隔離方法 的英文怎麼說

中文拼音 [gélífāngfǎ]
隔離方法 英文
partition method
  • 隔 : partitionseparate
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 隔離 : keep apart; isolate; segregate; isolation; isolated; apartheid; enclosure; enisle; severance; seg...
  • 方法 : method; means; way; technique; process; procedure; plan; device; recipe; fashion; tool; maneuver
  1. All isolation techniques may be aesthetically unacceptable or even dirty.

    所有的隔離方法都有可能在美觀方面使人難以接受，或甚至是骯臟的。
  2. Animal health analysis methods - isolation and identification of brucella spp., except b. ovis and b. canis

    動物健康分析方法.不包括b . ovis和b . canis的布魯菌spp .的隔離和識別
  3. The method of obtaining high concentration of na2feo4 solution by quick electrolysis mainly contains four aspects : adoption of either a diaphragm or an ionic membrane electrolytic cell in which a thin anodic cell lying between the two cathodes, ( 2 ) using an iron anode that has larger specific surface area, ( 3 ) keeping suitable concentration of naoh in the anodic cell, adoption of lower current density and higher electrolyzing speed. the practical technique parameters follow a s below : the naoh solution of 14 - 16mol / l, the temperature of 303 - 308k, the surface anodic current density of 300a / m2, the unit electrolyzing speed of efficiency larger than 6. 0a / l

    快速電解獲取高濃度na _ 2feo _ 4溶液的方法，主要包括四個方面：採用兩陰極室夾一厚度較小的陽極室的隔膜（或離子膜）電解槽；使用比表面積較大的鐵網陽極；保持陽極室中有適宜濃度的濃naoh溶液；採用較低的電流密度和較高的電解速度。具體工藝參數是： 14 16mol / lnaoh溶液、溫度303 308k 、表觀陽極電流密度300a m ~ 2 、有效單位電解速度6 . 0a / l 。
  4. With account for the effect of temperature and shock - boundary layer interaction, the forebody / inlet with plane lip and wedge lip are designed by using the design methods of constant shock wave intensity and constant shock wave angle. in the design, the incidence angle of the first ramp, height of isolator, length of forebody and total turning angle of the designed forebody / inlet models are given

    另外，根據優選結果，給定前體長度、前體預壓縮楔角、總壓縮轉角及隔離段高度，分別用等激波強度和等激波角度的方法設計了唇口平直和唇口帶楔角的前體進氣道。
  5. One such scheme involves an improved control method designed to automatically quarantine trouble spots and gerrymander the remaining grid into islands of balanced load and generation

    可行方案之一是改良控制方法，自動將出錯的部份隔離起來，並將剩餘的電力輸送網重新劃分成數個供需平衡的獨立區域。
  6. Microbiology of food and animal feeding stuffs - horizontal method for the detection and enumeration of listeria monocytogenes - part 1 : detection method - amendment 1 : modification of the isolation media, of the haemolysis test and inclusion of precision data

    食品和動物飼料的微生物學.單核細胞增生性利斯特氏菌檢測和計數的水平方法.第1部分:檢測方法.修改件1 :隔離介質和溶血試驗的改進並包括精確數據
  7. Using the moral authority it had won by confronting both apartheid and communism, it challenged western governments whenever they seemed to be cutting legal corners ; in that spirit, it opposed britain ' s policy of internment in northern ireland

    利用其對抗種族隔離以及共產主義而贏得的道德權威，大赦國際也會向西方政府發起挑戰，只要它們在法律上有所乖違；本著這一精神，大赦國際反對英國在北愛爾蘭的拘留政策。
  8. Methods of test for masonry units - part 7 : determination of water absorption of clay masonry damp proof course units by boiling water ; german version en 772 - 7 : 1998

    磚石檢驗方法.第7部分:磚石隔離層沸水吸水量測定
  9. Even what once seemed to be reasonably local matters - - - zoning regulations, school desegregation, drainage problems, public transportation issues, licensing requests from competing cable television companies - call for specialists who debate technicalities and frequently confuse rather than clarify the issues

