阻抗損耗 的英文怎麼說

中文拼音 [zǔkàngsǔnhào]
阻抗損耗 英文
impedance loss
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 阻抗 : [電學] impedance
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. The study is imitating subulate tool penterite armor fabric by method of test for puncture of paperboard and corrugated fiberboard, and to ascertain the laver of armor fabric for absorb energy and arrestment, and any difference angle to compare the rank of defying ball, for understanding the sharp to the rank of annor fabric defy penterite energy, and penterite deep, the lose energy relation of sharp

    摘要本研究是以沖孔強度試驗機測試，模擬尖錐利器攻擊穿刺防彈衣，且對于防彈衣層數間的阻抗作用及能量吸收的情形，並對各種不同角度的抗彈織物疊層排列作相互比較，進而?解尖錐對防彈衣的抗穿透層數之能量及穿透深度、錐度之能量耗損之間關系。
  2. Manufacturer of high voltage resistors, power and precision resistors, high voltage dividers, hybrid circuits, resistor networks, pressure and force sensors and load cells

    -生產ai - 6000自動抗干擾精密介質損耗測量儀，氧化鋅避雷器測試儀，地網接地電阻測試儀，油介損電阻率測量儀。
  3. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  4. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    直流電阻測試匝數比測量及電壓矢量關系的校定阻抗電壓及負載損耗的測量空載損耗及空載電流的測量工頻耐壓測試感應耐壓測試絕緣電阻測試局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  5. Impedance, reflection coefficient, return loss, and vswr test procedure measured in the time and frequency domain for electrical connectors, cable assemblies or interconnection systems

    電連接器電纜附件或互連系統在時間和頻率域中測量的阻抗反射系數回程損耗和vswr試驗程序
  6. Abstract : in this paper, the influence of the intrinsic material losses on the resonance and parameters measurement of lossy piezoelectric resonators, based on the impedance ( or admittance ) equation, is analyzed

    文摘:本文從考慮損耗時壓電振子的阻抗（或導納）方程出發，詳細分析了材料固有損耗對壓電振子的頻率特性及參數測量的影響。
  7. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  8. A new terahertz source of folded waveguide traveling - wave - tube which based on vacuum electronics is introduced, which may answer the question for scarcity of small, economical terahertz source with continuous wave of high average power. secondly, transmission characteristics of terahertz wave in the periodic slow wave circuit of folded waveguide traveling - wave - tube have been researched combined with development of micro - fabrication technology. dispersion relation and interaction impedance of the slow wave circuit are deduced by the way of equivalent circuit, and results accounted by theory are close to those simulated by software

    其次，結合計算機模擬技術對這種新型太赫茲輻射源的折疊波導慢波線路傳輸特性進行研究:用等效電路法從理論上推導了慢波電路場、色散關系及線路耦合阻抗，電磁模擬軟體計算得出的慢波電路色散曲線與理論計算所得結果基本上一致，表明這種尺寸的慢波電路在太赫茲頻段有著色散曲線較平坦以及寬帶、低損耗的良好傳輸特性。
  9. The thesis mainly investigated the bati _ 4o _ 9 ( bt _ 4 ), which has the lowest dielectric loss in ba - ti system, and ( ba, sr ) tio _ 3, the a position substitute compound of batio _ 3. the dielectric properties of bt _ 4 / bst with different preparation way and different elements doping were investigated. a archimedes method, xrd, sem, impedance analyzer, network analyzer and hakki - coleman method were used to investigate the density, phase formation, microstructure, dielectric properties and doping mechanisms

    本論文以在ba - ti系中具有最低介電損耗的bati _ 4o _ 9 （ bt _ 4 ）高頻介質陶瓷和batio _ 3a位sr取代而得的（ ba ， sr ） tio _ 3 （ bst ）高頻介質陶瓷作為研究對象，對不同粉體制備方法制備的bt _ 4 / bst高頻電介質材料進行不同元素的摻雜，運用阿基米德方法， x射線衍射分析儀，掃描電子顯微鏡和阻抗分析儀，網路分析儀， hakki - coleman法等方法手段和測試儀器測試燒成樣品的密度，相組成情況，微觀結構和介電性能，探討造成介電性能起伏的形成機理。
  10. As a result, switching configurations for rf signals are designed to minimize signal losses and maintain a characteristic impedance through the system

    因此，射頻信號的切換配置被設計為使信號損耗降至最低，並維持系統的特徵阻抗。
  11. The calculation results have shown that when the angles of the center electrode and the grounds decrease, the effective index, the characteristic impedance, and the conductor loss all decrease

    通過計算發現，隨著中間電極角度和地電極角度增加，有效折射率、特徵阻抗同時減小，導體損耗系數也隨之減小。
  12. The results show that the thickness and the width of the electrode, electrode gap and the thickness of upper cladding have different effects on microwave effective index, characteristic and conductor loss. compromising structure must be adopted in practical design to gain perfect performance

    結果表明:電極的厚度和寬度、電極間距以及上包層的厚度對微波有效折射率、特徵阻抗和導體損耗的影響是不同的，在實際設計時應當綜合考慮。
  13. It has been shown by our calculations that conductor loss is greatly reduced under velocity matching with relatively thick coplanar waveguide electrodes and thick buffer layer, but the characteristic impedance can not match with that of the external circuit at the same time, and the modulation bandwidth is confined in this case

    然後，用一般的橢圓積分計算了普通共面波導型調制器的有效折射率、特徵阻抗和導體損耗系數。通過計算發現，採用厚電極和厚緩沖層結構，在實現速度匹配的情況下，可以大大減小導體損耗，但是由於阻抗不能同時滿足匹配，調制帶寬受到限制。
  14. The high voltage windings is made by sectional aluminium foil with glass fiber and resin casting, the voltage between turns is very low, the partial discharge is very low, there is no cracking, since the expansion factor of conductor and insulation material is similar, it also has the advantages of no corrosion, no pollution, low losses, low noise level, anti - vibration, fire protection, maintenance free, long operating life and high reliability

    低壓繞組為銅箔繞制，半干nomex紙做層間和外層絕緣，經乾燥與銅箔固化為一體，散熱好強度高。高壓繞組為分段鋁箔繞制，玻璃絲網架環氧樹脂澆注，層間電壓低，局部放電小，導體和絕緣體膨脹系數相似，不裂壽命長無腐蝕無污染損耗小噪音低抗震阻燃免維護運行安全可靠。
  15. It is shown that good performance on millimeter - wave and centimeter - wave can be achieved respectively by electric loss and magnetic loss, then through improving the impedance matching between layers compatible absorbability will be obtained on the whole by double - layer structure letting the centimeter - wave absorbing layer be the inner layer and the millimeter - wave absorbing layer the outer layer

    理論分析和實驗結果表明，先分別以電損耗和磁損耗為主，採用單層結構分別對毫米波和厘米波實現較好的吸收，然後以厘米波吸收層作為內層，以毫米波吸收層作為外層，並進一步改善內外層之間的阻抗匹配，利用兩層結構可以對毫米波和厘米波實現較好的兼容吸收。
  16. By the methods of conformal mapping, the closed - form analytical expressions for characteristic impedance per unit length and relative effective dielectric permittivity are deduced for the three asymmetric cpw ' s, and the analytical expressions of the electric field for asymmetric cpw with conductor backing is derived

    根據本文所提出的模型，推導出了三種結構參數的具體特例，並給出了這些特例的特性阻抗、有效介電常數解析表達式。門）給出了分析有限介質基片厚度非對稱共面波導導體損耗的方法，並推導出其解析表達式。
分享友人
分享到 Line

分享到臉書