鏡面反射層 的英文怎麼說

中文拼音 [jìngmiànfǎnshècéng]
鏡面反射層 英文
mirror-like film
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 鏡面 : minute surface; mirror face; mirror plane; mirror plate; mirror surface鏡面反射 [物理學] direct r...
  1. The prototype is made by a concave sphere primary and a plane secondary deposited the mo / si multilayer on the fused quartz substrates. the reflectivity peak and the reflectivity uniformity of the multilayer mirrors are respectively 25 % and around + 2. 5 % at 17. 1nm

    望遠鏡主鏡為球面，次鏡為平面，所用反射鏡為在熔石英基底上鍍制mo si多層膜的euv波段反射鏡，在17 . 1nm的反射率25 ，反射率的均勻性2 . 5 。
  2. Therefore, in principle the scattering may be predicted from measurements of the surface profile. in this paper the author also discussed nonspecular scattering for mo / si multlayer coated primary and secondary mirrors of the measured schwarzschlid optics based on power spectral density of these mirrors measured by both optical profilometer ( wyko ) and atomic force microscopy ( afm )

    因此，我們可以通過檢測多層膜反射鏡基底的粗糙度來表徵多層膜反射鏡非鏡面散射對光學系統性能的影響，亦即通過檢測多層膜反射鏡基底的粗糙度調整拋光工藝參數，獲得低散射的多層膜反射鏡。
  3. According to high tech mirror surface technology principle, floorsurface layer pellet thin, causes its varnish like mirror, the smoothfinish to be extremely high, achieves the regular reflection theeffect

    根據高科技鏡面技術原理，將地板表層顆粒細化，使其表面光澤如鏡，光潔度非常高，達到鏡面反射的效果。
  4. Indium stannum oxide ( ito ) as semiconductor have caused a great deal of interest due to their prominent electro - optical behavior. ito has high prominent transmittance, high infrared reflectance, good electrical conductivity, ito applied as gas sensors, photovoltaic devices, heat reflecting mirrors, solar cells, flat panel displays, liquid crystal displays, electroluminescent, devices and organic light - emitting diodes ( oled ) etc. although preparations and applications of ito films have been studied deeply. nano - ito composites hardly studied

    氧化銦錫（ ito ）是一種高簡並的n型半導體，由於具有導電性，可見光高透過率，紅外反射性，穩定的化學性，被廣泛應用於熱反射建築玻璃、抗靜電塗層，太陽能電池，熱發射鏡，平板顯示器和液晶顯示屏，傳感器，有機光致二級管（ oled ）等方面，國內外對高質量的ito薄膜的制備和應用進行了深入的研究，但是很少有ito納米粒子與高分子材料復合的報道。
  5. The complete scene should be composed of a specular pass, a diffuse pass and an ambient pass

    一個完整的場景應該包括鏡面反射（高光）層，本色層和環境層。
  6. Aluminium and aluminium alloys - anodizing - measurement of specular reflectance and specular gloss of anodic oxidation coatings at angles of 20, 45, 60, and 85

    鋁和鋁合金.陽極氧化. 20 45 60和85角的陽極氧化覆層的鏡面反射系數和鏡面光澤度的測量
  7. In this paper, micro - cavity semiconductor laser ( mcsl ) with pillar vertical - cavity surface - emitting structure ( vcsel ) which has potential applications in optical communication and optical interconnect is theoretically analyzed, the calculation model that used to discuss the modal performance of rectangular columnar and cylinder vcsel with oxidized aperture is established by using vector field model. the numerical simulations in the case of cylinder structure show oscillating wavelength and threshold gain against inside and outside radius of laser, the layer refractive index and pair number of bragg mirror, thickness, position and oxidized material ' s refractive index of oxidized aperture, in detail. more practically, considering dos shell of laser as non - perfect one, or supposing that dos shell is separated from the laser, we can obtain more significative results

    本工作以矢量場模型出發，對具有誘人應用前景的柱形垂直腔面發射結構（ vcsel ）的微腔半導體激光器（ mcsl ）進行了理論分析，建立了用於分析方柱形和圓柱形結構具有氧化孔徑層的激光器的模式特性的理論模型；對圓柱形結構情況進行了數值模擬，得到了振蕩波長、閾值增益隨激光器內外半徑、 bragg反射鏡層折射率、周期數以及氧化孔徑層厚度、位置和氧化物折射率的詳細變化規律；為使理論計算更接近實際，將外加金屬包殼視為非理想導體，或將金屬包殼與激光器結構隔開，分別對這兩種情況下的結果進行了討論。
  8. Microstructure of the composite layer was analyzed with help of optical microscope, scanning electronic microscope ( sem ), electronic probe microanalysis ( epma ) and x - ray diffraction ( xrd ). the compacting of the billet and the forming mechanism of the carbide reinforcement were studied based on thermodynamics and kinetics of reaction, sintering theory and the result of dta. at the same time, the wear - resistance of the composite layer was studied under condition of dry sliding friction

    利用光學顯微鏡、掃描電子顯微鏡、電子探針以及x -射線衍射儀，分析了表面復合層的基體組織結構；運用反應熱力學、動力學、粉末燒結理論和燃燒合成理論，結合差熱分析結果，探討了表面復合層壓坯的燒結緻密化原理和碳化物增強相的形成機理；利用坯塊在真空燒結爐不同溫度下的燒結出來的顯微組織分析，模擬出坯塊的燒結過程中的化學反應過程。
  9. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它的研究，往往只考慮棱鏡膠合層的兩切割斜面上的主透射光束，至多同時考慮次級透射光束對出射光強的影響，或直接將光束光強透射比的實驗值的平均結果作為棱鏡的一個性能指標給出，很少考慮棱鏡膠合層間光束的多次反射對輸出光強的影響以及結構誤差和使用調整誤差對棱鏡光強分佈的影響。
  10. Aluminium and aluminium alloys - anodizing - part 11 : measurement of specular reflectance and specular gloss of anodic oxidation coatings at angles of 20 o, 45 o, 60 o or 85 o

    鋁和鋁合金.陽極化.第11部分:以20度45度60度或85度角度測定陽極氧化層的鏡面反射率和鏡面光澤
  11. The solution is to have a mirror coating on the chip reflect two of the beams [ see box on opposite page ]

    解決的方式是在晶片表面鍍上一層鏡面，以反射其中兩道光束（參見87頁降溫大法） 。
  12. After that, using the simulated annealing optimizing method, the structure parameters were optimized and good results were gained. finally, the scattering theory of d. stearns, which is applible to soft x - ray region, is applied to the scattering study of rough interface of soft x ray multilayer mirrors

    之後將適用於軟x射線波段的d . stearns的散射理論應用於軟x射線多層膜反射鏡的粗糙界面的散射研究，並基於該理論提出了一種多層膜反射鏡的修改設計方法。
分享友人
分享到 Line

分享到臉書