間接補體結合 的英文怎麼說

中文拼音 [jiānjiēbǔtǐjiēgě]
間接補體結合 英文
indirect complement fixation
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 體 : 體構詞成分。
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 間接 : indirect; secondhand
  • 補體 : addiment
  • 結合 : 1 （發生密切聯系; 聯合） combine; unite; integrate; link; binding; coalition; cohesion; connectio...
  1. Activation of the complement may lead to killing of the microorganisms by direct lysis effect of complement system or the phagocytosis by the enhancement of the attachment of microbes to the phagocyte ( opsonization ). low serun concentrations of mbl in man is the basis for a common opsonic defect associated with recurrent infection

    它可選擇性識別多種病原體表面的糖結構，以不依賴抗體和c1q的方式激活補體，發揮溶破和間接調理功能，還能與吞噬細胞膠凝素受體結合而起直接調理作用。
  2. Circuit design is the basis of design of demultiplexer. speed, power and chip area are the main factors that should be considered in circuit design. every circuit structure has its merits and drawbacks, e. g. cmos logic family has a slower speed, but lower power, smaller area, scfl ( source couple fet logic ) family has a higher speed, but higher power, larger area. we should choose a proper circuit structure or their mixed structure for certain design to get a good tradeoff among the three factors. flip - flop is the fundamental element of demultiplexer, setup time and hold up time are key factors, which influence the speed of circuit, thus the design aim is how to reduce them. in this thesis we place emphasis on the design of scfl latches

    速度、功耗、面積是電路設計要考慮的主要因素，不同的電路形式具有不同的優缺點，如cmos互補邏輯電路功耗低，面積小，速度相對較慢； scfl （源極耦合fet邏輯）電路速度高，功耗和面積較大。所以要針對具體設計需要選用適當的電路形式或其組合結構，以滿足設計要求。觸發器是分接器的基本組成單元，建立時間和保持時間是影響電路速度的關鍵，所以減小建立時間和保持時間是觸發器設計的主要目標，本文著重介紹了scfl鎖存器的設計和優化方法。
  3. Where the shoe pinches of the repair success is all right combination of young and old concrete. presently, most of the researches inside and outside country made the two into one to against force through felt. in practice, however, it ca n ' t obtain ideal bond capacity only depend on adherence. thus, this paper bring forward a young method to make up the lack of felt capacity - use mechanical joint element to link young and old concrete

    新老混凝土之間的良好結合是混凝土修補成功的關鍵所在，目前國內外的研究中絕大部分是通過二者的粘結作用使其結合成為整體共同受力。而實際工程中僅僅依靠粘結力往往達不到理想的結合程度。因此，本文研究的是加強新老混凝土結合，彌補粘結力不足的一種新方法，即採用機械連接件將新老混凝土結合在一起的方法。
分享友人
分享到 Line

分享到臉書