    即使是那些似曾被理所當然地當作地方事務的各項事宜，諸如區劃法規、廢除校園種族隔離、排水問題、公共交通問題，以及來自各互相競爭的有線電視公司的收視許可申請等等，現在也召集專家對其進行學術論證，可結果經常是越論證越混淆，根本無法澄清這些問題。
  10. This approach creates the false impression that applications are isolated from each other

    這種方法會造成應用程序互相隔離的錯覺。
  11. In hardware, we choose anti - disturbance photoelectric isolative sensor, take rc filter to resolve high - frequency for anti - disturbance. in software, we adopt arithmetic of recursion mean value to collective signal values to resolve low - frequency ac and pinnacle pulse disturbance

    在硬體方面，選用抗干擾能力強的光電隔離電量傳感器，並採取rc濾波抗干擾措施解決中高頻干擾問題；在軟體方面，對採集到的信號量採取遞推平均值演算法，解決低頻交流和尖峰脈沖干擾問題。
  12. The impacts of the substrate pn junction isolation on the inductor quality factor ( q ) are studied and experimental results show that a certain deep substrate pn junction isolation achieves good improvement

    結果表明這種方法是可行的， b一一定深度的襯底pn結隔離能有效的使q值提高。
  13. A novel method for reducing the substrate - rated losses of integrated spiral inductors is presented. the method is that directly forming pn junction isolation in the si substrate to block the eddy currents induced by spiral inductors. the substrate pn junction can be realized in standard silicon technologies without additional processing steps

    提出了一種新的方法來減小硅襯底損耗提高集成電感的q值：在硅襯底形成間隔的pn結隔離以阻止渦流減少損耗，這種方法工藝簡單且與常規硅集成電路工藝兼容。
  14. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性
  15. Standard test method for determination of ion exchange capacity in grafted battery separator

    接合蓄電池隔板中離子交換能力測定的標準試驗方法
  16. Fielding is the most efficient method for restraining conduct disturbance

    電磁屏蔽是抑制輻射干擾的一種有效隔離方法。
  17. By constructing filters dynamically to suppress influence of captured symptoms to fault detection, this technology can isolates new symptoms and thus the spectrum of symptoms detected are broadened and the accuracy with which symptoms are detected is increased

    針對事件過濾階段的主要問題，提出動態癥狀隔離方法，通過動態構造過濾器抑制已捕獲癥狀對故障檢測的影響，隔離出新的癥狀，擴大檢測癥狀的范圍和提高準確率； 4
  18. The concept of minimum distribution part ( mdp ) is put forward together with the adjacent table based method to divide a distribution network into several mdps. based on above theory ; a novel way to identify fault sections of a distribution network is presented. algorithm to isolate the fault section with minimum switch operations and identifying of over - tripped switches are discussed

    提出最小配電區域的概念，並基於等長鄰接表的數據結構建立了最小配電區域分解的方法，在此基礎上發展了一種新穎的配電網故障區域判斷和隔離方法，研究了以最少的開關操作隔離故障區域的方法和越級跳閘開關的判斷問題，探討了針對採用重合分段器的配電網故障區域判斷和隔離問題。
  19. Finally, the technique of vibration suppression is discussed. the passive isolation that is simple is adopted for high frequency part and the effort of high frequency suppression is obvious. the bandwidth adaptive that doesn ’ t need new plants is adopted for low frequency part and simulation results indicate that the scheme is valid for the suppression of bit error rate increasing produced by satellite platform vibration

    最後對振動的抑制方法進行了研究，對高頻振動採用被動隔離方式，該方法操作簡單，對高頻振動抑制效果顯著;對低頻振動採用了自適應帶寬抑制方式，該方法無需添加新器件，對抑制低頻振動帶來的誤碼率增加作用明顯，並進行了模擬驗證。
  20. Because that the inertial measurement system is very important in the federated filter, the component fault diagnosis and isolation algorithms in the inertial measurement system are also discussed. 3

    由於慣性測量子系統在聯邦濾波結構中有著舉足輕重的作用，因此本文還提出了慣性測量子系統的部件級故障檢測與隔離方案和演算法。
分享友人
分享到 Line

分享到臉書