限流線圈 的英文怎麼說

中文拼音 [xiànliúxiànjuān]
限流線圈 英文
current limiting inductor
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • : 圈名詞1. (養豬羊等牲畜的建築) pen; fold; sty 2. (姓氏) a surname
  • 線圈 : [電學] coil
  1. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為: ( 1 ) 、這次冷渦在其發生發展過程中,其移動路徑是沿經南壓,攜帶的冷空氣勢力較強,形成槽后較強的垂直運動; ( 2 ) 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急軸,把源源不斷的西南暖濕氣輸送到遼西地區,也就是急軸的左前方位置,為這次暴雨的產生提供了充足的水汽來源; ( 3 ) 、低空急不但為暴雨輸送水汽,其造成的較強的垂直環也是產生強降水的一個主要原因; ( 4 ) 、 mm5模式以四維同化資料作為初始場,最大度地避免了觀測誤差可能造成的積分不穩定,提高了模擬結果的參考價值。
  2. In the anistropic magnetic medium under the condition of magnetic permeability 11unequal to 33, the magnetic field on axis line of current - carrying coil and that inside current - carrying solenoid can be calculated by applying biot - savart law of that medium. as the condition of their service is restricted, it is necessary to derive the magnetic field on axial line of current - carrying coil and that inside current - carrying solenod under more general condition of 11unequal to 33. on the basis of the magnetic field on axial line of current - carrying coil in anisotropic magnetic medium under the derived condition of 11unequal to 33, the authors obtain the magnetic field on axial line of current - carrying solenoid in anisotropic magnetic medium under general condition of 11unequal to 33. the result shows a wider applicable coverage

    利用畢奧-薩伐爾定律,並在磁導率11 = 33的條件下,可求出各向異性磁介質中載上的磁場,以及載直螺管內部的磁場.顯然,其使用條件受到制.為此,有必要導出在11 33的更一般情況下,各向異性磁介質中載上磁場和載直螺管內部的磁場.在已導出11 33及各向異性磁介質中載上磁場的基礎上,求出一般情況下各向異性磁介質中載上的磁場,使其結果適用范圍更廣
  3. High voltage shunt capacitor installation is comp - rised of capacitor cabinets or steel racks capacitor, special fuses for capacitor overload protection, capaci - tor discharge device, air - cored reactor which is applied to restrain surge current and high frequency harmonic, zno arrester without gaps for overvoltage - limiting and high voltage vacuum switch etc. capacitor cabinet is

    高壓並聯電容器成套裝置主要由電容器櫃或鋼架電容器電容器過負荷保護專用熔斷器放電裝置專用放電或電壓互感器,抑制涌制高次諧波的空芯電抗器和制過電壓的無間隙氧化鋅避雷器及高壓真空開關
  4. Numerical analysis of the electromagnetic field caused by the eddy - current transducer the dissertation calculates the field caused by the solenoid coil with a finite - length ferrite core carrying time - harmonic current by the finite element method

    二、渦傳感器電磁場數值分析本文採用有元數值分析方法計算了含有有長磁芯的放置式的屯磁場。
  5. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻,著重探討了水泵量、揚程、軸功率、轉速的測試原理和測試方法,提出了採用電測法並結合電機效率特性曲測量水泵軸功率,從而避免了損耗分析法中大量復雜的中間過程,滿足了試驗裝置的自動化測量要求;採用漏磁感應法測量電機轉速,彌補了其它轉速測量方法對水下電機測試的局性,適應了萊恩公司開發潛水電泵的實際需要。
  6. Abstract : based on principle of minimal leakage magnetic field energy for current distribution of parallel coils in the primary side of transformer and also on finite element method, the method for calculating the current distribution of parallel coils in the primary side is studied and solved

    文摘:以變壓器一次各並聯的電分配一定滿足漏磁場能量最小原理為基礎,結合有元方法研究了計算一次各並聯分配的方法。
  7. Below are the work and results of the dissertation : 1. analytical solution to the eddy - current transducer with ferrite core according to the practical eddy - current transducer used in eddy - current not, the analytical model described by a solenoid coil with a coaxial cylindrical ferrite core of finite length " is established

    論文的主要工作和結論概括如下:一、渦傳感器電磁場解析解根據渦無損檢測中實際使用的放置式傳感器,建立了含有共軸有長磁芯的通電圓柱電磁場分析模型。
  8. The integral method is adopted caculate and analyze to amf three - dimension distruction which is the structure of coil type four - pole and the structure of coil type double - pole and study the size of two kind of electrode structure axial magnetic flux density distribution and its fielduniformity. the finite - element method is used simulate that eddy current has effect on amf when contact tray of douple - pole amf structure is slotted or no

