錐形突 的英文怎麼說
中文拼音 [zhuīxíngtū]
錐形突
英文
conoid process-
Spikes 15 - 25cm long, single or paniculate, flowers white, dense ; calyx late - campanulate, 2mm long, 5 - toothed ; petals 5, oblong, 4mm long, slightly connate at base ; stamens 10, free ; slightly exserted ; ovary glabrous
穗狀花序長15 - 25厘米，單生或排成圓錐花序式，花白色，密集，花萼闊鐘狀，長2毫米，具5齒；花瓣5 ，長圓形，長4毫米，基部稍連合；雄蕊10枚，分離，略突出於花冠之外；子房無毛。Then, nogo - a expression was gradually enriched in the distal segment and growth cone of the putative axon which grew much faster than other neurites
神經元突起形成過程中， nogo a主要表達于樹突近端，在軸突上隨著軸突的伸長逐漸表達于軸突遠端和生長錐。( 3 ) the most principal factors that influence the supersonic atomization process include the flow ratio of the gas - liquid metal ( gmr ) value, the flow of atomizing of gas and the range of the inverse vortex taper. the more of the value of three factors, the more advantage they are for the atomization and the more fine the powders are. ( 4 ) the produced powders are the best in efficient atomization efficiency, particle diameter, particle shape and dispersion when the solder alloy is zhl63a, atomizing medium is n2, the protrusion h = 6. 0mm, atomizing gas pressure p = 100mpa, over - heat temperature t = 167 ( t = 350 )
研究結果表明： （ 1 ）超音速霧化器的氣體流場在導液管下端形成一個倒渦流錐，在二維空間上呈軸對稱的雙峰分佈，負壓形成於這個倒渦流錐內； （ 2 ）修正後的霧化氣體速度公式可以滿足超音速霧化的要求； （ 3 ）影響超音速霧化工藝最根本的因素有氣液質量流率比（ gmr ）的大小、霧化氣體流量和倒渦流錐范圍，三個因素的值越大，對形成細粉越有利； （ 4 ）在焊錫合金為zhl63a ，霧化介質微n _ 2 ，導液管突出高度取h = 6 . 0mm ，霧化氣體壓力取p = 1 . 0mpa ，合金過熱度取t = 167 （ t = 350 ）時，所制得的粉末在有效霧化率、顆粒球形度、粒度及其離散度三個方面綜合性能最好。
分享友人