阻抗匹配條 的英文怎麼說

中文拼音 [kàngpèitiáo]
阻抗匹配條 英文
matching strip
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ動詞1 (抵抗; 抵擋) resist; combat; fight 2 (拒絕; 抗拒) refuse; defy 3 (對等) contend with...
  • : Ⅰ動詞(比得上; 相當; 相配) be equal to; be a match for Ⅱ形容詞(單獨) lone Ⅲ量詞1. (用於馬、騾等) 2. (用於整卷的綢或布)
  • : Ⅰ動詞1 (兩性結合) join in marriage 2 (使動物交配) mate (animals) 3 (按適當的標準或比例加以...
  • : Ⅰ名詞1 (細長的樹枝) twig 2 (條子) slip; strip 3 (分項目的) item; article 4 (層次; 秩序; 條...
  • 阻抗 : [電學] impedance
  • 匹配 : 1. [書面語] (婚姻配合) mate; marry 2. [電學] matching
  1. The impedance matching criterion that the sum of all the radiating slot normalized conductances is equal to 2 for the inner feed, and also the sum of all the coupling slot normalized impedances for the series - shunt inner feeder is equal to 2 are verified by using microwave network theory

    採用微波網路理論,在內部饋電情況下,分別對一輻射波導上輻射裂縫的歸一化導納和為2的設計準則,以及對串並形式饋電裝置,對耦合裂縫的歸一化和為2的設計準則進行了證明。
  2. This effects can be explained as follows : the radiation conditions are actually impedance matching condition in terms of microwave network, for a fixed dimension of a resonator and output transformer, only below the critical plasma density ", the matching condition can be satisfied in the smith circle map

    我們提出,這一現象可從的角度來解釋。對於一確定尺寸的腔體、變換器,存在一個等離子體密度的臨界值,只有在等離子體密度低於這個臨界值時,腔體的輸出和波導的特性才能滿足,即滿足所謂的輻射件。
  3. 2. we design a configuration of frequency - doubler according to the optimum focus condition and the cavity stability condition | a + d | < 2 and optimize it based on " mode - matching " and " optimum coupling ". 99. 96 % of optical impedance - match efficiency and over 95 % of spatial mode - matching efficiency are achieved eventually by using t = 10 % of input coupler in our experiment

    ( 2 )根據最佳聚焦件和腔的穩定性件( | a + d | 2 )對四鏡環型倍頻腔進行了設計,並分別從「模式」和「最佳輸入耦合鏡透射率的選擇」兩方面著手對腔進行優化,在我們的實驗中採用10的輸入耦合鏡,獲得效率為99 . 96 ,空間模式效率高於95以上的模式。
  4. As a result, this paper gives a corresponding harmonic prevent me asure. finally, according to the asymmetrical characteristics of electrical traction loads, this paper studies the negative sequence currents under different loads and makes a piece of advice for reducing the negative sequence currents produced

    最後,還根據電力牽引負荷三相不對稱的特點,分析了平衡變壓器在不同負荷件下的負序電流,對如何減小電力牽引負荷的負序電流提出了一點建議。
  5. According to the radar - absorbing model, the performance of rams of various absorber - volume - percentage with various frequency and the radar obsorbing performance of which in various thickness is predicted. according to the radar - absorbing model, the prerequisites of microwave electromagnetic parameters and the border curves for a single - layer homogeneous absorbing coating backed by a perfectly conducting plate to produce zero specular reflection are obtained by the steffensen speedup approach to solve the complex transcendental equation

    以吸波模型為依據,用計算機求解了單層均勻各向同性吸波材料的阻抗匹配條件,通過數值模擬得到了吸波材料時電磁參數邊界曲線的數值模擬等式和時寬帶吸波材料電磁參數的合理搭規則和頻散特性。
  6. Aiming at efficient analyses of electromagnetic characteristics of electrically large complex cavities, some hybrid techniques are developed based on eb - fem, including ipo / fem, extended ipo, improved ipo / fem, ddm / fem - bie, ddm / fem - po - ptd, fem / ibc, and fem / pml. the following contributions have been made in this dissertation : a novel hybrid approach is proposed in which iterative physical optics ( ipo ) subdomain - splicing technique is combined with eb - fem, the mathematical model of the proposed ipo / fem is established by some approximate methods

    本文以eb - fem為基礎,以電大尺寸復雜腔體的電磁特性為分析對象,對eb - fem與迭代物理光學法( ipo ) 、區域分解法( ddm ) 、邊界件( ibc ) 、完全層( pml )和mur吸收邊界件的結合演算法以及具有非完純導體邊界的ipo理論模型進行了研究。
分享友人