集中控制循環 的英文怎麼說

中文拼音 [jízhōngkòngzhìxúnhuán]
集中控制循環 英文
central control cycle
  • 集 : gatherassemblecollect
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 循 : 循動詞（遵守; 依照; 沿襲） follow; abide by
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 集中 : concentratecentralizefocusamassgroupmassingput togather
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 循環 : circulate; circle; round; repeat; loop; period; recurrence; cycling; circulating; mixing; circula...
  1. Abstract : in the research of internal combustion engine, recordingin - cylinder pressure and temperature is an essential technique to study the thermal cycle of internal combustion engine. the combustion analyzer developed in this study will give both the measurements at sampling points per crank angle or sampling cycle, calculate and show the real time parameters which decide the working process of internal combustion engine, such as pressure accelerating rate, indicateed mean effective pressure, cycle - to - cycle variation, heat release rate, etc. compared with the imported congeneric products, the analyzer has many advantages such as chinese interface, low price, easy operateing, convenience in maintainance and easy upgrading

    文摘:為了測錄內燃機缸內的壓力及溫度，開發了一種內燃機燃燒分析儀.該分析儀由國產高速數據採集卡及自行開發的控制軟體組成.它不僅能精確設置每度曲軸轉角內采樣點的個數和採集循環數，而且在採集過程中能實時計算和表徵內燃機工作過程的壓力升高率、平均指示壓力、循環變動率、放熱率等參數.經實際使用以及與國外產品相比表明，此分析儀具有全中文界面、價格低、操作簡單、使用維護方便、功能便於擴充等優點
  2. Optical power meter real - time monitor optical power of each optical cable, and control computer gather the value of optical power attenuation circularly, if some values excess the limit, the computer control optical switch to connect another spare optical fiber with otdr card, control the otdr card to test the optical fiber, and then find the malfunction point accurately. the system require software system to run with hardware devices tother. this paper analyze requirement and technical feasibility in software system, ooa and uml are used to analyze software and abstract the class diagram

    通過光功率計對每條光纜中的備用光纖進行實時的監控，測試光功率的衰減值，主控計算機不斷循環的對每個光功率模塊進行數據採集，並記錄每路光信號的光功率衰減值，然後進行分析處理，如發現達到設定的光功率衰減門限值就報警，並控制光開關的切換，將故障光纜中的另一備用光纖與otdr卡連接，通過otdr卡對該光纖進行測試，從而確定故障點。
  3. The application of dcs to control system for circulating fluidized bed boiler, including the drum water level control, steam temperature control, hearth negative pressure control, fuel control and circulating fluidized bed temperature is introduced

    摘要介紹了集散控制系統在循環流化床鍋爐控制系統中的具體應用，包括汽包水位控制、蒸汽溫度控制、爐膛負壓控制、燃料控制和爐床溫度控制。
  4. Central control cycle

    集中控制循環
  5. By applying the theory and method of geological anomaly, it is focused on the analysis of the characters of major geological anomalies and their effect of mineralization in daye - jiurui region. the analysis result shows that the basement fault anomalies control a few major large hidden batholiths and their associated orefields ; that the anomalies of cover structure confine most cu - au deposits and fe - cu deposits within their scope ; that the geochemical anomalies and lithofacies - paleogeographical anomalies are major geological factors leading to trataboundness of some cu - au deposits ; that the anomalies of rock operties provide the favorable chemical and physical conditions for the ore - forming process, including the seepage, circulation, convergence and deposit of ore - bearing hydrothermal solution ; that the anomalous ctive stage of mesozoic magmatite is almost consistent with the major mineralization epoch of the fe, cu deposits, and the structure of multi - levels, and the zoning in magmatic system determine the spatial distribution of the mineralization system. then, based on the above analysis, a comprehensive variate, geological combination entropy, is brought forward for reflecting the complex degree of the combination of geological ore - controlling factors. after circumscribing the anomalies of geological combination entropy, the relations between the anomalies and ore deposits are determined

