞胺基吡啶鈷配合物，研究了反應條件對其催化乙烯齊聚活性和所得產物碳數分佈的影響。
  6. The main methods to prepare polyphosphazene were first introduced, then the living cation polymerization at room temperature and the reaction halogenphosphazene and pentacoordinate silicon complexes developed in our laboratory were discussed

    在回顧聚磷腈的主要合成方法的基礎上，介紹了出現的室溫活性正離子聚合及本實驗室利用鹵化磷腈與五配位硅絡合物反應所取得的一些結果。
  7. With the increase of the gptms, the decomposition temperature of the rare earth complexes decreased gradually, which also indicated that the existence of the organization results in the decrease of the decomposition temperature of the rare earth complexes in the gels

    由於hy ： h 」配合物在teos水解縮聚形成的祆。凝膠中原位合成程度較小，所以隨著ph的上升，熒光逐漸增強，在ph值達到5對左右時，熒光達到最強，表明a 。
  8. This review covers the properties of chitosan, derivative anddegradation product complex with metal, the condition, composition, structure and characterization on synthetic complex, and their applications were brietly introduced

    本文綜述了殼聚糖、殼聚糖衍生物及其降解產物與金屬配位的性能，形成某些配位化合物的條件、組成、結構及其表徵，簡述了它們的應用。
  9. Abstract : this review covers the properties of chitosan, derivative anddegradation product complex with metal, the condition, composition, structure and characterization on synthetic complex, and their applications were brietly introduced

    文摘:本文綜述了殼聚糖、殼聚糖衍生物及其降解產物與金屬配位的性能，形成某些配位化合物的條件、組成、結構及其表徵，簡述了它們的應用。
  10. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  11. In conclusion, the properties of the polymers can be controlled to some extent by simply adjusting the ratio of the catalysts ( n ( fe ) / n ( zr ) ) in the in - situ copolymerization of ethylene

    在乙烯原位共聚中，可以通過調節齊聚催化劑與共聚催化劑的配比對聚合產物的物理性能進行控制。
  12. Tem reveals that the complex possessed good dispersibility in the system and the status varied reversibility with the ph value and the size of the complex is within 20 ~ 40nm. the complex was characterized by ft - ir, uv - vis, fluoresence and electrical conductivity methods. paa - ag nanospheres were also synthesized by coordination of polyacrylic acid and silver ( i ) ion and queued in line in lr

    本論文還以低分子量的聚丙烯酸和硝酸銀為主要原料，通過控制體系的ph值合成響應環境ph值變化的聚丙烯酸銀納米微球和納米柱狀物，通過tem觀察尺寸達20 - 40nm ，用ir 、 uv - vis 、熒光、電導率法分析聚丙烯酸和銀的配位作用、所形成配合物的組成與結構，並將聚丙烯酸和硝酸銀置於「線性反應器」中進行配位聚合，合成出線性排列的paa - ag納米微球。
  13. The study of in - situ construction of cytocompatible surface on pdl - la matrix via amphiphile - amino acid ( rgd ) hybrid self - segregation - the amphiphilic diblock copolymer, poly ( dl - lactide ) - poly ( ethylene oxide ) ( pla - peo ) copolymer, containing hydrophobic pla block and hydrophilic peo block was synthesized via coupling method in this dissertation. cell - adhesion - promoting amino acids and integrin receptor peptide rgd were then immobilized at the end of peo chain of pla - peo copolymer via hydroxyl group activation technique. the solvent blending and casting method was then used to obtain the amphiphile modified pdl - la membranes

    兩親共聚物-氨基酸（ rgd ）雜化體原位自修飾構建聚乳酸細胞相容性表面的研究一本論文首先設計併合成了一類含疏水聚乳酸（ pla ）鏈段和親水聚氧乙烯（ peo ）鏈段的兩親嵌段共聚物材料（ pla - peo ） ，利用peo鏈端的活性官能團羥基固定了促細胞粘附的氨基酸及整合素配體多肽片段rgd 。
  14. The factors of influencing coordinate polymer structure, such as metal ions and ligand, were discussed. the reaction conditions of coordinate polymer were studied

    摘要討論了影響配合物結構的一些因素；金屬離子和配體等。也研究了配位聚合物的反應條件。
  15. This article discusses the synthesis methods of the three - dimension transition metal coordinate polymer with nano - pore, mainly through selecting proper ligand to enlarge nanoporous volume and increase the stability of the polymer in order to enhance its gas - storing property

    摘要綜述了具有納米孔道的過渡金屬三維配位聚合物的合成方法，主要是通過選擇合適的配體來增大孔道和提高配合物的熱穩定性，達到增強儲氣性能的目的。
  16. In the test of developing the macromolecule polymer - stabilizing agent, a lots of macromolecule polymer have used by different ratio. the optimization ratio of macromolecule polymer has been found by use of the intersect test

    復合高分子聚合物穩定劑研製中進行了大量的化學配比正交試驗，對化四j ；大學博士學位論文學組分配比進行優化。
  17. Progress in studies on coordination chemistry and applications of natural polymer chitosan chitin

    殼聚糖的配位化學和配合物應用的研究進展
  18. Synthesis and crystal structure of two - dimensional network copper coordination polymer linked by tartrate

    配位聚合物的合成和晶體結構
  19. It can be used instead of plastic and will get wide use in area of industry, agriculture and medicine

    聚乳酸的傳統合成工藝有陽離子聚合、陰離子聚合和配位聚合三種，但隨著技術的進步，已有了不少改進方法，如生物合成等。
分享友人
分享到 Line

分享到臉書