集總 的英文怎麼說

中文拼音 [jízǒng]
集總 英文
lumping
  • 集 : gatherassemblecollect
  • 總 : Ⅰ動詞（總括; 匯集） assemble; gather; put together; sum up Ⅱ形容詞1 （全部的; 全面的） general; o...
  1. In addition, this paper numerically investigated the influence of the lumped parameters of the gunn diode on the frequency of the oscillation, and the tuning techniques of the oscillation frequency of the active antenna

    本文還利用fdtd法數值研究了gunn二極體的集總參數對振蕩頻率的影響以及有源天線振蕩頻率的調諧技術。
  2. Lumped equivalent circuit of planar spiral inductor for cmos rfic application

    平面螺旋電感的集總等效電路
  3. The dynamic model of misaligned rotor - bearing system equipped with a flexible laminated membrane coupling was developed by using the method of lumped parameter in this dissertation, and the dynamic behavior, such as the nature characteristics, stability, steady state response of the system, etc. was analyzed based on the theory of linear vibration

    本文根據集總參數法建立了膜片聯軸器耦合的不對中轉子?軸承系統的動力學模型。基於線性振動理論分析了系統的固有特性、穩定性和不平衡響應。
  4. When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved

    分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。
  5. An element is lumped if its terminal relation is an ordinary differential equation as opposed to a partial differential equation.

    如果一個元素的端子關系是一個常微分方程，其反面為一個偏微方程，則它是集總的。
  6. Every president of the united states takes an oath to preserve, protect and defend the nation they serve

    來到最後一集《總統的抉擇》 ，在第二次世界大戰期間，羅斯福再度連任總統。
  7. The chain structure model can offer a new idea for improving the precision of lumped - parameter model

    鏈式結構的集總參數模型在提高模型精度方面也提供了一種思路。
  8. On the basis of the insertion structure mathematical model, the modeling method for single - phase section of boilers is improved and a new modeling method chain structure modeling method based on lumped - parameter is presented

    在嵌套結構參數模型的基礎上，對鍋爐單相區的數學模型加以改進，提出了鏈式結構的集總參數數學模型，並對其進行模擬。
  9. Systems are lumped, time-invariant, or linear if all their elements have these properties.

    如果一個系統的所有元素都有集總的，非時變的或線性的性質，則該系統是集總的，非時變的，或線性的。
  10. ( 3 ) a lumped parameter model with 18 parameters to represent luncher is proposed. ( 4 ) the characters of machine gun system ' s firing dynamics are simulated in the linear way and nonlinear way

    針對機槍射擊過程中人體抵肩的作用特點，提出一種18參數的集總參數人體抵肩模型，以全面考慮人體力學特性的隨機性和射手的多樣性這一客觀情況。
  11. Study on lumped parameter model for simulation of ventilator

    集總參數呼吸機模型模擬研究
  12. Distributed hydrologic model

    集總式水文模型
  13. A novel model for residual fluid catalytic cracking process ( rfcc ) is proposed. it divides the whole reactor into two part : the riser as ideal pipe flow reactor and the sett - ler as ideal cstr. the model contains six lumps reaction kinetics with serial and parallel network

    通過將實際裝置中發生裂化反應的提升管和沉降段反應器分別考慮為理想的活塞流反應器和連續攪拌式反應器，建立了簡化的渣油催化裂化反應6集總組分的串列和并行反應動力學網路模型。
  14. So it was worth studying synthetic lightning protection measures on demonstration of the situation of the mianyan bureau ' s 35kv lines. on the basis of collecting and summarizing the lightning protection data of our 35kv lines, this paper mainly analyzed the lightning protection status of 35kv line

    本論文所研究的主要內容就是通過收集、總結我局35kv線路防雷運行資料，分析35kv線路防雷現況，並以我局典型的遊仙分局35kv魏玉線路為研究對象，通過對該線路每基桿塔的現場實測數據來利用波過程理論建立數值計算模型。
  15. Meanwhile the 0 dimension 1 dimension plane wall 2 dimension models are established. using the mathematic and ansys software the numerical and soluble analyses can be got for the thermal shock model of the piston. compare the simulation results to the test results the temperature field and stress field can be got which are quite close the thermal shock situation

    同時建立活塞熱沖擊的集總參數、 1維平壁和2維模型，應用mathematic軟體和ansys軟體，對所建立的活塞熱沖擊模型進行了解析和數值分析，利用模擬計算與試驗結果相結合的方法，獲得接近於內燃機活塞熱沖擊的溫度場與熱應力場分佈，從而更加全面深入地了解在熱沖擊條件下活塞的溫度場和應力場變化規律。
  16. The lumped circuit model of gunn diode was incorporated into the fdtd arithmetic

    Gunn二極體的集總電路模型被編入了fdtd演算法。
  17. From the results, we can know that, the key way to raise the inductor quality factor and self resonance frequency is to less substrate eddy current loss. the simple model can accurately equal to each parameter on integrated inductor

    由模擬結果可知，提高集成電感品質因數與自諧振頻率的主要途徑是要減小襯底的渦流損耗，其簡約集總模型可較為精確的等效集成電感各埠電氣特性。
  18. Traditionally, the saturated zone is modeled as a simple lumped continuity equation :, dsitqsdt where t is time, s is the total storage in the reservoir, i is the spatially integrated volume of incoming wa - ter, and q is the discharge subsurface runoff which only depends on the total storage s. this kind of subsurface runoff model has many different parame - terizations 10 12, however it has a very common char - acteristic that the subsurface runoff is just a sin - gle - valued storage - discharge function

    對于大尺度水文模型而言，目前常常採用的是集總式的地下徑流機制，其連續性方程一般可表示為d ， dsitqst ? 1這里t是時間， s表示整個流域潛水面土壤層的飽和區域總的水分儲存量， i t表示t時刻土壤的非飽和區域向整個潛水面的水分補充量， q s表示僅依賴於水分儲存量s的地下徑流量量
  19. The kinetic characteristics of two - stage riser fluid catalytic cracking ( tsrfcc ) technology were studied, and experimental data were simulated by using the modified three lumping kinetic model of tsrfcc

    摘要利用修正的兩段提升管催化裂化的三集總動力學模型分析了兩段提升管催化裂化技術的動力學特點，並對中試裝置的試驗數據進行了擬合。
  20. The process mechanism of tar cracking was investigated in kinetics view, in which a five - lump kinetic model was erected. the whole tar was divided into five lumps of different kinetic behavior in cracking process, and the kinetic parameters used to construct the kinetic model of each lump was achieved by optimally fitting experiment data

    在從動力學角度研究焦油催化裂化過程中，採用集總的思想將整體焦油劃分為具有不同動力學行為的五個集總，集總中的各組分的動力學行為都由集總來代表。
分享友人
分享到 Line

分享到臉書