閘門型 的英文怎麼說

中文拼音 [zháménxíng]
閘門型 英文
gate type
  • 閘 : anchor gate
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 閘門 : 1 （水閘） sluice gate; gate; water gate2 （船閘） lock gate3 [機械工程] throttle valve; strobe; ...
  1. According to the fact that freeze - resisting measure is needed to be taken for the gates operating in winter and low head arch gates, electrothermic freeze - resisting device is designed in this thesis

    本文根據冬季有運行要求的閘門及低水頭弧形閘門需要採取防凍措施的實際情況，研究設計了一種電熱型防凍裝置。
  2. Small shops inside the large - scale mall have limited space. the crystal rolling gates have replaced the traditional bidirectional - opening ground glass doors

    大型商場內的小商鋪空間有限，選裝水晶卷閘門代替傳統的雙開地彈玻璃門，克服了白天營業時兩扇玻璃門佔用空間之不便。
  3. Small and middle size hydraulic headstock gears. basic parameters

    中小型液壓閘門啟閉機.基本參數
  4. This paper introduces the surface forming technology for pocket concrete overflow weir, analyzes and compares construction technique for two types of gate and built - in parts, and presents rating methods for concrete samples when they are less than 30 groups

    摘要現介紹了小型混凝土溢流堰堰面成型工藝，分析比較了兩種閘門埋件施工工藝，提出了數量不足30組時的混凝土試塊評優的方法。
  5. The researches including discharge capacity, pressare properties, cavitation characteristics at some key positions, hoisting load of the gate, configuration of energy dissipator at the exit dentated - sill, and downstream scouring were performed by hydraulic model tests

    藉助系列水工模型試驗對水布埡放空洞的泄流能力、壓力特性及關鍵部位的空化特性、閘門啟閉力、出口鼻坎消能工體型及下游沖刷等進行了較深入的研究、分析。
  6. In this paper, ansys, the software on finite element analysis, is made use of processing the static and modal analysis on the preliminary models and its " modified ones. by analyzing the results, we can conclude that the stresses on the components of the modified models are tended to equilibration and the location of the branches " brace can also influence stresses and translations on the branches. in addition, the values of the intrinsic frequencies on modified models " are larger than the ones on preliminary models, but the ranges of the frequencies on both models are almost same

    傳統的弧形閘門的支臂結構基本上都是三角架式的，這主要是因為按平面體系進行計算的傳統設計方法忽略了結構的整體性及弧形閘門的空間結構特點，設計得比較保守，而實際上，將其改為a型結構也存在可行性，本文是利用有限元分析軟體? ? ansys對原模型及修改模型分別進行靜態和固有頻率的計算，通過分析比較其結果可知，支臂改為a型后會使閘門的整體受力趨于均勻，即原模型受力大的部件其應力變小，而原模型受力小的部件其應力會變大；而且a型支臂的支桿在不同的放置位置對支臂的應力和位移變化也有一定的影響。
  7. Radial gate is one of type of gate used widely in hydraulic structure engineering

    弧形閘門是水工結構工程中使用最廣泛的閘門型式之一。
  8. Abstract : using a series of model tests, the properties of discharge capacity in the closed conduit due to inflow in gate shaft is studied and a method for estimating reducing discharge capacity is provided to designers

    文摘:通過系統模型試驗，研究了泄水道因進口閘門井進水減小泄流能力的特性，並提出了估算方法，可供設計應用。
  9. Chapter two ascertains main technological factor of dong gou lock reconstructing, including forecast the cargo and volume through the lock to reason about representative type of vessel designed for through the lock and its operation organize. chapter three design the renovate engineering through ascertaining the main technological factor scale of the lock, dimension, designed water level and altitude, including design of structure of the lock, lock chamber and lock gate, and select the main technological factor and pattern of headstock gear. chapter four draws a comprehensive compare of the two design scheme of the renovate project with engineering project economy evaluation method, and makes out the recommended scheme, and furthermore, to calculate the economic evaluation index of the recommended scheme and makes the economic sensitivity analysis of the scheme and finally demonstrate economic feasibility of the scheme

