閥隙流速 的英文怎麼說

中文拼音 [fáxìliúsù]
閥隙流速 英文
mean gas velocity in valve opening area
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 流速 : [機械工程] velocity of flow; strength; [水文] current velocity; current speed; flow rate流速管 pi...
  1. On one hand, it may exert damping on the armature of torque motor and overcome self - excitation of jet pipe. one the other hand, it may enlarge magnetic permeability of working clearances and improve magnetic circuit efficiency of torque motor to boost dynamic response speed of servo valve

    一方面可增大力矩馬達工作氣隙部分產生的阻尼，從而可以抑制射流管的自激，另一方面又可增大工作氣隙的導磁率，改善力矩馬達部分的磁路效率，從而提高伺服閥的動態響應速度。
  2. Based on the special property of magnetic fluid ( mf ), we fill the magnetic fluid into the working clearances of the servo valve torque motor. one side, the magnetized magnetic fluid can exert a damping torque on the torque motor armature and reduce vibration of the armature ; on the other side, it can improve the magnetic circuit efficiency of the torque motor because of the magnetic fluid ’ s larger magnetic permeability

    基於磁流體所具有的特殊性質，將磁流體添加到伺服閥力矩馬達的工作間隙中，一方面磁流體被磁化后可增大銜鐵的阻尼力，減少振動;另一方面由於力矩馬達氣隙中磁導率的提高，使氣隙中的磁通量增大，力矩馬達的磁路效率和輸出扭矩將增大，因此可以提高力矩馬達的固有頻率和伺服閥的響應速度。
  3. A comparison of the flows with different gate - opening rates shows the causes that opening the gate at a higher rate is favorable to the reduction of cavitation, gate vibration as well as the gate load fluctuation. in addition, a study has been made to show the influence of the high - speed jet flow coming downward from the narrow gate gap on the flow condition in the tunnel downstream to the gate

    通過分析比較不同閥門開啟速率對流動特性的影響，闡明了快速開啟閥門不僅有利於減少空化空蝕也有利於減小弧門振動和啟門力的脈動，此外，研究了門楣處狹窄縫隙高速射流對門后流態、壓力脈動和弧門受力等方面的影響。
  4. Air valve size and airflow resistance losses of valves always speed and the size of the spring - loaded edge

    氣閥阻力損失大小與氣流的閥隙速度及彈簧力大小有關。
分享友人
分享到 Line

分享到臉書