銅量測量 的英文怎麼說
中文拼音 [tóngliángcèliáng]
銅量測量
英文
cuprometric surveys-
Methods for determination of beryllium in copper alloys
銅合金中的鈹含量測定方法Methods for chemical analysis of blister copper - determination of copper content
粗銅化學分析方法銅量的測定Blister copper - methods for sampling and determination of moisture content
粗銅錠.水分含量測定的取樣及測定方法Standard test method for determination of copper in anode and blister copper
測定陽極和粗銅中含銅量的標準測試方法Method for chemical analysis of constantan resistance alloy the electrolytic gravimetric method for the determination of copper content
康銅電阻合金化學分析方法電解重量法測定銅量Stress measurement of anqing coper mining
安慶銅礦地應力測量The results indicate the stress of copper interconnects generates in the metallization and the thermal stress caused by thermal mismatch during the damascene process is the main stress. the thermal stress distribution in copper interconnects has been simulated by the finite element analysis software with the different trench structures
對測量結果的分析得出金屬薄膜的淀積是造成銅互連線中應力的主要原因,熱應力在銅互連線應力中占較大比例,熱處理后銅互連線中應力減小。Determination of copper content - electrolytic grarmetric method
電解重量法測定銅量Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定:當r _ v 10 ~ 8時,製成100 100 4mm板材,用zc36型高阻儀測量;當r _ v 10 ~ 8時,用dt - 9205b型數字式萬用表測試試樣的體積電阻,為了減小接觸電阻對測試的影響,採用銀導電膠將銅片粘接在試樣的兩個端面上,靜置24小時,待銀導電膠凝固,試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。Industrial circulating cooling water - determination of undissolved material in acid, phosphorus, ferrum, aluminium, calcium, magnesium, zinc and copper for sludge and corrosion products
工業循環冷卻水污垢和腐蝕產物中酸不溶物磷鐵鋁鈣鎂鋅銅含量測定方法Method for chemical analysis of copperconcentrates for import and export - determination of copper content by iodometry
進出口銅精礦化學分析方法碘量法測定銅量Studies on the stress of copper interconnects include the stress measurement by xrd, computer simulation and observation the local stress distribution with snam
利用薄膜應力測試分佈儀和xrd測量硅基銅膜及銅互連線薄膜宏觀應力。Manganin gauge is a kind of special sensor which is mainly used to measure the ultra - high pressures generated by shock waves
錳銅計是一種特種傳感器,主要用於測量沖擊波產生的超高壓力。Method for chemical analysis of manganin and novokostant resistance alloy the electrolytic gravimetric method for the determination of copper content
錳銅和新康銅電阻合金化學分析方法電解重量法測定銅量Test method for copper number of paper and paperboard
紙和紙板銅含量測試方法The amount of free ions and labile complexes of copper has been determined and the apparent stable constants have been calculated in a proteose peptone medium by anodic stripping staircase voltammetry ( assv )
採用陽極階梯溶出伏安法,測定了蛋白腖細胞生長液中的易變形態銅,並獲得了總銅量中易變形態的摩爾分數以及易變形態的表觀穩定常數。It turns out that zinc, gallium, and copper are very difficult to measure precisely in the solar photosphere so our measurements of the sun may not be quite right
其結果是在太陽光球層中的鋅、鎵、銅恰好是很難測定的,那麼我們對太陽的測量方法可能不是很正確。Superconductivity - part 8 : ac loss measurements - total ac loss measurement of cu nb to composite superconducting wires exposed to a transverse alternating magnetic field by a pickup coil method
超導性.第8部分:交流電損耗測量.用拾波線圈法測量暴露于橫向交流磁場的銅鈮復合超導導線的交流電總損耗量Due to the release by the rarefaction wave from the rear of copper impactor, and with the measurement of the velocity at the interface of sample and window, the release path was detected
利用來自飛片后界面稀疏波對被測樣品卸載,測量了樣品窗口界面的粒子速度剖面,得到了無氧銅的卸載路徑。Neutron fluence measurement - part 5 : fast - neutron fluence determination with copper activation detectors
中子注量測量.第5部分:用銅活化探測器測定快中子注量分享友人