    本論文共分四章：第一章主要介紹了原東溝船閘的地理位置和營運現狀，說明了船閘在航道建設和水資源綜合利用中的作用及東溝船閘改造的必要性；第二章東溝船閘改造的主要技術因素確定其中包括東溝船閘過閘貨種和貨運量發展的預測，並確定東溝船閘的設計代表船型及營運組織；第三章東溝船閘改造工程設計本章通過船閘改造工程主要技術參數：船閘規模、尺度、設計水位和高程等的確定，設計了二個船閘改造方案，包括鋼筋混凝土整體塢式閘首結構、閘室和閘門的設計，並選定了啟閉機的主要技術參數和型式；第四章採用了工程項目經濟評估方法對東溝船閘改造工程二個設計方案進行全面綜合比較后，確定了推薦方案。
  10. Choicing suitable configuration, ventilation installation and controlling the unevenness of flow surface at the sudden enlargement section after the tainter gate, this emptying tunnel may avoid or mitigate cavitation

    在工作閘門區突擴跌坎處，選擇合適的體型及通氣設施並嚴格控製表面不平整度，可達到防止或減小空化的目的。
  11. A mathematic model is first introduced for optimizing the layout of flood - release structures in a high arch dam after an idea of the broad sense of construction costs for unit area gate is introduced, and the optimal computation of the layout of flood - release structures in xiao - wan arch dam demonstrates that this model is reasonable ; 4

    在引入了閘門廣義單位面積造價的基礎上，首次建立了高拱壩壩身泄洪建築物布置的數學優化模型，並通過對小灣拱壩壩身泄洪孔口的優化布置計算，說明所提出的數學優化模型是可用的； 4
  12. By using the p + pr algorithm and the technique of synchronous gate operation, a mathematical model of multireach canal systems in the mode of constant water - volume control was developed ; and it was programmed to simulate the control process

    摘要應用閘門同步操作技術和p + pr演算法，建立了多渠段串聯渠系並有渠側出流的等體積控制模型，並編程對控制過程進行實時模擬。
  13. Vicki has put on a smart causal clothes this time with jean jacket and pants including her cap, and not forget to mention that she has pleats her hair, this is different and she has changed her appearance

    步出機場閘門的薇薇今次穿著青春便利，牛仔褲加上牛仔外套和鴨嘴帽，還綁了辮子，改了以往的裝扮，豎立了新造型。
  14. In the latest disturbing development, a camera on the a59 in penwortham, near preston, was set off by the vibration of roll - down shutters on the back of large lorries

    在最近的一次令人不安的事故中，普雷斯頓附近潘沃森59a公路上的一個電子監控設備，受到大型貨車后車廂卷閘門開啟時的震動產而被啟動拍照。
  15. Extra - large gate installation assembly weld technology at xihe hydropower station

    喜河水電站超大型閘門安裝組焊技術
  16. ( 3 ) the vibration types and physical course of the tilting gate were elaborated, the causes of all kinds of the vibration were analyzed, and then the corresponding shock absorption measures were put forward

    （ 2 ）分析闡述了翻板閘門振動類型及其物理過程研究，對各種振動的原因進行了分析，同時也提出了相應的減振措施。
  17. According to the analysis of the gate, the author put forward a mathematical model of the optimization design of the hydraulic automatic tilting gate, and then worked out the structural stability optimization design program of the hydraulic automatic tilting gate. then by the calculation of the program, a better design for a certain project was gained

    根據對翻板閘門的運行分析，提出了翻板閘門優化設計數學模型的一般表達式，並據此編制出水力自動翻板閘門的結構穩定性優化設計程序，對某一工程實例，通過程序的計算，得到了較理想的設計成果。
  18. Secondly, based on the account of hydraulic dynamic factor ( hydro - capacitance and hydro - inductance ) and the analysis of each component ' s math model, the system ' s math models of three situations are established

    其次，在充分考慮液壓系統的動態因素（液容和液感） ，並對各液壓元器件建模分析的基礎上，分別建立了速閉閘液壓控制系統在泵或蓄能器作用下開啟、關閉閘門過程的數學模型。
  19. The detailed opinion of the enterprise dexet ? - automaticke pohony vrat has pertinent information on drives and on gate. moreover, manufacture and installation and / or automatic are offered

    是一家知名的、誠信的生產商和服務商，該公司提供新型的、專門的產品，例如柵、框，格形柵板，障礙物，百葉窗，閘門，塑料，工業機械裝置。
  20. Interesting selling prices of industrial, industrial plant, plastic in addition to gates, shutters, gate are offered to you by dragon west s. r. o. beyond that you can obviously co - ordinate at a short notice for all offers on barriers, automatic and grating through telephone or mail

    是一家知名的、誠信的生產商和服務商，該公司提供新型的、專門的產品，例如柵、框，格形柵板，障礙物，百葉窗，閘門，塑料，工業機械裝置。
分享友人
分享到 Line

分享到臉書