阻帶衰減 的英文怎麼說

中文拼音 [dàishuāijiǎn]
阻帶衰減 英文
attenuation in suppressed band
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : 衰動詞(衰弱) decline; wane
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  1. Two kinds of filters are presented : by transferring the conventional waveguide cavity filter to the siw, a narrow bandstop filter is designed and simulated, get characteristic of narrow - band bandstop filtering. for example, relative bandwidth 1. 2 %, most attenuation of 48db in band. electromagnetic bandgap ( ebg ) structures present “ forbidden band ” characteristics, siw features high - pass characteristics, so bandpass filters can be composed by combing ebg and siw

    本論文提出了兩種基片集成波導濾波器結構:將傳統的腔體濾波器概念運用於基片集成波導結構,設計出了一種窄濾波器,對其進行模擬,得到了窄濾波特性,如相對寬為1 . 2 % ,最大為48db 。
  2. The performance of filters is not very good. the attenuation of stop - band is almost - 44db. the performance cannot satisfy the requirement for some application situation

    阻帶衰減大約在- 44db ,對於一些對濾波器性能要求較高的應用場合,這個數值是達不到要求的。
  3. Bessel function design simulation results show the small pass - band ups, stop - band attenuation, in the pass - band with a better group delay characteristics, which can meet the design requirements

    模擬結果表明貝塞爾函數設計的濾波器通起伏小,阻帶衰減大,在通內群延遲特性較好,可以很好滿足設計要求。
  4. Applying the method of this article, we can get that the attenuation of stop - band is - 75db and the error of reconstruction is 0. 0015. the simulation program and experiment result are provided. the correctness and validity are proved

    用本文的方法,在重構誤差將近千分之一的情況下,取得了較好的濾波器特性,其阻帶衰減達到- 75db ,文中給出了matlab實驗程序及結果,並通過simulink模擬,證明了這種方法的正確性與有效性。
  5. The main work of the system can be divided into four main parts as the following : ( 1 ) 10. 5ghz bandpass filter the main contradiction of filter is caused by its function of dividing frequencies. in order to properly divide frequencies, not only need passband ’ s attenuation to be as small as possible and stopbands ’ as big as possible, but also need a sharp and quick change between the attenuation of passband and stopband, thus to make their diversity obvious

    這四個功能模塊分別是: (一) 10 . 5ghz通濾波器濾波器的主要矛盾是由它分隔頻率的功能決定的,為了使分隔理想,一方面要求通盡可能小,阻帶衰減盡可能大,亦即通差值要盡量大;另一方面要求通之間的變化應盡可能快,最好是陡峭的跳變,使和通的分隔十分明顯。
  6. The specification is that the cutoff frequency must be more than 15mhz, the maximum passband ripple must be 0. 2db and the minimum stopband attenuation must be 40db

    該濾波器要求截止頻率大於15mhz ,通最大紋波為0 . 2db ,最小為40db 。
  7. High speed, high damping factor, with reduce / gain, full protect system, special heat radiator, excellent components. it can work at 2, 4, 8

    本機其特性為高速度、高尼系數、/增益切換等等功能、完整的保護系統,獨特的散熱設計,精良的元件,可輕松承受2 4 6 8負載。
  8. Band elimination filter. a filter that has a single continuous attenuation band, with neither the upper nor lower cut - off frequencies being zero or infinite

    濾波器。只有單個連續寬,將在上邊或下邊頻率切斷為零或無窮大。
分享友人