閉合電流 的英文怎麼說

中文拼音 [bìgědiànliú]
閉合電流 英文
closed path
  • 閉 : Ⅰ動詞1. （關; 合） close; shut 2. （堵塞不通） block up; obstruct; stop up Ⅱ名詞（姓氏） a surname
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 閉合 : close; shutting; synizesis; synezesis; occlusio; closure; make; occlus-; occluso-
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. In order for there to be an induced current, we must have a closed circuit.

    為了出現感生電流，我們必須有閉合迴路。
  2. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  3. The controller includes two control loops which are outer speed loop ( variable parameter pi adjustment ) and inner current loop ( single - chop current delta - control ). in order to improve system performances, design of digital control system based on dsp is presented. the proportional parameter and integral parameter can be obtained through the design

    整個系統採用變pi參數轉速調節（外環）與單斬電流滯環調節（內環）相結合的雙閉環控制方式，為了得到既快速又穩定的恆速系統，本文還給出了基於dsp的雙凸極永磁電機數字控制系統的設計方案，通過此設計方案可以得到轉速環的比例參數kp和積分參數ki的參考值。
  4. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  5. Under operation system of dos and windows, control software is developed respectively. the wave of voltage and current as the ac contactors switch - on and switch - off is displayed dynamically, which make the equipment not only used as general electric life test instrument, but can apply test date for contactor study

    在控制軟體方面，分別完成dos平臺和windows平臺控制軟體設計，實現了交流接觸器觸點閉合與斷開時刻電壓、電流波形動態顯示功能，使該裝置不僅能作為交流接觸器常規電壽命試驗裝置，還對接觸器觸點的研究提供必要的試驗數據。
  6. The design of high - voltage circuit based on pwm technology is briefly described. the closed - loop current control theory using analog instruments is fully discussed, followed which is that using digital instruments. it is an important part that the hardware and software design of the single chip - two arms and two chips - two arms current control circuits with a new chip applicable to digital current control system

    簡單介紹了基於開關電源技術的高壓電路設計；詳細講述了模擬穩流電源的閉環穩流原理，並在此基礎上討論了利用數字電路實現穩流的原理及可能性；選擇出適合數字穩流系統的新型晶元，完成了單片雙路穩流系統、雙片雙路穩流系統的軟硬體設計；給出了一種簡單易實現的比例?積分控製程序。
  7. Main functions : 3 - stage complex - voltage blocked overcurrent protection, 3 - stage zero - sequence overcurrent protection, clearance discharging zero - sequence overcurrent protection, zero - sequence overvoltage protection, overvoltage alarming, overload alarming, fan start stop, tap changer blocking, pt wire broken blocking and alarming, etc

    其保護配置：復合電壓閉鎖過流段保護，零序過流段保護，間隙放電零序過流保護，零序過壓保護。
  8. This paper firstly explains the significance of researching the continuous enclosure type isolated - phase bus and analyzes the situations in nation and abroad. it presents the calculating method of the structure designing for the continuous enclosure type isolated - phase bus. at the same time, according to the theory, it provides the calculating programs for defining the dimensions of the bus

    本文首先闡述了研究全連離相封閉母線的重要意義，並結合國內外的現狀進行了分析，提出了全連離相封閉母線的結構設計方法，依據理論計算編制了全連離相封閉母線的截面尺寸的計算程序，可以方便快捷地進行各電壓及電流等級全連離相封閉母線的設計計算。
  9. We introduce in detail the circuit current and voltage when the relay is switch - on and switch - off, and make the software in dos and windows. the equipment can dynamic shows the wave of the current and voltage when the relay is switch - on and switch - off

    在檢測方面，分別完成了dos和windows平臺控制軟體設計，實現了繼電器觸點閉合與打開時的電壓、電流波形的動態顯示功能。
  10. It is composed of magnetic pulse sensor and control components, and is a built - in part inside distributor. it detects engine cranking position signal and cylinder signal via sensor, followed by treatment by control unit, thus controlling the on off of the current of control ignition coil to achieve the purpose of ignition. it has a function of auto closing regulation

    該型產品是為微車無觸點點火系統而研發的，它由磁脈沖傳感器和控制組件構成，內置於分電器內，通過傳感器檢測發動機曲軸位置信號汽缸信號，然後經控制組件處理，控制點火線圈中電流的通斷，從而達到點火目的，具有閉合角自動調整等功能。
  11. It is composed of magnetic pulse sensor and control components, and is a built - in part inside distributor. it detects engine cranking position signal and cylinder signal via sensor, followed by treatment by control unit, thus controlling the onoff of the current of control ignition coil to achieve the purpose of ignition. it has a function of auto closing regulation

