鍵槽鍵槽 的英文怎麼說
中文拼音 [jiàncáojiàncáo]
鍵槽鍵槽
英文
key way-
Keyway broach with chamfer types and dimensions
帶倒角齒鍵槽拉刀型式與尺寸Bores and keyways for flexible couplings metric series
柔性耦合器的鏜孔和鍵槽Semi - circular woodruff keys - dimensions of cross sections and keyways
鍵和鍵槽的剖面尺寸Specification for metric keys and keyways - woodruff keys and keyways
米制鍵及鍵槽規范.第2部分:月牙鍵及鍵槽Mechanical transmissions. tangential keys and keyways. dimensions and tolerances
機械傳動.切向鍵和鍵槽.尺寸和公差Square and rectangular keys and keyways - width tolerances and deviations greater than basic size
方形和矩形鍵和鍵槽.寬度公差和大於基本尺寸的偏差Shipbuilding. shaft lines. keys and keyways for tapers on propeller - shafts. diameters 100 mm to 680 mm. alternative
造船工業.軸線.直徑為mm mm的螺旋槳軸上錐形體的鍵和鍵槽.可選擇的Taper keys - cross section dimensions of keys and keyways
鍵和鍵槽的剖面尺寸Parallel keys - dimensions of cross sections and keyways
鍵和鍵槽的剖面尺寸Square and rectangular keys and keyways
四方型和矩型鍵和鍵槽Thin flat keys - cross section dimensions and keyways
鍵和鍵槽的剖面尺寸Keys and keyways and taper pins - specification - keys and keyways
鍵和鍵槽及錐形銷.鍵和鍵槽規范Woodruff keys and keyseats
月牙鍵和鍵槽Woodruff keys and keyways
月牙鍵和鍵槽Square and rect keys and keyways : width tolerances and deviations greater than basic size
方頭和長方頭鍵和鍵槽:大於基本尺寸的寬度公差和偏差Woodruff keys keyways
半圓鍵和鍵槽Keys and keyways and taper pins - specification for solid and split taper pins for general engineering purposes
鍵和鍵槽及錐形銷.第3部分:一般工程用整體的和開口錐形銷規范Specification for metric keys and keyways - parallel and taper keys
米制鍵及鍵槽規范.第1部分:平鍵和錐形鍵1 10 conical shaft ends with or without parallel keys and keyways. short series. dimensions
帶或不帶平行鍵和鍵槽的錐形軸端.短系列.尺寸1 10 conical shaft ends with or without parallel keys and keyways normal longs series. dimensions
帶或不帶平行鍵和鍵槽的錐形軸端.通用長系列.尺寸分享友人