間隙控制器 的英文怎麼說

中文拼音 [jiānxìkòngzhìqì]
間隙控制器 英文
clearance controller
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 間隙 : （空隙） interval; gap; freedom; space; [機械工程] clearance; separation; stricture; clear; inter...
  • 控制器 : controller; regulator; monitor; pilot; keyer; manipulator; control unit; control device; [自動化]...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Control on intimate terms of the air preheat device

    空氣預熱器的間隙控制
  2. 4 design for hatch size of control - pan relates to brake interruption setup and whole layout of aira. this article gives their correlation

    4控制盤開口尺寸的設計與制動器制動間隙的設置和調整臂的整體布置有關，文中給出了它們的相互關系。
  3. Aim to eliminate the influences of backlash nonlinear characteristics, a second generation adaptive pid controller based on single neuron is given. the result of simulation and the debug of actual digital servo system shows that the controller can effectively get rid of the sustained oscillation of the system caused by the backlash characteristics, and can improve the system accuracy

    隨后，採用改進型單神經元自適應pid控制器來消除間隙非線性對系統的影響，模擬結果表明所採用的方法能有效消除間隙特性引起的系統自振蕩，並且能夠提高系統的跟蹤精度。
  4. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  5. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  6. Therefore, the leakage control technology of air preheater becomes an important problem that must be solved

    因此空預器的密封間隙控制技術是該領域的一個研究熱點。
  7. In this thesis, several advanced control methods are adopted to improve the performance of the traditional air preheater leakage control system using non - touched sensor

    本文採用了多種先進控制方法，用來改進傳統的非接觸式空氣預熱器密封間隙控制系統。
  8. Based on can bus, this thesis develops an innovational air preheater leakage control system, with pcs structure to fulfil the optimal control over system structure and the multi - signals transfer

    為了優化控制系統結構並解決系統中多種信號的傳遞問題，本課題以can總線為基礎，建立了fcs結構的新一代空氣預熱器密封間隙控制系統。
  9. Clearance control strategy in rotary air - preheater

    回轉式空氣預熱器密封間隙控制策略
  10. The program is written by assemble language to control the movement of the vacuum circuit breaker with pma. the program also can monitor the environmental temperature, control voltage, closing displacement, zero point of contactor voltage

    用匯編語言編製程序對配永磁機構的真空斷路器的分、合閘進行控制，同時對其運行的環境溫度、控制電壓、合閘位移和觸頭間隙電壓過零點等狀態進行實時監測。
  11. Due to high speed of the maglev, it demands rapidity and reliability of the communication interface between gap sensor and suspense control system. thus a multi - serial asynchronous communication interface based on rs - 485 is designed. it transmits one signal on each unattached channel and has redundant structure, which meets the requirement of rapidity and reliability

    針對磁懸浮列車，對間隙傳感器與懸浮控制器之間通訊介面的實時性和可靠性高要求特點，本文還設計了多路rs - 485串列異步通訊介面，每路通道傳送一路數據，各路通道之間相互冗餘，滿足了系統對實時性與可靠性方面的要求。
  12. The last part concludes that mr dampers is one of the very attractive control elements in semi - active control. as one of mixed model mr dampers, armature piston ' s mr dampers have principle designs good function and better practical value, it ' s worth to popularize use. about the armature piston ' s mr damper ' s designs, the space of work, the diameter of wok and the length of magnetic pole have obvious affects to the force of mr dampers, mr fluid materials should be paid attention, input electric current affects mr dampers greatly the high current increases the damping force, the effect of reduce vibration increase obviously,

    最後，論文給出了結倫：磁流變液阻尼器是半主動控制裝置中非常吸引人的控制元件之一，混合工作模式的磁流變阻尼器結構簡單，阻尼效果比流動模式和剪切模式均要好，是一種比較理想的磁流變阻尼器；電樞活塞式磁流變阻尼器作為混合模式磁流變阻尼器的一種結構形式，其結構設計合理，性能良好，具有較強的實用價值，值得在工程中推廣應用；在電樞活塞式磁流變阻尼器的設計中，應特別注意工作間隙h 、工作直徑d 、磁極長度卜都對阻尼器的阻尼力有明顯的影響，並注意選用合適的磁流變液材料；輸入電流對磁流變阻尼器的阻尼效果影響很大，輸入大電流時阻尼力明顯增大，減振效果明顯提高。
分享友人
分享到 Line

分享到臉書