    該型產品是為微車無觸點點火系統而研發的，它由磁脈沖傳感器和控制組件構成，內置於分電器內，通過傳感器檢測發動機曲軸位置信號、汽缸信號，然後經控制組件處理，控制點火線圈中電流的通斷，從而達到點火目的，具有閉合角自動調整等功能。
  12. We design inversion control circuit with cmos figure pll cd4046 act as core and microprocessor 80c196kc act as assistant controller. adopting a control method that combine fuzzy controller and pll control, improve induction heating power succeed in startup. adopting electric current voltage pair closed loop feedback design, with trough route capacitance voltage and trough route electric current act as pair closed loop feedback signal, guarantee induction heating power output accuracy

    並對系統主電路的元器件參數進行了詳細的計算；設計了以cmos數字鎖相環cd4046為核心、以80c196kc作為輔助控制器的逆變控制電路；採用了模糊邏輯與鎖相環相結合的控制技術，提高了電源的啟動成功率；採用電流、電壓雙閉環反饋方案，採用槽路電容電壓和槽路電流作為反饋信號，從而保證了電源功率的輸出精度。
  13. Exhibits include " the giant motor ", " the principle behind the motor ", and " making a magnet rotate by using electric current ", " the generator produces electricity " and " the magnet within the coil ". getting to grips with electric current exhibit include " when the current flows, things heat up ! ",

    展品包括電流通過時會產生熱電流通過時會產生磁場電流通過時會造成電解電路必須閉合，才有電流通過電路是導電體，才有電流通過電器接上電池，才有電流通過及小心短路
  14. The design of excitation power source based on principle of three phase step motor and pulse width modulation ( pwm ) technology, intelligent power model ( ipm ) is used for inverter switches, the output ac pulse used as excitation signals. the speed of rotation and magnetic intensity can be changed by regulate the exciting converted frequency and magnitude of exciting current. constant current is achieved by closed loop feed back

    勵磁電源結合步進電機原理與脈寬調制技術，選用智能功率模塊ipm作為逆變開關器件，輸出交流脈沖勵磁信號，以調節勵磁轉換頻率和勵磁電流大小為手段，實現對磁場旋轉頻率和磁場強度大小的有效調節，並通過閉環反饋實現閉環恆流控制。
  15. The type to current transformer is epoxy and silicone rubber insulation. it is fully enclosed and posttype. the terminal of the secondary is sealed tight. the silicone rubber outer cover has excellent ability to anti ? pollution

    本型電流互感器採用環氧樹脂和硅橡膠復合絕緣的全封閉支柱式結構，二次出線端封閉嚴密，尤其是硅橡膠外套，防污性能優異。
  16. These tubes have a thickness not exceeding 15mm because of skin effect. the connection between transformer and cables can include the closing of the transformer delta, and its layout wil aim at optimising and balanching the circuit reactance

    因集膚效應，管厚要求不超過15毫米.變壓器和電纜的連接可形成一個三角形的閉合形變壓器，這種設計旨在優化和分流電抗
  17. Specification for electrically operated automatic gas shut - off valves fitted with throughput adjusters, proof of closure switches, closed position indicator switches or gas flow control

    裝有流量調節器閉路開關檢驗閉合位置指示開關或氣流量控制器電動式氣體自動關閉閥規范
  18. Based on the analysis, we gave an example to study the dynamic contact with friction of the intermittent joint, and got some essential rules : the friction coefficient could n ' t influence the distributing of dynamic stress on the contact surface, and the roading rates affected evidently on the dynamic characteristic on the contact surface. in the last part, this paper made respectively use of the time - history method and the response spectrum method to analyze the dynamic response of the rock slope on baise hydraulic power plant, and got the coincident resultant. simultaneously, the contact theory was applied to study the stability of the intermittent joints

    基於上述的接觸理論和接觸分析結果，本文在最後一部分中分別利用動力時程法和反應譜法對百色水電站尾水渠的巖質邊坡進行動力響應分析，兩者計算方法得出比較一致的結果，同時採用動力摩擦接觸理論重點分析了斷層對于邊坡的穩定影響，認為斷層的存在會使得巖坡的穩定性降低，在地震等動力荷載的作用下對于斷層將發生張開、閉合和錯動現象，尤其是動力荷載和其他荷載如滲流力等的耦合作用將會對斷層產生極為不利的後果，進而影響巖坡的整體動力穩定，應該要引起足夠的重視。
  19. In the other device, intelligent hybrid dc contactor, igbt is creatively used to transfer current during breaking and closing, thus eliminating the arcing effect

    該接觸器首次應用電力電子器件igbt來完成直流接觸器在閉合和分斷時的電流轉移，實現直流接觸器的無弧運行。
  20. When the closed circuit is broken at any point - that is, when the path of conducting material is interrupted - there will be no current

    當閉合電路在任一點上斷開，也就是說，當導電材料的通路中斷時，就不會有電流。
分享友人
分享到 Line

分享到臉書