鋼的 的英文怎麼說

中文拼音 [gāngde]
鋼的 英文
steel
  • : 鋼名詞(鐵和碳的合金) steel
  • : 4次方是 The fourth power of 2 is direction
  1. Method of sulfuric acid test for stainless steels

    不銹鋼的硫酸試驗方法
  2. Method of copper sulfate - sulfuric acid test for stainless steels

    不銹鋼的硫酸-硫酸銅腐蝕試驗方法
  3. One of these alloys contained a high percentage of chromium.

    其中有一種合金鋼的含鉻量最高。
  4. Under kinds of conditions, these stresses, strains and their development of concrete, steel, and angle iron were shown. during the whole process, the rate of sharing the loading for the angle iron was also indicated

    給出了各種情況下混凝土、筋和角鋼的應力應變值及其發展變化情況;給出了各種情況下,角在加固過程中承擔荷載比率。
  5. There are three main operations in the heat treatment of steel: hardening, tempering and annealing.

    鋼的熱處理操作主要有三種,即:淬火,回火和退火。
  6. Development of high strength low - carbon bainite steel

    高強度低碳貝氏體鋼的試制
  7. Microstructure analysis of ultra low carbon bainite steel

    超低碳貝氏體鋼的顯微組織分析
  8. Granular bainite and properties of 12crni3 steel

    3鋼的粒狀貝氏體及性能
  9. Barnacle metallic and other inorganic coatings - electrochemical measurement of diffusible hydrogen in steels - barnacle electrode method

    金屬和其它無機塗層.鋼的可擴散氫電化測量.茗荷芥
  10. A furnace in which pig iron is converted into steel by the bessemer process

    熔爐一種通過酸性轉爐法將生鐵練成鋼的設備
  11. Reasons and preventing measures of breakout in slab caster

    連鑄板坯漏鋼的影響因素及防止措施
  12. Inhibition of thiourea to carbon steel in citric acid

    硫脲在檸檬酸中對碳鋼的緩蝕作用
  13. Inhibiting effect of mbt on carbon steel in citric acid solution

    對檸檬酸溶液中碳鋼的緩蝕行為
  14. High quality stainless pipe valve and seamless welded joint can ensure absolutely air conurbation and durability of pipe system

    高品質不銹鋼的管道閥門,無縫焊接連介面,以保證絕對氣體密閉性和管道系統耐用性。
  15. Cadmium plating of steels with specified tensile strength inferior or equal to 1450 mpa, copper, coper alloys and nickel alloys. aerospace series

    航空航天系列.規定拉伸強度小於或等於1450mpa銅銅合金和鎳合金鋼的鍍鎘
  16. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv強韌化機理,本文通過對不同淬火溫度,回火溫度,回火時間下力學性能指標對比及顯微分析,認為微合金元素細化晶粒,馬氏體回火分解,殘余奧氏體轉變,第二相沉澱析出共同決定了微合金鋼的強韌化情況,特別是由於微合金元素存在,其細化晶粒及其碳氮化物沉澱析出,導致鋼的良好強韌性,並且如果工藝滿足第二相沉澱析出強化大於回火馬氏體分解引起軟化效應,會在硬度曲線中產生明顯二次硬化現象。
  17. Uses : used as deoxidizer and alloying agents for smelting steel and used as pregnantagents and additives in cast irons

    用於煉鋼的脫氧劑和合金劑,鑄鐵中孕育劑和添加劑。
  18. Other chinese companies flocked to the european fire sale, stripping dortmund of its assets

    在邯鋼的帶動下,其它中國鐵公司紛紛涌進歐洲,剝離多特蒙德鐵廠資產。
  19. Eutectic carbide of steel - micrographic method using standard diagrams

    鋼的共晶碳化物不均勻度評定法
  20. And due to the heat expansile coefficient of the stainless steel rather high, the connecting force between the stainless steel pipe and the pipe coupling in the room temperature is much less than that between the titanium alloy pipe and the pipe coupling. the results accord with the tensile experiments well. finally, the dependence of dimensions of the coupling on the strength of the connector system is analyzed

    模型計算還表明,被接管材料和管接頭材料之間熱膨脹系數差異會造成管接頭系統室溫強度低於高溫強度;由於不銹鋼的熱膨脹系數較大,使得室溫下1不銹管與n立tinb形狀記憶合金管接頭間抱緊力遠小於鈦合金管與nitinb形狀記憶合金管接頭間抱緊力,成功地解釋了拉脫實驗中結果。
分享友人