鏈路號 的英文怎麼說

中文拼音 [liànlùháo]
鏈路號 英文
link no
  • 鏈 : Ⅰ名詞1. （鏈子） chain Ⅱ動詞（用鏈栓住） chain; enchain Ⅲ量詞（計量海洋上距離的長度單位） cable length
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 鏈路 : chain circuit; periodic line; link; link circuit; path of chain
  1. Facilitating the configuration of protocol parameters, optimization of protocol operations, and more exact estimation of protocol performance, etc. basing on combinatorial theory and asymptotic method, we analyzed the properties of manets with nodes uniformly distributed in rectangular region. mathematical formulas of some basic properties of manets are obtained, such as the expected number of wireless links, mean node degree, the relation between network connectivity and radio range

    因此本文第二章基於組合學方法和極限思想研究了矩形區域內節點均勻分佈的無線自組網的幾項基本屬性，網路中鏈路總數的期望值，網路中節點度數分佈情況，以及網路連通性與無線信號傳輸半徑的關系等，得出了其解析描述。
  2. Simulation base on link level is the simulating of independence components of system, it is made use of simulating of signal transforming and processing, in order to analyses signal character, parameter and processing course in signal level, the result of simulation can provide very important reference for the design and evaluation of system

    鏈路級模擬是系統相對獨立組成部分的模擬，主要用於模擬通信信號的實際傳輸和處理過程，便於從信號層面分析研究通信信號的特徵、參數和處理情況，模擬的結果可為通信系統設計和評估提供極為重要的參考依據。
  3. However, while bringing us a lot of benefits, it raises requirements for network interworking. as is shown in figures 1 and 2, if the order of the 2 mbits time slots is inconsistent on the 155 mbits paths, disorder will take place when these paths are interconnected, thus making impossible the functioning of the point - to - point 2 mbits links. hence the unification of the arrangement of the time slots of 155 mbits signals throughout the network

    正像圖1 、圖2中所示開通交換機中繼電路的情況，如圖中155mbits通路2mbits時隙排列不統一，在互連時就會造成2mbits時隙混亂，難以開通點到點2mbits鏈路，因此全網155mbits信號時隙必須統一排列規則，才能保證業務的順利開通，方便網路的維護。
  4. Link forced uninhibitation signal lfu

    強制鏈路無禁止信號
  5. Link inhibit signal lin

    鏈路抑禁止信號
  6. Link remote inhibit test signal lrt

    鏈路遠禁止測試信號
  7. The mssr mode s technology, which was introduced firstly for the purpose of air tranfic control ( atc ) system, is based on the individually addressing and selective interrogation technology. the mode s can overcome many problems exist in mode a / c, such as signal interference, limited aircraft identification, garble and fruit, and provides the ability to build digital data link. many countries and organizations do them best to support researches about the communication, navigation and surveillance technology, which are all based on the mode s, and many productions have been adopted step by step by the international civil aviation organization ( icao ). so, to research the key technologies of mode s will contribute a lot to the development of domestic aviation system, especially for the air control system, identification friend foe and navigation system

    它建立在獨立編址、選擇性詢問的基礎之上，能夠解決在模式a / c中存在的信號干擾、有限的信息編碼、幻影（ garble ）和異步應答（ fruit ）等問題，同時在數據鏈路方面有著巨大的潛力。國際上，模式s的數據鏈技術得到了廣泛的關注，許多國家和組織大力支持基於模式s的通信、導航和監視技術以及航空管理新技術的研究，許多成果正逐步被國際民用航空組織（ icao ）所採用。因此，對模式s核心技術的深入研究對於我國在航空管理、敵我識別、導航等方面的發展有著重大的意義。
  8. Analysis of a forward link cdma signal spectral regrowth and adjacent - channel power ratio

    信號前向鏈路頻譜增生和鄰道功率比估計
  9. Link local inhibit test signal llt

    鏈路本地禁止測試信號
  10. Chongqing expressway networking toll data communication network cotains 2 - ring and 8 - ray network structure based on expressway physical structure, setting up a trasmission trunk layer of sdh stm - 4 ( can be up - graded to stm - 16 ), and channel protection business entry layer consisting of sdh onu / olt stm - 1 ( can be up - graded to stm - 4 ). data exchange layer, through ip route exchange network above sdh network, forms 3 - level computer network structure of account settlement center - road section management company - toll station. to ensure obtaining original and reliable toll data from communication network, 2m circuitous chain is established between each toll station, accountsettlement center and road section management company, and also pstn dialing backup chain is set up between toll station and account settlement center. in order to maintain clock synchronization of the whole communication network, a proposal of sub - stage clock sychrononization signal network for differet network construction scale has been put forward in this design. in view of sensitivity and importance of toll data, this design particularly gives considerations of network safety and information safety for external and internel of network. therefore, communication safety, smoothness and reliability of networking toll system can be able to maintained in many ways

    重慶高速公路聯網收費數據通信網的結構是根據高速公路的物理結構構築了2環8射的網狀結構，建立了以sdhstm - 4 （可升級到stm - 16 ）的傳輸主幹層，以sdhonu / oltstm - 1 （可升級到stm - 4 ）組成的通道保護業務接入層。數據的交換層是在sdh網之上的ip路由交換網，形成了結算中心-路段管理公司-收費站之間的3級計算機網路結構。為從通信網路上保證收費數據的原始性和可靠性，每個收費站和結算中心、路段管理公司之間建立了2m迂迴鏈路，同時在收費站和結算中心之間建立了pstn的撥號備份鏈路。
  11. This article takes hanging off and wide fluctuation of transmition velocity of adsl as example, then analysis centers on the discerte multiple tone and the principle of channel load assignation. from analysis above article points out the root of adsl being sensible of noise signal. at last, reserches effects that window function and barrier effect on frequency and adopts fft to work out the noise power of adsl