    本文採用積分方法對本文設計的式兩極縱向磁場觸頭結構和式四級縱向磁場觸頭結構的縱向磁場三維分佈進行了計算分析。研究了電弧燃燒期間兩種觸頭結構縱向磁場強度的大小、均勻性,利用有元法模擬式兩極縱向磁場觸頭結構的觸頭盤開槽和不開槽時渦對縱向磁場的影響。
  9. This dissertation, firstly, on the base of background materials of changjiang logistic co., ltd, analyze deeply the all - round processes of logistics operation, and open out the existing problems of changjiang logistic co., ltd at present, which mainly includes information communication barriers and information cannot be used of during the logistics businesses, resulting in increasing of the logistics operation cost and influencing speed of logistics business response to the market, according to analysis of existing problems and targets, offer solving problems total project, designing function modules and the framework of logistics management information system from two factors about reducing cost and increasing response speed, and puts forward mathematics module in terms of practical logistics operation case

    本文首先以武漢長江物股份有公司各方面背景資料為基礎,對物作業程進行全面而深入的剖析,揭示了長江物公司目前存在的問題,主要表現為信息溝通不及時、物作業得不到信息有效支持,影響了總物成本降低,及物服務響應速度。其次,依據問題分析和系統目標,提出了擬解決實際問題系統構架,詳細設計了物管理信息系統結構和各個功能模塊,著重從降低物營運成本和提高物響應速度兩個出發點來進行論述。本文還根據數學h圖論理論,結合實際物運作案例,就倉庫選址優化和配送路優化進行了探討。
  10. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有元分析方法對匝數、電強度、電頻率等對焦耳熱產生速率的影響進行了詳細的分析討論;採用不同的熱輻射分析策略,對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及的位置等對熱場分佈的影響進行了數值分析,解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題,提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路,給出了根據軸向溫度梯度的波動對位置實行動態調節以控制熱場的理論依據。
  11. A sensing magnetic field and displacement type of giant magneostrictive microdisplacement actuator with the functional of sensing driving magnetic field and microdisplacement is developed, and the design theories and approaches being applicable this type of microdisplacement actuator are pointed out : a circular diaphragm type of flexible construction that acts as integration mechanism of microdisplacement transferring and sensing of giant magnetostrictive microdisplacement actuator is adopted, sheet flexure theory of elasticity mechanics and approach of finite element are applied to design and calculate it, corresponding deflection and analytic formula and distribution curve of stress are given, and the specific achieving approaches of measuring principle and magnetic field sensing function of driving field in giant magnetostricitive rod are pointed out the magnetic field sensing function of the actuator is used to practically measure driving magnetic field of actuator and to obtain the relationship of driving magnetic field and coil current, which is also analyzed and studied

    其中,採用圓形膜片式柔性結構作為超磁致伸縮微位移執行器的微位移傳遞、感知一體化機構,應用彈性力學中的薄板彎曲理論、有元方法對其進行了設計、計算,並給出了相應的撓度和應力解析式及分佈曲;應用電磁理論給出了超磁致伸縮棒內驅動磁場的測量原理及磁場感知功能的具體實現方法,並利用執行器的磁場感知功能對其驅動磁場進行了實際測量,得出了驅動磁場與之間的關系,並對其進行了分析和研究;對執行器內部的電磁路和偏置磁路結構進行了設計計算與實驗研究,為了減小驅動的發熱,對其形狀進行了優化設計。
  12. However flux leakage is really exist, calculation through formular analytic method has more error, so electromagnetic field analysis is made by using finite element method ( fem ) in ansys7. 1 / multiphysics and ansys / emag programs. typical quantities of interest in a magnetic analysis are available such as magnetic flux density, magnetic field intensity, magnetic forces, power loss and flux leakage in the system of magnetic levitation. then gain the current in the coil which control levitation gap when the stage is stable

    由於存在漏磁,用公式的解析法計算有很大的誤差,因此本文採用有元法( fem )來計算磁懸浮系統磁場分佈,從而計算磁力,通過用ansys7 . 1軟體進行有元電磁場分析計算,得到平臺穩定懸浮時電磁所需電、懸浮氣隙等控制參數,由於設計的磁懸浮系統為非軸對稱結構,採用2d磁場分析有一定的誤差,而採用3d電磁場分析更接近實際。
分享友人