鈦酸鋁 的英文怎麼說

中文拼音 [tàisuānlǚ]
鈦酸鋁 英文
aluminium titanate
  • 鈦 : 名詞[化學] （金屬元素） titanium （ti）
  • 酸 : 酸構詞成分。
  • 鋁 : 名詞[化學] aluminium （13號元素, 符號al）
  1. The preparation method of methyl 1 - naphthylacetate catalyzed by sulphuric acid, hydrochloric acid, chlorosulfonic acid, p - toluene sulfonic acid, amino sulfonic acid, strongly acidic cationic exchange resin, ferric chloride hexahydrate, stannic chloride pentahydrate, aluminium chloride, ferric sulfate, aluminium sulfate, titanium sulfate, sodium bisulfate monohydrate, solid super acid, heterpoly acid, support heterpoly acid, composite titanate and p - toluene sulfo - chloride etc. catalyst were reviewed

    摘要評述了硫酸、鹽酸、氯磺酸、對甲苯磺酸、氨基磺酸、強酸性陽離子交換樹脂、六水三氯化鐵、五水四氯化錫、三氯化鋁、硫酸鐵、硫酸鋁、硫酸鈦、一水硫酸氫鈉、固體超強酸、雜多酸、固載雜多酸、復合鈦酸酯和對甲苯磺酰氯等催化劑催化合成1 -萘乙酸甲酯的方法。
  2. But it also includes two fatal disadvantages : first, at is difficult to be sintered and its density is low, which causes its lower strength ; second, in the temperature range of 1023 - 15 73 k, at can decompose into al2o3 and tio2 easily, which can cause the stress concentrated and raise the heat expansion rate

    但是該材料本身存在的兩大致命的缺點，在很大程度上限制了它的廣泛應用： （ 1 ） 、鈦酸鋁難以燒結，燒結體的緻密度低，因而強度不高； （ 2 ） 、在750 1300的溫度范圍內易分解成氧化鋁和二氧化鈦，造成材料內部應力集中，並使材料的熱膨脹率升高。
  3. At the same time, we also can supply taed, thiourea, melamine, aluminum sulphate, titanium dioxide rutile and anatase, rubber accelerator, methyl cellulose, hydroxypropyl methyl cellulose, monoammonium phosphate and other phosphates, 2 - ethyl anthraquinone, etc

    同時還可為客戶提供四乙酰乙二胺硫脲三聚氰胺硫酸鋁鈦白粉橡膠促進劑甲基纖維素羥乙基甲基纖維素羥丙基甲基纖維素，磷酸二氫銨2 -乙基蒽醌等十幾種優質化工品。
  4. Preparation of mullite sol and mullite sol coated aluminum titanate powder

    莫來石溶膠的制備及對鈦酸鋁粉體的包裹
  5. For the sake of overcoming the two fatal disadvantages of at that its density and strength is low, and in the middle temperature range it can decompose into ahos and tic > 2 easily. in this dissertation, magnesium dititanate ( mgti2os, m2t ) is introduced to form solid solution to restrain the decomposition and improve the strength of at in high temperature

    為克服at強度偏低和中溫域易分解的缺點，本文引入與at晶型相同的二鈦酸鎂（ mgti _ 2o _ 5簡稱m2t ） ，通過與at形成固溶體以抑制鈦酸鋁中溫分解，並滿足其力學強度。
  6. Inorganic salts, such as a1 ( no3 ) 3, zrocl2, ticl3, et al. was used as raw materials and corresponding hydroxides were deposited on the surface of graphite particle with heterogeneous nucleation process ; composite particles of graphite / oxides were obtained after heat treatment. in this paper, preparing conditions and properties of composite particles were studied

    本論文以無機鹽（硝酸鋁、氧氯化鋯、三氯化鈦等）為原料，在石墨的稀懸浮液中應用非均勻成核技術，使水解產物（水合氧化物）沉積到微米級鱗片石墨表面，經洗滌、烘乾和熱處理制備出石墨氧化物復合粉體。
  7. Through investigating the sinter process of al2o3 and at composite, the sinter parameters of atio5 / al2o3 is obtained

    通過對鈦酸鋁與氧化鋁的燒結研究，進一步確定了鈦酸鋁氧化鋁梯度復合材料的燒結工藝制度。
  8. The influence of preparing conditions on aluminum titanate composing was inquired. by analyzing element content of alumina and titania source, arranging a stoichiometric dosage, and keeping the chemical homogeneity from sol to mixed ti - al oxide precursor, a high activity powder was prepared. after calcining the precursor powder at 1250 for 2h, aluminum titanate phase is formed

