長絲數量 的英文怎麼說

中文拼音 [zhǎngsīshǔliáng]
長絲數量 英文
number of filaments
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 數量 : quantity; quantum; amount; magnitude; number
  1. Wetting-force data on filaments of any diameter and shape can easily obtained.

    各種直徑和形狀的長絲的潤濕力數據是易於測量的。
  2. Therefore, because the number of samples is less, but in order to successfully get orders, the printing surface treatment ( signs nameplate, etc. ) can not be lax, the usual choice of either silk screen, and pad printing or thermal transfer, but for a small number of sample products or the case is a long life cycle, cost, efficiency in my company ' s products, printing effects, the cost has obvious advantages

    因為是樣品所以數量少，但為了順利拿到定單，表面的印刷處理（標志、銘牌等）又不能馬虎，通常的選擇不外乎絲印、移印或熱轉印，但針對樣品或少量產品而言則周期長、成本高，我公司產品在效率、印刷效果、成本方面具有明顯優勢。
  3. Usually the number of holes in the spinneret determines the number of filament in the yarn.

    一般噴絲頭細孔的數量決定了紗中長絲的根數。
  4. A reliability experiment of thermal aging was carried out for the two types of joints, scanning electron microscopy, energy dispersive x - ray spectrometer and micro x - ray diffractomer were adopted to investigate the interfacial evolution behavior of joints, and kinetics model of imc formation was established. the results show that imc growth follows the parabolic law as a function of aging time at certain aging temperature, imc growth is more sensitive to the aging temperature than the aging time, the activation energy of cu - al imc growth is 97. 1kj / mol and the major forming cu - al imc are cual2 and cu9al4, the activation energy of au - al imc growth is 40. 1kj / mol and the main au - al imc are au4al and au5al2, with au2al and aual at the interfacial periphery of joints, the rate of cu - al imc growth is about 1000 times slower than that of au - al imc, and kirkendall voids and cracks are easily appeared during thermal aging in gold ball bonds while voids and cracks are absent in copper ball bonds even after aging at 200 for 2900 hours and 250 for 169 hours

    研究結果表明:金屬間化合物厚度與老化時間的關系符合拋物線法則，金屬間化合物的生長對老化溫度比老化時間更加敏感; cu - al金屬間化合物生長的激活能為97 . 1kj / mol ，老化后金屬間化合物呈層狀分佈，主要相為cual2和cu9al4 ; au - al金屬間化合物生長的激活能為40 . 1kj / mol ，主要相為au4al和au5al2 ，同時在界面周邊區域生成了au2al和aual ;老化過程中cu - al金屬間化合物生長速率比au - al金屬間化合物生長速率小103數量級;金絲球鍵合點200老化96小時出現了明顯的kirkendall空洞和裂紋，但銅絲球鍵合點200老化2900小時和250老化169小時都沒有形成空洞和裂紋。
  5. Because of flexible object of wire rope, it is inevitable to produce elastic spread under the load, the value of critical parameter - elastic modulus relates to the precision and safety in designing of machinery

    鋼絲繩屬撓性體，負荷時不可避免出現彈性伸長，其關鍵參數彈性模量的取值問題關繫到機械設計的精度與安全性。
  6. Secondly, calculation theory of construction for suspension bridge is presented under the ideal condition of dead load design. linetype change stiffness of cable and slip stiffness of supporting points are deduced based on segmental catenary theory. then numerical analysis method through sgkz2000 software are introduced in detail about calculating design linetype for suspension bridge, unstressed length of cable, erection linetype of cable and pre - displacement of saddle without loads, erection linetype of wire strands, the fixed position for erecting cable band and linetype of lifting stiffening girders

    其次，根據懸索橋恆載設計理想狀態建立了懸索橋施工計算原理；以分段懸鏈線索理論為基礎，推導了懸索的線形變化剛度和懸索支點的滑移剛度；介紹了懸索橋成橋設計線形計算、吊索無應力長度計算、空纜線形與預偏量計算、絲股架設線形計算、索夾安裝位置計算和加勁梁吊裝線形計算的具體方法、數值演算法及軟體sgkz2000的計算模塊的實現。
  7. Based on the principle of michelson interference a new integrative experiment apparatus to measure linear expansion coefficient and yang ' s modulus of metals is designed and manufactured primarily

    摘要在邁克耳孫干涉原理的兩條干涉光路中，分別設置可以精確測量金屬絲的拉伸長度和金屬棒熱膨脹伸長量的裝置，從而設計出一種可以分別測量金屬楊氏模量和線脹系數的新型綜合實驗儀器。
  8. In the laboratory experiment part, human peripheral blood, cultured cells and icr mice were study objects. the changes of mitotic chromosome numbers were measured by human metaphase chromosome counts and statistic analyzed used x2 - test. the changes of meiotic chromosome numbers were measured by mice one - cell zygote chromosome counts and statistic analyzed usedx2 - test. the effects of low dose ionizing radiation on the expression of topoisomerase ii were measured by immunocytochemistry, western blot and rt - pcr