    從地質異常的角度，重點分析了大冶九瑞地區主要地質異常的特徵及其對成礦的影響.由分析可知：基底斷裂異常控制了本區若干重要規模較大的隱伏巖基及伴生礦田，而蓋層構造異常控制銅金礦床和鐵銅礦床的空間位置；地層的地球化學異常和巖相古地理異常是造成一些銅金礦床層控性的主要地質因素；蓋層的巖性異常為含礦熱液的滲流、循環、聚集和礦質沉澱等一系列成礦作用提供了有利的物理和化學條件；中生代巖漿巖的異常活動期也是本區主要的鐵銅成礦期，巖漿巖系統的多層分枝和分帶性結構控制了本區成礦系統的三維空間分佈.在上述分析的基礎上，構置了地質組合熵作為反映控礦地質因素組合系統結構復雜程度的綜合變量，並圈定出組合熵異常，由此確定了綜合地質異常與礦床的關系
  6. In this paper introduced the study of fuzzy controller which was used for co2 supplying control from co2 source - high - pressure steel tin to culture box, studied the control of relative humidity and co2 concentration in the culture box and effects of co2 enrichment ( enrichment concentration was 900 - 1100mol mol - 1 ) on the growth of chrysanthemum plantlet and tried to clean the air in the culture box by cycling the results indicated that this environment control system operates normally and reliably. it can keep the co2 concentration and relative humidity in setting scope ; it is good to the growth of the culture plantlets to clean the air in culture box by cycling ; co2 enrichment can promote the growth and photosynthetic and can increase the percentage of shooting the number of new leaves of the chrysanthemum plantlet cultured under co2 - enriched condition is 1. 85 times of the plantlet cultured under co2 - nonenriched condition ; the number of the roots of the chrysanthemum plantlet cultured under co2 - enriched condition 5. 67 times greater compared with the plantlet cultured under co2 nonenriched condition

    結果表明：所研製的無糖組培微環境co _ 2增施監控系統工作正常、穩定、可靠，能有效地將組培箱內的co _ 2濃度及其相對濕度控制在設定范圍內；用箱外循環法對箱內氣體凈化處理后，改善了組培箱內的氣體環境，有利於組培苗的生長發育； co _ 2富集環境中，組培苗生長健壯、發育良好，生根率顯著提高，根系發達。本實驗條件下，處理組菊花組培苗的新增葉片數是對照組的1 . 85倍；處理組的根總長是對照組的10 . 6倍；處理組根數是對照組的6 . 67倍。
  7. After finished the cyclic voltammetry experiments, the results showed that iron steel grid can act as good current collector in the aqueous electrolyte. while the scan rate was fall in the range of 0. 5 - 4. 0mv / s, electrochemical reaction of the lithium insertion / extraction in the solid phase was kinetically limited by the diffusion of lithium ions. after 40 cycles in aqueous electrolyte the discharge capacities of sample of s13 reached 77mah / g, and showed good cycle performance

    在水溶液中不銹鋼網可以作為電極的集流體，在0 . 5 - 4 . 0mv / s的掃描速度范圍內，鋰離子在尖晶石鋰錳氧化物的嵌入和脫嵌的電化學反應在動力學上是受鋰離子在固相中的擴散所控制，充放電實驗顯示樣品s13在水電解液中經過40個循環后達到77mah / g的放電容量，具有很好的循環穩定性。
  8. The machine is concentrated the button control. it can carry out to move adjust is automatic with half circulating two kinds of operation norm

    本機器為集中按鈕控制，可實現手動調整和半自動循環兩種操作規范。
  9. The effective internal control is the essential component of company ' s high - efficient management. sir adrian cadbury even affirmed, “ the failures of the companies were all caused by failures of the internal control. ” the accounting law which has been implemented in july of 2000 regulates every company should establish and improve supervising system of internal accounting, and put forward the concrete requirement. this is the first law of our country to reflect requirement of internal control. after that, the ministry of finance released successively ten regulations of internal accounting control, which have greatly promoted the development of the internal control in the company. at present, the majority of the enterprises have already established the internal control system according to the requirement of relevant laws and regulations

    然而，內部控制並不是靜態的，而是一個動態循環的過程（設計? ?執行? ?評價? ?改進） ，其中內部控制評價是內部控制運行過程中非常關鍵的一環。越來越多的研究者開始關注內部控制評價，並對其進行研究，但這些研究基本集中於內部控制評價在審計監督領域中的應用，很少從企業經營管理需要的角度來研究內部控制評價。而內部控製作為現代企業高效管理的必要組成部分，關系著企業的生死存亡，因此，探討內部控制評價在經營管理領域中的應用具有極為重要的現實意義。
  10. The monitoring and controlling system adopts a total distributed control system ( dcs ) constituted by a programmable logic controller ( plc ), a computer ( pc ) and thermal power engineering signal sensors, sender, controller, etc. plc is used to collect data and perform automatic control mostly, while pc is adopted to monitor the operation process, analyze, display and store data

    本項研究中採用可編程式控制制器（ plc ）作下位機、工業控制計算機（ pc ）作上位機與熱工參數測量傳感器、變送器、操作控制器等組成集散型控制系統（ dcs ） ，上位機和下位機自動監測垃圾焚燒鍋爐的各運行參數，並對異重循環流化床垃圾焚燒鍋爐實行自動控制與調節。
  11. You can add controls to, or remove controls from the collection, and iterate through the controls in the collection

    您可以在集合中添加控制項，也可以從中移除控制項，並且可以循環訪問集合中的控制項。
  12. You can add controls to the collection, remove controls from the collection, or iterate through the server controls in the collection

    您可以向集合添加控制項、從集合中移除控制項，或者循環訪問集合中的服務器控制項。
分享友人
分享到 Line

分享到臉書