閉環系統函數 的英文怎麼說

中文拼音 [huántǒnghánshǔ]
閉環系統函數 英文
closed-loosystem function
  • : Ⅰ動詞1. (關; 合) close; shut 2. (堵塞不通) block up; obstruct; stop up Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • : 名詞1. [書面語] (匣; 封套) case; envelope 2. (信件) letter 3. (姓氏) a surname
  • : 數副詞(屢次) frequently; repeatedly
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  • 函數 : [數學] function函數計算機 function computer; 函數計算器 function calculator; 函數運算 functional operation
  1. The method can eliminate the conventional fuzzy control system ' s steady - state errors and flutters. and, the method of forward feed control is used to reduce the tracing errors during glide slope phase

    在此基礎上,採用帶優化修正無量化的模糊控制方法,設計飛機的微波著陸控制,並進行了模擬。
  2. With the generalized algebraic riccati inequality ( gari ) approach, a sufficient and necessary condition for the existence of dynamic output feedback h controllers is presented, such that the resulting closed - loop sy stem is admissible with its transfer function satisfying h norm constraint

    利用廣義代riccati不等式,給出離散廣義存在正常動態輸出反饋h控制器,使得是容許的且其從外界干擾輸入到受控輸出的傳遞矩陣具有h范約束的充分必要條件。
  3. A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method

    提出一種基於遺傳演算法的直流雙調速優化設計方法.根據工程技術的要求,選用速度超調量和過渡時間作為參優化性能指標.將該指標用模糊隸屬度歸一化,再加權平均形成優化模型的目標.採用計算機值計算方法,通過模擬獲得對應參的動態響應曲線及其性能指標.最後以工程設計的參為搜索范圍,以速度調節器和電流調節器的參為染色體中的基因,通過遺傳演算法在搜索范圍中優化這些基因,獲得優化解.實驗結果表明,所設計的參能使性能指標有顯著提高
  4. Switch states of mc are obtained when the output voltage error function is minimized, thus the optimum combination of switch states is derived for the closed - loop control of mc

    根據最小誤差確定矩陣變換器開關模式,實現了控制時開關狀態的優化組合。
  5. And so on, the mathematical model and transfer function of the tracking system are built, and the feasibility of the tracking control system design is demonstrated. furthermore, the static error of the system with a unit incline input is deduced. a majority of model of unit is based on analytics, so the general model can apply to other optical intersatellite communications systems

    在此基礎上,將atp跟蹤控制子視為線性定常,通過解析法和實驗法對子的各個控制節的單元器件進行合理建模,得出整個路總的開傳遞,論證了本課題所設計的atp跟蹤控制路的可行性及其視軸輸入為斜坡信號時的理論穩態誤差。
  6. Besides the design of the hardware construction for shape meter, the software system written in visual basic 6. 0 is also developed. the real - time data acquisition and conversion system worked in interrupt mode is accomplished by means of loading dynamic linkage library of pcl - 812pg enhanced multi - lab card. the converted data processing will be operated then, for example, scale operation, comparison, graphic display, data storage, etc. the adjusting values for the shape control are also calculated in it

    本文在參考大量帶材標準板形、軋制初始量設定、調節量計算研究的基礎上,確定了標準板形模型、設定模型、調節控制模型等學模型;並給出了其相應的演算法;完成了板形儀計算機控制的硬體設計,並在此基礎上,應用高級開發語言visualbasic6 . 0 ,通過加載pcl - 812pg多功能據採集卡的驅動程序后,調用動態鏈接庫( dll )中的的方法,完成了信號中斷方式下的實時據採集,採集的據經計算機作標度變換、對比、圖形顯示、存儲等處理,並提供了用於板形控制的調節量。
  7. The closed - loop transfer function matrix of such a system must be singular and an input controls two outputs in the system, so the closed - loop transfer function should be assumed a singular matrix whose elements are the fist - order inertia components, then the controller is designed. the control algorithm of closed - loop gain shaping is applied to the rudder roll damping system ( rrd )

    考慮到此傳遞陣一定是奇異的,以及具有一個輸入控制兩個輸出的特點,在保證其中一個輸出盡量小而另一個輸出跟蹤輸入的前提下,將傳遞陣即補靈敏度設為具有一階慣性的奇異陣,設計出控制器。
  8. With the high accurate transfer function it is possible to design frequency characteristic compensator to eliminate the mechanic resonance frequency characteristic of the control object. the fast steering mirror system closed bandwidth is no longer restricted by the mechanic resonance frequency and the closed bandwidth is expanded effectively