    本試驗通過準確測定起始物的ti 、 al含量，嚴格化學配比，採取適當措施將微尺度上的組成均勻性從溶膠一直保持到混合鋁鈦氧化物前驅體的生成，使該粉體具有高活性，將其在1250煅燒2h ，已合成出以鈦酸鋁為主晶相的產物，比文獻報道的鈦酸鋁相的最低生成溫度降低了50 。
  9. When the content of mgtiao5 is 10mol % and the composite is kept at the 1100 for loh, the decomposition rate of at is far below 9 % ; the density of sintered material at 1500 with additive m2t is about 10 percent higher than that of those without any additives

    當鈦酸鎂的含量為5mol時，鈦酸鋁在1100保溫10小時，其分解量要小於9 ；而且在1500燒結得到的燒結體緻密度比沒有引入添加劑高近10個百分點。
  10. In this dissertation, mgo5 is introduced to form solid solution to restrain the decomposition of at in high temperature. then at is mixed with the al2o3, forming gradient composite to raise the integral intensity of the material and not affecting the thermal properties. the experimental results show that the additive mgo5 can effectively restrain the decomposition of at and promote the sinter process, which enhances the density of at

    本文在充分分析本領域國內外研究現狀的基礎上，首先通過引入添加劑鈦酸鎂（ m2t ） ，使其與鈦酸鋁形成固溶體，以達到抑制鈦酸鋁中溫分解的目的；再通過與強度高、氣密性好的氧化鋁進行梯度復合來提高整體材料的強度並能彌補鈦酸鋁滲透性能差，同時對材料的低熱膨脹性能影響不大。
  11. If appropriate m2t is introduced, the composite can also obtain fine thermal properties. when the content of m2t is 10mol %, the thermal expansion coefficient is - 0. 45x10 - 6 /

    同時引入適量鈦酸鎂，鈦酸鋁燒結體的熱膨脹系數仍然很低，鈦酸鎂的含量為10mol時其熱膨脹系數為- 0 . 45 10 ~ （ - 6 ） 。
  12. Alumina titanate ceramics

    鈦酸鋁陶瓷
  13. Study on the aluminum titanate ceramics matrix composite reinforced by carbon fiber electroless plated

    化學鍍碳纖維增強鈦酸鋁基復合材料的研究
  14. Aluminium titanate ( at ) has many excellent properties such as low thermal expansion coefficient, thermal conduction coefficient, high melting point, endured corrosion and thermal resistance, so it is one of the best materials with low thermal expansion coefficient resisting high temperature

    鈦酸鋁由於具有接近於零的熱膨脹系數、低的導熱系數、高熔點、耐腐蝕和抗熱沖擊性能好等特點，是目前低膨脹材料中耐高溫性能最好的一種之一。
  15. Aluminium titanate ( al2tio5, at ) has many excellent properties such as low thermal expansion coefficient, thermal conduction coefficient, high melting point, endured corrosion and thermal resistance, so it is one of the best materials with low thermal expansion coefficient resisting high temperature

    鈦酸鋁（ al _ 2tio _ 5簡稱at ）因其具有接近於零的熱膨脹系數、低的導熱系數、高熔點、耐腐蝕和抗熱沖擊性能好等特點，是目前低熱膨脹材料中耐高溫性能最好的材料之一。
  16. Study on the preparation of al2tio5 gel via nonhydrolytic sol - gel route using alcohols as oxygen donor

    凝膠法制備鈦酸鋁凝膠的研究
  17. According to us, it is the first time that aluminum titanate with zero decomposition ratio was compounded by using single mgo additive

    據我們所知，這是首次在使用單一mgo添加劑的情況下制備出零分解率的鈦酸鋁。
  18. Based on the study of the abtio5 / al2o3 composite, the finite element method is use to relax residual thermal stresses and design the structure

    在此基礎上，採用有限元方法對鈦酸鋁氧化鋁梯度材料進行了熱應力緩和與結構設計。
  19. The main purpose of the study is to prepare aluminum titanate ( al2tio5 / at ) fine powder with good thermal stability. improving the thermal stability of aluminum titanate synthesized by using single mgo additive is emphasized

    本論文研究的主要目的是合成出具有良好熱穩定性的微細鈦酸鋁粉體，重在提高使用單一mgo添加劑穩定鈦酸鋁的能力。
  20. The value of these new discovers lies in that they supply a new considering basis for developing synthesizing technology of at with concurrent high thermal stability and strength and for researching thermal stability mechanism of at

    本研究獲得的這些新發現的價值在於，它們為發展兼容熱穩定性和強度的鈦酸鋁粉體的合成技術、研究鈦酸鋁的熱穩定性制約機理提供了新的考慮基點。
分享友人
分享到 Line

分享到臉書