閉環鎖相系統 的英文怎麼說

中文拼音 [huánsuǒxiāngtǒng]
閉環鎖相系統 英文
closed loop phase lock system
  • : Ⅰ動詞1. (關; 合) close; shut 2. (堵塞不通) block up; obstruct; stop up Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • : Ⅰ名詞1 (安在開合處使人不能隨便打開的器具) lock 2 (姓氏) a surname Ⅱ動詞1 (上鎖) lock up 2 ...
  • : 相Ⅰ名詞1 (相貌; 外貌) looks; appearance 2 (坐、立等的姿態) bearing; posture 3 [物理學] (相位...
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. The key components in laser gyro is he - ne ring laser, and the reciprocal action theory between light and medium is the base in studying the ring laser, use the lamb half classical theory, and on the base of density matrix theory, the optical brounch equation was established, which described the movement of amplifying medium atom in the ring syntonic cavity, and according to the medium polarize theory the self consistent equations was deduced, which describe the light intensity and phasic of the counter - propagating wave. on the basis of this equations, adopted the simulation software matlab and virtual instrument programming language labwindows / cvi, we can do some simulated experiments in study the phenomenas such as amplify and dispersive characteristic of medium, mode pushing effection, burned hole effection and pattern competition, lock - in of frequency and the characteristic of light intensity and phasic of the counter - propagating wave in laser gyro

    激光陀螺的核心部件為he - ne形激光器,而掌握光與介質的互作用理論是研究激光器的關鍵,採用拉姆半經典理論為主,在密度矩陣理論的基礎上,推導形諧振腔中描述he - ne氣體增益介質原子運動的光學布洛赫方程,運用介質極化理論得出描述激光陀螺反向行波的光強、位所滿足的自洽場方程組,在此基礎上,運用matlab模擬軟體和虛擬儀器編程語言labwindows / cvi ,對激光陀螺中的介質增益色散特性、頻率牽引效應、燒孔效應及模競爭、效應及激光的光強和位特性進行模擬試驗研究,並且運用全量子理論,對激光工作原理進行分析,得出二能級單模輻射場的光子數密度分佈,得出激光場的光子計分佈,模擬激光場的動態建立過程。
  2. We design inversion control circuit with cmos figure pll cd4046 act as core and microprocessor 80c196kc act as assistant controller. adopting a control method that combine fuzzy controller and pll control, improve induction heating power succeed in startup. adopting electric current voltage pair closed loop feedback design, with trough route capacitance voltage and trough route electric current act as pair closed loop feedback signal, guarantee induction heating power output accuracy

    並對主電路的元器件參數進行了詳細的計算;設計了以cmos數字cd4046為核心、以80c196kc作為輔助控制器的逆變控制電路;採用了模糊邏輯與結合的控制技術,提高了電源的啟動成功率;採用電流、電壓雙反饋方案,採用槽路電容電壓和槽路電流作為反饋信號,從而保證了電源功率的輸出精度。
  3. Finally, the principle of phase - locked - loop for speed control is discussed. the control methods of torque and magnetic levitation force are studied experimentally on a prototype bearingless motor. based on the analysis of shortcomings of the analog control system, a digital control system is proposed

    分析了採用對電機轉速進行控制的原理;設計了磁懸浮力的模擬控制器並對磁懸浮血泵電機進行了實驗研究;針對模擬控制存在的缺點,本文設計了一種數字控制
  4. Firstly, design the software phase - closed loops ; secondly, realize the double closed loops control of the instantaneous value and the virtual value. furthermore, the dynamic flux imbalance of the output transformer caused by ordinary pi arithmetic is analyzed in detail. a new solution for flux balance by sampling the instantaneous primary current of the output transformer and introducing the on - line calculated bias current component into the voltage regulation arithmetic is presented

    軟體實現了ups的各個功能模塊,首先設計了軟體;然後實現了輸出電壓瞬時值和有效值雙反饋控制;並且在深入分析基本數字pi演算法所引起的輸出變壓器動態偏磁問題的基礎上,提出了一種改進演算法,實時消除了變壓器的偏磁。
  5. First, because pipelines are so complex that controlled object is high order, delay, coupling, nolinear and time - varing, it is difficult to realize closed loop control for it using valid mathematic model. to resolve this problem, the paper presents a fuzzy - pid control algorithm with self - adjusting regulation factor. second, if a moving motor supplied by inverter power is switched to be supplied by power supply, the impact of overload - voltage and overload - current appears

    主要針對中、大容量供水中,由於供水管網鋪設復雜、彎管多、控制對象具有高階、滯后、耦合、非線性及參數時變的特點,難以利用有效的解析式數學模型進行控制,以及多臺水泵並聯運行時,水泵電機由變頻電源供電向工頻電源供電切換過程中產生的過電壓過電流沖擊這兩個難題,提出了可調整因子fuzzy - pid控制演算法及利用控制實現水泵電機由變頻電源向工頻電源的同頻同平滑切換。
  6. The software includes procedures to control and monitor the ups such as software pll ( phase - locked loops ), the value modulation of the output voltage, the producing of pwm signals and kinds of protections the control system and operation principal are analyzed and verified by detailed simulation and experiment results

    軟體部分則包括ups各種功能的實現,其中主要研究了軟體(市電跟蹤) 、有效值調節、各類保護、 pwm波的生成、控制等的實現。
分享友人