鈣熱法 的英文怎麼說
中文拼音 [gàirèfǎ]
鈣熱法
英文
calciothermics-
Methods for chemical analysis of melted welding fluxes. the pyrolytic method for determination of calcium fluoride content
熔煉焊劑化學分析方法.熱解法測定氟化鈣量The 3d electrons increased with the content of mn doping increasing, and the electrical property increased accordingly as the electron transport path improved. it is confirmed that all the orthorhombic perovskite phase which is formed initially at the heat treatment temperature of about 600c and thoroughly above 850c are observed in the lcmto thin film deposited on si ( 100 ) substrate by rf magneto - controlled sputtering
確認了採用射頻磁控濺射法于si ( 100 )基板上生長的薄膜至多在600熱處理已開始形成晶相,形成的晶相全部是正交晶系鈣欽礦相,提高熱處理溫度,薄膜中晶相含量相對增大,高於850后晶相基本形成完畢。The major performances of concrete and mortars, which are mixed with different quantities of expansion admixtures under the same mix proportions, are studied systematically and deeply in this work. sulphoaluminate mixed with a type of new expanding component by use of the composite methods are studied in the laboratory, and some achievements have been obtained. the service conditions, the characteristics and the shortcomings of expansion admixture in the concrete engineering are analyzed and summarized based on literatures, and the expanding mechanism of concrete is discussed
本文試圖從膨脹劑不同摻量研究其對混凝土和砂漿主要性能的影響,進行了一系列宏觀力學性能試驗研究;利用差熱分析( dta ) 、掃描電子顯微鏡( sem )等分析手段對鈣礬石等水化產物的結晶和生成量、形貌特徵進行微觀分析;並採用復合方法摻加新型膨脹組分對硫鋁酸鹽類膨脹劑( uea )進行了改性試驗研究,根據多因素模糊綜合評價方法就各類膨脹劑的主要性能進行綜合評價,得出摻加新型膨脹組分pt的膨脹劑性能較優,取得了明顯的效果。Hydrated calcium silicate with nm - order size manufactured by using dynamic autoclaved technology
水熱法制備水化硅酸鈣納米粉體The purpose of this study was to investigate the performance and thermodynamic mechanism of an engine exhaust - powered adsorption refrigerating unit tube using cacl2 as absorbent and nh3 as refrigerant
本文提出了一種氯化鈣-氨吸附製冷單元管的設計方法,並對其工作過程中的性能和熱動力學機理進行探索。Thermodynamics of smelting metallic calcium by silicon - thermal method and its smelting technology
硅熱法冶煉金屬鈣的熱力學及工藝Nanosized lead titanate ( pt ) and lead titanate doped with calcium and lanthanum ( pclt ) powder obtained by the sol - gel method was added into vinylidene fluoride - trifluoroemylene [ p ( vdf - trfe ) ] to form nanocomposite to be used as the sensing film of the pyroelectric detector. the experiment results show that after mixing in 0. 16 volume fraction of pclt powder, the pyroelectric coefficient of pttp ( vdf - trfe ) composite film was about 37 % higher than that of the pure p ( vdf - trfe ) film prepared under the same condition, and the voltage figure - of - merit of pt / p ( vdf - trfe ) composite film was about 22. 4 % higher
用溶膠-凝膠法制備了鈦酸鉛( pt )和摻鈣鈦酸鑭鉛( pclt )納米粉粒,與聚偏氟乙烯-三氟乙烯( p ( vdf - trfe )均勻復合,由於16的摻鈣鈦酸鑭鉛納米陶瓷粉粒的摻入,使得pclt / p ( vdf - trfe )復合膜的熱釋電系數值提高了約37 ,探測優值提高了約22 . 4 。Abstract : the equilibrium constant of carbonization reaction of lime white was calculated using three thermodynamics methods. the results indicate that the carbonization reaction of lim white was the neutralization reaction between acid and alkali first, and it was the transform reaction of precipitation second. the essential cognition of the carbonization reaction of lime white was deepend. it was of guiding significance for industrial production of light ( precipitation ) calcium carbonate
文摘:用3種熱力學方法計算了石灰乳碳化反應的平衡常數,結果表明,石灰乳的碳化反應首先是酸堿的中和反應,其次才是沉澱的轉化反應,從而加深了對石灰乳碳化反應本質的認識,對輕質(沉澱)碳酸鈣的工業生產有指導意義The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm
採用改進的檸檬酸法(以檸檬酸和edta乙二氨四乙酸為復合絡和劑,檸檬酸為燃料)和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm ( la _ ( 0 . 9 ) sr _ ( 0 . 1 ) ga _ ( 0 . 8 ) mg _ ( 0 . 2 ) o _ ( 3 - ) ) ,用差熱?熱重分析( dta / tg ) 、 x光衍射分析( xrd ) 、交流阻抗譜技術( ac - impedancespectra ) 、比表面積分析( bet )和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵,並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。分享友人