    本文以電信現在推出的adsl傳輸中鏈路經常掉線和傳輸速率經常大范圍波動為例，重點分析了adsl所使用的dmt調制方式和注水演算法分配通道載荷方式原理，由此指出adsl對噪聲信號敏感的根源，在得到問題的根源之後，分析了窗函數和柵欄效應對頻譜的影響，採用fft方法計算adsl線路的噪聲功率譜，為adsl線路測試提供了可靠的理論依據。
  12. The mobile no. 7 signaling network of 2 mbit s high speed signaling link

    高速信令鏈路架構移動通信七號信令網
  13. The return link is that the signal retransmitted from the user aircraft to relay satellite, then transmitted the signal to the earth station

    返回鏈路指用戶航天器經數據中繼衛星轉發信號，向地面站回傳航天信號。
  14. The inter - link of tdrss contained forward link and return link. the forward link is the signal retransmitted from earth station to relay satellite, then transmitted the tt & c to the user aircraft

    前向鏈路指地面站經數據中繼衛星轉發信號，向用戶航天器（包括成像偵察衛星、航天飛機與載人飛船等）發送跟蹤、遙測與控制指令。
  15. Based on chinese tracking and data relay satellite ( ctdrs ) in the future, the antenna pointing control and complex control theory of user satellite are studied deeply in this dissertation, which is funded by the improve item of dept. of astronautic engineering and mechanics ? “ the teaching demonstration of antenna pointing control system in tdrss ”. the main contents of this dissertation are consisted of the following parts : firstly, dynamics equation is derived using lagrange equation for user satellite, so as the kinetics equations of user satellite at the same time are expressed in the form with matrix differential equations that is suitable for attitude control system design and analysis

    本學位論文結合航空宇航科學與技術學科研究生教學基地實驗室建設項目「中繼系統星間鏈路天線指向控制系統教學與演示實驗」 ，以我國跟蹤與數據中繼衛星系統為背景，對某型號用戶星星間鏈路天線指向跟蹤控制和復合控制理論進行深入的研究，研究內容主要包括以下幾個方面: 1 .利用lagrange方程建立了用戶星的動力學方程，同時推導了運動學方程，並將這組動力學方程以矩陣微分方程形式表示，使之適用於姿態控制系統的設計和分析。
  16. First, the structure of the second generation ctdrs isl was discussed in this paper, the characteristic of coverage in the second generation ctdrs by the characteristic of orbit and the simulation model of isl was analyzed then the effect of the isl establishing process analyzed. second, the discussing and analyzing focus on the characteristic of signal during the establishing isl process, establishing the orbit model, the technology of doppler frequency shift capturing and tracking sequence and the effect of background noise, then the theory analyzing the parameters we have just mentioned, and this will support the reference for the implement of project. the simulation and test of the isl of ctdrs and analyzing from theoretical basis to implement of simulation were mainly focused in this paper

    其中討論了二代中繼星捕獲跟蹤系統星間鏈路的模擬方案的組成結構，利用軌道特性對二代中繼衛星系統的覆蓋特性進行分析，搭建了星間鏈路的模擬模型，其中包括中繼衛星和用戶衛星在內的軌道模型、星間鏈路模型、用戶星信號調制模型等，並對星間鏈路建立過程的影響進行分析;重點針對星間鏈路建立過程的信號特性，軌道模塊的建立、多普勒頻移技術、背景噪聲影響、載波的捕獲與跟蹤技術等進行了實際參數的設計與理論分析。
  17. What is more, i have implemented two profiles ( lap and dunp ) that enable one pc to access lan or dial up internet wirelessly by making another pc as access point, which is connected to lan or modem as usual

    並且利用lap和dunp兩個profile實現了通過讓一臺pc作為數據接入點（以傳統方式接入局域網或連接modem撥號） ，而另一臺pc通過藍牙無線鏈路與數據接入點建立連接從而實現無線地接入訪問局域網利撥號上網。
  18. Its main function is to amplify and transmit the upconvertor ' s signal. it is applied to various kinds of ground equipment and satellite transponder. there was captured by foreign brand basically in the market of mobile communications in our country

    眾所周知，功率放大器模塊是微波通信發射機的重要組成部分，它完成對上行鏈路信號的放大發射功能，廣泛的應用於各種地面設備和衛星轉發器中。
  19. The technology of direct sequence spread spectrum / code division multipul access ( dsss / cdma ) are applied in the broadband code division multiplex wireless communication systems, which means transmitting data at the rate of 2. 048mbps using four e1 lines within the band of 20mhz. in this paper, the theory of the whole debice is first analysized specified for the system asic design and optimizing its performance

    寬帶碼分復用無線傳輸系統是採用直接序列擴頻/碼分多址（ dsss / cdma ）技術，在20mhz頻帶內實現四路2 . 048mbps的e1鏈路數據速率的無線傳輸。本文首先分析了整個數傳設備實現原理，針對系統asic設計和優化整機集成性能出發，提出並實現了基於fpga控制pm4314e1晶元的介面模塊完成對e1鏈路信號的監控和告警功能的改進方案。
  20. Acknowledge link number

    確認鏈路號
分享友人
分享到 Line

分享到臉書