鍵控檢波器 的英文怎麼說

中文拼音 [jiànkòngjiǎnbōqì]
鍵控檢波器 英文
keyed detector
  • 鍵 : 名詞1 [機械工程] （使軸與齒輪、皮帶輪等連接並固定在一起的零件） key 2 [書面語] （插門的金屬棍子）...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Then the paper analyzes control system of hybrid active power filter, the way of harmonic detecting and the principle of control system, digital low pass filter and the generation of pwm, on the base of which the paper designs a new parallel hybrid active power filter which is controlled by tms320lf2407, and detailedly introduces drive circuit of pwm, sampling circuit of current, voltage adjustment and protection circuit, communication circuit, liquid crystal display circuit

    分析了混合型有源濾波器的控制系統、諧波檢測方法及控制原理、數字低通濾波器和pwm信號的產生，在此基礎上設計了一種基於tms320lf2407為控制核心的並聯混合型有源電力濾波器硬體原理圖。並對pwm驅動電路、電流采樣電路、電壓調整、按鍵輸入和保護電路、通信模塊、液晶顯示模塊進行了較詳細的分析說明。
  2. On the basis of this, the control strategies for obtaining its reference voltage, one of pivotal technolog, are discussed. corresponding control circuits are designed, including the control strategies of detecting the source current and load voltage

    在此基礎上探討了串聯型有源電力濾波器的關鍵技術之一? ?獲得參考電壓的控制策略，包括檢測電源電流和檢測負載電壓兩種控制策略，並設計了相應的控制電路。
  3. In chapter four, the project techniques of harmonic filter and reactive power compensation for guixi smelter were firstly discussed ; based on the harmonic condition of guixi smelter, the key techniques of a new hybrid active power filter with high capacity for harmonic filter and reactive power compensation were proposed ; then the designs of main configuration, output filter, harmonic detection and analysis subsystem, and the controller based on dsp have been discussed. application results of the hybrid active power filter have confirmed the feasibility of the integrated compensation system

    第四章討論了貴冶電網諧波治理和無功補償的工程實現技術，介紹了貴冶電網諧波的現狀，分析了貴冶電網諧波超過國標的情況，提出了一種新型大功率混合型有源電力濾波器的應用方案，討論了系統主電路設計，輸出濾波器的設計，諧波檢測和分析子系統的設計，基於dsp數字晶元的控制器設計等關鍵技術，並給出了混合型有源電力濾波器投運后，改善電網諧波的情況，表明了論文中所給出的設計方案和工程實現技術獲得良好的工程應用效果。
  4. This thesis designs automobile braking performance inspecting and control system. this thesis consists of three main parts. something about automobile braking system design has been discussed in the first part according to the main requirement of gb7258 - 2004 《 the requirement for motor vehicle, running safely 》. the hardware has been designed according to the characteristic of the parameter afer establish the whole plan for inspecting it. and then working principle of each part has been introduced. and at last, we designed software depending on the require to inspection and function. we can educe the braking power of both wheels, braking moment retardarce power and other parameters. we designed sensor signal processing circuit which including power sensor signal processing circuit and speed signal measure circuit according to the require of designing parameter. ad620 is used as power sensor. in order to measure the power of the automobile braking and protect the electromotor. so we must measure both

    由汽車制動測試原理以及制動性參量檢測的技術指標可知，檢測數據準確性、控制可靠性、實時性和抗干擾能力是系統設計的關鍵。本文在掌握汽車性能檢測系統結構和原理的基礎上，根據國家有關標準和汽車制動性檢測系統的控制邏輯提出了採用單片機為控制器的總體方案，設計了各部分硬體電路，並根據所要實現的功能用c51語言設計了軟體。由於檢測現場存在各種干擾噪聲，為了保證系統運行的穩定性和可靠性以及測量精度的要求，分別從硬體和軟體的角度出發，介紹了常用的硬體抗干擾措施以及軟體數字濾波的原理和方法。
分享友人
分享到 Line

分享到臉書