隔離診斷 的英文怎麼說

中文拼音 [gélízhěnduàn]
隔離診斷 英文
isolation diagnostic
  • 隔 : partitionseparate
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 診 : 動詞（診察） examine （a patient）
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 隔離 : keep apart; isolate; segregate; isolation; isolated; apartheid; enclosure; enisle; severance; seg...
  • 診斷 : diagnose; diagnosis; diacrisis
  1. This new family of dsp enables cost - effective design of intelligent controllers for brushless motors which can fulfill more conditions, consisting of fewer system components, lower system cost and increased performances. in the aspect of vibration detection and analysis, the system gets two - way vibration signals. after magnifying and filtering, the signals are inputted to dsp, and are analysised by dsp based user ’ s demand

    振動測試分析部分採集兩路振動信號，經過隔離放大、濾波等信號調理電路后輸入dsp的片上ad模塊，在dsp上構建相應的數據採集模塊，以及濾波、時域分析、幅域分析等多種數字信號處理模塊，根據用戶需求對旋轉機械作相應的檢測與診斷。
  2. The fault diagnosis system includes four parts : sampling and insulation of the synchronous signal, sampling of the voltage waveform of the rectifier, logic pre - processing and dft analysis, display and alarm circuit

    故障診斷系統主要包括同步信號的取樣與隔離、整流電壓的采樣、邏輯預處理及dft分析，診斷顯示報警電路等四部分。
  3. Fault detection ( fd ) technology supervises the status of production process, detect the fluctuation and faults, and locate the fault sources, then isolate and eliminate them. in this way, calamities are prevented and fluctuations of quality of products are reduced

    故障診斷技術通過監督生產過程的運行狀態，不斷檢測過程的變化和故障信息，並在故障發生后，迅速定位故障源，隔離並消除故障，以防止災難性事故的發生，同時減少產生質量的波動，提高產品的競爭力。
  4. In simulations, all important phenomena, such as non - neutral sheath widening near cathode, cathode electron emitting, current channel migrating to the load side of the plasma, ion accelerating toward cathode and magnetic insulation of cathode emitting electrons etc, have been observed and depict the internal physics of this device. also presented is the influence of cathode emitted electrons on phenomena in the conduction processes of pegs. the simulation results show, without cathode emitted electrons, rapid magnetic field penetration takes place only in region near the cathode, with cathode emitted electrons, magnetic field penetration takes place in all plasma region

    診斷發現了陰極表面非中性鞘層的形成、陰極電子發射、電流通道的漂移、等離子體離子加速以及陰極電子磁隔離等物理現象，揭示了這一斷路器件的物理機制；分析了陰極電子對peos導通過程中的物理現象的影響，模擬結果顯示：忽略陰極電子作用，磁場滲透現象主要出現在陰極表面區域，考慮陰極電子作用，磁場滲透現象出現在整個等離子體區域。
  5. Dengue is an enigmatic virus, difficult to diagnose and impossible to quarantine

    登革熱病毒是一個謎一樣的病毒，它很難被診斷出來也不可能被隔離。
  6. In particular, the bond - graph - based method and the miniature mode estimation system can used to detect and isolate faults in spacecraft propulsion system. the results show they are suitable for the fault de tection and isolate of hybrid systems like spacecrafts

    針對混合系統的故障檢測與診斷問題，本文以推進系統為對象，研究了鍵圖理論和miniaturemodeestimation方法在其故障檢測與隔離中應用與實現方案。
  7. The built - in test ( bit ) is an integral capability of the mission system or equipment which provides an automated test capability to detect, diagnose or isolate failures

    機內測試（ built - intest ， bit ）是系統或設備自身為故障檢測、隔離或診斷提供的自動測試能力。
  8. Rotating machines ( i. e. gear - box ) are always assembly of many associated parts, such as gears and bearings. commonly, high rate of fault isolation for such machines need enough test points. since the machines are always too compact to fix enough sensors, it is significative to study on how to use fewer sensors for machine monitoring and fault diagnosis by vibration analysis of rotating machine groups

    復雜的旋轉機械往往由軸承、齒輪等大量零件構成，在對這樣的設備進行狀態監控和故障診斷時，為提高故障隔離率，通常需要為每個零件就近安裝傳感器，但由於機械結構的緊湊性和性價比的限制，這一點往往難以實現。
  9. Failure detection and isolation ( fdi ) is the key technique of srfcs, which can forecast the occurrence of potential failure, tell why and where it occurs, and then provide relevant information for trigger test, control law reconfiguration and automated maintenance diagnostic

    故障檢測與隔離是自修復飛控系統的核心技術之一，它能及時判斷故障發生的原因和部位，預測潛在故障的發生，進而為及時預警以及進行飛行控制律重構和自主維護診斷提供相關信息和依據。
  10. Failure detection and isolation ( fdi ) is the key technique of srfcs, which can forecast the occurrence of potential failure, tell why and where it occurs, and then provide relevant information for trigger test, control law reconfiguration and automated maintenance diagnostic. flight control law reconstruction is the another core

    故障檢測與隔離是自修復飛控系統的核心技術之一，它能及時判斷故障發生的原因和部位，預測潛在故障的發生，進而為及時預警以及進行飛行控制律重構和自主維護診斷提供相關信息和依據。
分享友人
分享到 Line

分享到臉書