重力載荷 的英文怎麼說

中文拼音 [zhònglìzǎihé]
重力載荷 英文
gravity load
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 重力 : [力學] gravity; force of gravity; gravity force; power of gravity; pull of gravity; gravitational...
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. It provides strong basement for the research of design. the method of structure analysis commended by this paper is based on nonlinear finite - element, diathermanous and elasticity mechanics. it found the model of a steel beam pressed by gravity and temperature in the condition of indoor fire

    本文提出的結構分析法是在大量參數分析的基礎上，以非線性有限元、傳熱學及彈性力學為基礎，利用ansys軟體，建立一個鋼框架梁在室內局部火災條件下的傳熱模型與在重力荷載及溫度荷載共同作用下的受力模型。
  2. Establishing an human spine dynamic model is an significan event to study spine injured biomechanics of pilot " s ejective injury, parachute opening, landing and study the endurance to impact loading on human spine. in this paper, the huston " s method of kane " s equations is developed so that it can be applied to the multibodysystem including translation between the bodyies. the dynamic model of human spine is provided basing on these theories, while the big movement of spine is considered. the deformation of vetebra is far smaller comparing with the intervetebra disc, so the spine is considered into multibodysystem including rigid bodies ( vetebra ) and the flexible bodies ( intervetebra disc ). the computer solution correspond with the results of the large scale human impact test. the rigid coefficient factors and the damping factor of intervetebra joints are obtained

    人體脊柱動力學模型的建立對研究飛行員彈射救生、傘兵跳傘開傘、著陸等脊柱損傷的生物力學以及研究人體脊柱耐受沖擊載荷的極限問題都具有重要意義.首先發展了凱恩方程的休斯頓方法，使其可應用於變形體連接的多體系統，並以此理論為依據建立人體整椎脊柱沖擊動力學模型，此時考慮脊柱的大位移運動，每個椎骨的變形相對椎間盤的變形小得多，把脊柱看成由剛體（椎骨）和變形體（椎間盤）組成的多體系統.並以大型真人坐姿沖擊實驗結果進行了擬合，最後得到腰椎間關節剛度系數因子和阻尼系數因子
  3. It is an important half hardware - in - loop simulation equipment, which is often used to simulate the aerodynamic torque load on the missile rudder or elevon actuators in the flight

    它是地面半實物模擬系統中的一種重要專用設備，用來模擬飛行器舵機在飛行過程中所承受空氣動力力矩載荷。
  4. The principal perturbing forces for launch vehicles, both on the launch pad and in flight, are the aerodynamic loads produced by winds.

    發射飛行器在發射臺上以及在飛行中的重要擾動力是由風產生的氣動載荷。
  5. Design of load limiter with pulling ring for tower crane

    起重機拉力環型載荷限制器的設計
  6. Normal force of the total weight of the payload and the carriage

    載荷與支架總重的法向力
  7. Choose two nodes on the edge of the structural to compare the results calculating by the finite element program midas, then we can draw a conclusion that these kinds of space truss systems is sensitive to the libration of the dynamic wind loads. to consider this factor is very necessary in the process of design, we will use the pulsant augmentation coefficient to realize it

    比較靜力風荷載和動力風荷載作用下的有限元軟體的計算結果，選取結構邊緣部分的兩個節點，對比它們在兩種方法計算下的最大位移的計算結果。經過比較可以看出重量輕、頻率低、阻尼小的柔性建築物對風荷載的橫向振動是很敏感的，在進行工程設計時應該考慮這種因素，並可採用乘以風振系數等相應方法來加以體現。
  8. Nowadays, the ways to detect the piles are various, and all of them are limited in some aspects. for instance, coring test do large scathe on the piles, and static load test will waste much time, money and energy, while some ways are hard to operate as the limitation of the length and the diameter of the piles, and the special condition on the spots, such as high - strain, low - strain, and so on. furthermore, the result can only be gained under the complex analysis of the collected wave, and under the validation of the coring test

    目前，工程中常用的樁基檢測方法很多，但都存在著一些弊端：有的對樁破壞性嚴重，例如抽芯檢測；有的耗時、耗財、耗力，例如靜載荷試驗；還有的如低應變、高應變等檢測技術由於受到樁長、樁徑以及現場一些特殊情況的限制，操作很不方便，而且採集到的波形要經過比較復雜的處理分析方能得出結論，而這個結論卻還要輔助取芯手段加以驗證。
  9. The dynamic force - displacement relation curve is of crucial important to the design and operation of mechanical impact devices. using one - dimensional wave mechanics and characteristic line theory, this paper presents a testing method for determination of dynamic force - displacement relation curve from one - point strain measurement on an elastic rod endface. the principle of measurement, data processing method and experimental results for penetration into granite are discussed. 4figs., 5refs

    沖擊載荷下彈性桿端的作用力-位移關系曲線是沖擊機械繫統研究的重要內容.基於一維波動力學方程，應用特徵線方法，探討了已知一點應變求取彈性桿端的作用力-位移曲線的測試原理與數據處理方法，以及在花崗巖上沖擊鑿巖機具的測試結果，對一點應變測試法的可行性進行了論證.圖4 ，參5
  10. After researching the loads on dangerous rock synthetically, the author points out the development and collapse mechanism of dangerous rock : the geology foundations that forms dangerous rock are the constructional surfaces such as tectonic fracture 、 relief fissure, soft interlayer etc. the developing of dangerous rock is due to release of in - situ stress in rock 、 aeolation 、 water erosion and root flerry. the main loads leading to collapse of dangerous rock are gravity, water pressure and earthquake force