    在獲得對象的高精度傳遞以後,使用零極點對消的方法補償的機械諧振,有效地擴展了快速控制反射鏡的帶寬,使快速控制反射鏡帶寬不再受制於的開諧振頻率。
  9. After analyzed each part of the loop, the system ' s open - loop and closed - loop transfer functions are presented and some parameters are optimized to ensure that the system has better stability and response speed

    設計了小抖動穩頻控制,分析了各部分的組成與傳遞,給出了的開傳遞。根據傳遞優化了有關參,使得有較好的穩定性與響應速度。
  10. In this thesis, the decoupling unit of vav system is designed in the way of feedforward conpensation. then the transfer function matrix of the feedforward conpensation decoupling unit of the 5 inputs & 5 outputs vav system is worked out. the decoupling conpensation unit can change the transfer function matrix of the open loop and closed loop control system into diagonal matrix, so that the coupling among the five control loops is eliminated, and vav system is decoupled

    本文採用前饋補償法設計了變風量空調的解耦補償器,並得出了五輸入、五輸出變風量空調前饋補償解耦器的傳遞矩陣,該解耦補償器可以使本文所研究的變風量空調控制的開傳遞矩陣和傳遞矩陣都變換為對角矩陣,從而解除五個控制迴路之間的耦合,使變風量空調實現解耦。
  11. Instead of adopting exterior matrix p ( s ) diagonal 1 or s, triangle 0 or as which the predecessors used, i employ the exterior matrix p ( s ) diagonal 1 or the structure of iir filter ( for convenience, s + i s employed ), triangle 0 or the structure of iir filter ( for convenience, a ( s + p ) is employed ). this method eliminate the element 1 / s in close transfer matrix whereas the predecessors ' s method carried

    但該方法採用的p ( s )主對角元素為1或s ,下三角元素為0或s 。這樣,傳遞就必定出現因子1 s ,不利於的穩定性與魯棒性。針對這個問題,本文提出一種改進的方法,可使外矩陣p ( s )的主對角上元素為1或iir濾波器的結構形式(為簡單起見,取s + ) ,下三角元素為iir濾波器的結構形式(為簡單起見,取( s + ) )或0 。
  12. At first, the robust h control for uncertain nonlinear systems with norm bounded uncertainties is studied, based on a positive definite solution of hamilton - jacobi - issacs inequality ( hji ), a sufficient condition is given such that the closed loop system is asymptotically stable and its l2 - gain is less than or equal to a prescribed value. using this condition state feedback control law and an output feedback control law which ensured robust hx performance of the closed - loop system are derived. due to the difficulty to solve hji, a method is proposed which do not require solving it by using an appropriate lyapunov function

    首先,研究了范有界型不確定非線性魯棒h _控制問題,基於hamilton - jacobi - issacs不等式( hji ) ,給出了漸近穩定且l _ 2 -增益有限的狀態反饋和輸出反饋設計演算法。考慮求解hji的困難性,針對不確定非線性,通過適當地選擇lyapunov,提出了求解非線性魯棒h _控制問題的演算法,可以避免求解hji 。
  13. By using the correction approach of vary - transfer function for designing parameter of closed - loop in the area of power electronics, the system could work reliably under wide range input voltage conditions. compared with the design method of closed - loop parameter, the advantages of the correction approach of vary - transfer function were highlighted and testified by simulation and experimental results

    為了使能夠在寬電壓輸入范圍內穩定正常工作,本文實現了提出的變傳遞校正方法在電力電子設計中的應用,並與設計方法進行了比較,指出了該方法的優點,並通過模擬和實驗驗證了該方法的正確性。
  14. Based on the generalized riccati inequality and linear matrix inequality, necessary and sufficient conditions were obtained for the existence of static output feedback h controllers, which guarantees that the resulting closed - loop system is admissible with its transfer function matrix satisfying h norm constraint

    本文首先利用線性矩陣不等式和廣義riccati不等式( gari ) ,給出離散廣義中存在靜態輸出反饋h控制器,使得是容許的且其傳遞矩陣滿足h范約束的充要條件。
分享友人