    流行病學結果顯示長期小劑量輻射接觸與染色體不分離呈正相關，為進一步在細胞遺傳學和分子生物學方面研究小劑量電離輻射與染色體不分離關系及其機制，本課題第二部分以外周血、培養細胞、 icr小鼠為研究對象，用外周血染色體計數和單細胞受精卵染色體計數的方法研究小劑量輻射和拓撲異構酶復旦大學2000級博士生學位論文11a抑制劑及其二者的協同效應對有絲分裂和減數分裂染色體不分離的影響，用免疫細胞化學染色、 westernblot 、 rt pcr等方法研究了電離輻射引起拓撲異構酶a表達變化。
  9. The expression of topoisomerase ii of cultured cells treated low dose ionizing radiation decreased and then returned as time went. and become outstanding as radiation dose and frequency were added. inhibitor of topoisomerase ii could cause chromosome non - dis juction in mitosis and meiosis. and the co - effect of inhibitor of topoisomerase ii and ion

    05 ） ，具有隨照射次數增加而增加的趨勢；小劑量電離輻射可以引起拓撲異構酶a表達變化，隨照射后時間延長先下降后回升，隨照射劑量和次數的增加，變化更加明顯；拓撲異構酶11a抑制劑可引起有絲分裂和減數分裂時染色體的不分離；拓撲異構酶a抑制劑和電高輻射的協同作用使染色體不分離更加明顯。
  10. In consideration of a design plan for intelligent measuring of tubing string length, a mathematical model is established to conduct the measuring based on eulers fomula and the characters of bearing force and deformation of wire rope in the lifting system

    針對油管柱長度智能計量的設計方案，以歐拉公式為基礎，依據起升系統中鋼絲繩的受力特點及變形，推導出適用於油管柱長度智能計量的數學模型。
  11. It adopts pc computer control, the high accuracy force value sensing test system, step - motor direct driving ball threaded screw methods it may set arbitrary numbers for the parameters such as gripped sample length stress rate, test times etc. the testing results would be output in forms of chinese characters reporting statistics through the printer

    採用pc機控制，高精度力值傳感測量系統及步進電機直接驅動滾珠絲桿方式.對夾持試樣長度.拉伸速度.實驗次數等參數均能任意設定.測試結果由印表機輸出
  12. It adopts pc computer control, the high accuracy force # 118alue sensing test system, step - motor direct driving ball threaded screw methods it may set arbitrary numbers for the parameters such as gripped sample length stress rate, test times etc. the testing results would be output in forms of chinese characters reporting statistics through the printer

    採用pc機控制，高精度力值傳感測量系統及步進電機直接驅動滾珠絲桿方式.對夾持試樣長度.拉伸速度.實驗次數等參數均能任意設定.測試結果由印表機輸出
  13. The spinning conditions include spinning methods, the pressure and types of filling liquid, the pes concentration, the molecular weight of pvp and peg and the coagulation length in the first coagulation bam

    紡制條件包括:紡絲方法、填充液的壓力和種類、聚醚礬質量分數、聚乙烯毗咯烷酮的相對分子質量、聚乙二醇的相對分子質量以及在第一凝固浴中的凝固長度等。
  14. A mathematic model is established by adopting orthogonal polynomial regression method to study the effects of temperature on hypha growth rate, development, and stroma differentiation, growth, and yield of cordyceps militaris

    為了實現蛹蟲草的工廠化生產，採用正交多項式回歸分析法構建數學模型，揭示了溫度對蛹蟲草菌絲生長速率、菌絲長勢、菌絲轉色、子座分化、子座生長及產量的影響規律。
  15. In order to improve the antistatic performance of synthetic fabrics and analyze influence of the stainless steel mass fraction, the distribution and the shape in fabrics on antistatic performance of knitted fabrics, the blended yarn of stainless steel staple with cotton and the wrapped yarn of stainless steel filament with acrylic were made, then various stainless steel / acrylic mixed knitted fabrics which have different stainless steel mass fractions and distributions were designed

    摘要為改善合成纖維織物的抗靜電性能，分析不銹鋼質量分數及分佈對織物抗靜電性能的影響，研製了不銹鋼纖維棉混紡紗和不銹鋼長絲腈綸包纏紗，並設計了多種不銹鋼纖維質量分數和分佈形式的針織物。
  16. The fabrics containing much stainless steel fiber, distributing evenly and using stainless steel filament, had excellent antistatic performance

    不銹鋼纖維質量分數增加、均勻分佈、採用不銹鋼長絲具有更好的抗靜電性能。
  17. Based on theory analysis and lots of experiment data, converting relation of symmetrical elongation and breaking elongation of testing steel bars have been tropical and the reference to consolidating ductility is provided. at last, in this paper consolidating steel bar ' s ductility by comparing to stress - strain curves of steel bars and is assessed

    在理論分析基礎上結合大量試驗數據，回歸出各類試驗鋼筋均勻伸長率_ （ gt ）與斷后伸長率_ 5 （ _ （ 10 ） 、 _ （ 100 ） ）的折算關系，為統一延性評定指標提供參考，進一步比較鋼筋應力?應變曲線和_ （ gt ）值，最終統一評定我國混凝土結構用鋼筋（絲）的延性性能。
分享友人
分享到 Line

分享到臉書