    在綜合研究危巖上的各種作用之後，本文提出了危巖的形成和破壞機理：硬質巖體中構造裂隙、卸荷裂隙、及各種軟弱夾層，結構面的的存在是危巖形成的地質基礎；地應力卸荷、風化、流水侵蝕、植物根劈是危巖發育的主要作用；重力、水壓力、地震力是危巖崩塌的主要荷載。
  11. Load simulator was an important simulation system in hardware - in - loop flight simulation laboratory, which could simulate aerodynamic loads acting on flight vehicle, such as unmanned aerial vehicle, planes

    負載模擬器是半實物模擬實驗室中模擬無人機等飛行器在飛行中舵面所受空氣動力載荷的重要設備。
  12. Electro - hydraulic servo loading system ( ehsls ) is an important simulation system in hard ware - in - loop flight simulation laboratory, which can simulate aerodynamic loads acting on flight vehicle, such as missiles, planes. its performance of test is important on the design of flight vehicle

    電液伺服負載模擬器是半實物模擬試驗室中模擬飛行器在飛行中舵面所受空氣動力載荷的重要設備，它的試驗能力高低對飛行器設計起著重要作用。
  13. Electro - hydraulic servo loading system ( ehsls ) is an important simulation system in hardware - in - loop flight simulation laboratory, which can simulate aerodynamic loads acting on flight vehicle, such as missiles, planes. it is one of most important devices in the whole flight vehicle simulation system

    電液伺服加載系統是半實物模擬實驗室中模擬導彈等飛行器在飛行中舵面所受空氣動力載荷的重要設備，它是飛行器大迴路半實物模擬系統的重要組成部分。
  14. Compared with non - slung - load flight, additional aerodynamic load, gravity load should be considered in the slung - load system. so the moment to the gravity center, flight mode and the natural frequency will change

    直升機吊掛飛行，與直升機非吊掛飛行狀態相比，增加了新的氣動載荷、重力載荷，和因此產生的對直升機重心的力矩，其飛行運動模式、低頻振蕩固有頻率均發生改變。
  15. 2. dynamics analysis : by setting up jacon matrix differential coefficient sport is passed to descartes space. it makes terminal executing manipulator produce differential coefficient of acceleration and force in every different coordinates can be got. then the effective inertia, coincident inertia and gravity load of two manipulators are calculated by lagrange method. so generalized joint torque of each joint is got, and along with equivalent driving torque, actual driving torque of each joint can be worked out. 3

    動力學分析：建立雅可比矩陣將關節空間的各關節的微分運動傳遞到笛卡爾空間，使末端執行器位姿產生微分運動，以用於求加速度及力在不同坐標系間的線性變換，再用拉格朗日法計算兩機械手的有效慣量、偶合慣量、重力載荷，從而計算得到各關節的廣義關節力矩，並與等效驅動力矩共同算得各關節的驅動力矩。
  16. The production is composed of dtzziii - dj type elevator weight - load indicating controller box and pressure sensor

    產品由dtzz - dj型電梯重量載荷指示控制儀和壓力傳感器組成。
  17. Ltd founded in 1999, is a new high technology enterprise, specialized in researching, developing, manufacturing and selling of elevator weight - load system, elvator ic intelligent management system and the like of elevator dynamic static state data record management system and the like of elevator fittings. there are more than 100 experienced staff members including r d perpons, engineers and adminstrators who do their utmost to offer prompt, efficientand overall services for customers. our company manufactures six kinds of productions that hold autonomous. our company manufactures six kinds of production that hold autonomous intellectual property rights and has established long - term friendly cooperation with over one hundred ecactly elevator manufacturtures in china and abroad

    秦皇島開發區前景光電技術有限公司成立於一九九九年，是一家專業從事研製開發銷售電梯重量載荷控制系統電梯ic卡智能管理系統電梯遠程自動報警安防管理系統和永磁同步電梯專用變頻器等電梯配件產品的高新技術企業。我公司擁有經驗豐富的科研工程技術管理人員一百余名，竭力為客戶提供迅速優質全面的服務。公司生產擁有自主知識產權的九項專利產品，並與百余家整梯生產企業建立了長期的友好合作關系。
  18. The production is composed of dtzziii - dft type elevator weight - load indicating controller box and pressure sensor

    產品由dtzz dft型電梯重量載荷指示控制儀和壓力傳感器組成。
  19. The production is composed of dtzziii - sk type elevator weight - load indicating controller box and pressure sensor

    產品由dtzziii sk型電梯重量載荷指示控制儀和壓力傳感器兩部分組成。
  20. The production is composed of dtzziii - ah type elevator weight - load indicating controller box, four pressure sensors and buffer rubbers

    產品由dtzz - ah型電梯重量載荷指示控制儀四隻壓力傳感器和緩沖橡膠塊組成。
分享友人
分享到 Line

分享到臉書