離子激光器 的英文怎麼說

中文拼音 [ziguāng]
離子激光器 英文
ion laser
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 離子 : [物理學] ion
  • 激光器 : [光學] (光激射器) laser (縮自 light amplification by stimulated emission of radiation); optic...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Argon laser induced auto - fluorescence spectra of normal tissue, benign adenoma and cancer of thyroid were investigated in vitro

    摘要用氬離子激光器作為源,對甲狀腺正常組織、良性瘤及癌的體組織標本進行了誘導組織自體熒譜分析。
  2. The laser damage threshold of the ybyp _ xv _ ( 1 - x ) o _ 4determined by nd : yag laser, which showed a decreasing tendency with the increase of the dopant concentration

    利用nd : yag測試晶體的損傷閾值,隨著摻雜濃度的增大,損傷功率密度呈減小趨勢。
  3. This article studies on a novel method about detector calibration and monochromator calibration by using silicon pin photodiode. the detector and the monochromator of one spectrum measurement system had been calibrated using the method, and the spectrum distribution of one laser - produced plasmas ( lpp ) source with jet gas target was measured. the use of a specific combination of the silicon photodiode and multiplayer reflect films is the notable character in monochromator calibration

    本文研究了一種利用電二極體傳遞標準探測標定普通探測和單色儀系統的方法,實際標定了所用的探測和單色儀系統,測得了噴氣靶源的相對譜分佈,設計出絕對譜分佈的測量方法,並且利用labview的g語言及相應的數據採集卡等硬體設備構造出一套智能化、高效率的測量系統,完成了多層膜反射率測量工作。
  4. Measuring mathod of major parameter for argon ion lasers

    離子激光器主要參數測試方法
  5. Argon ion laser

    離子激光器
  6. Radio - frequency excited ion laser

    射頻離子激光器
  7. This paper gives a description of discharge tube, mirror, laser head and laser power supply of an air cooling argon laser which output is over 1w, and shows its properties

    介紹輸出功率超過1w的風冷氬離子激光器的放電管、反射鏡、頭部和電源的設計考慮,給出了它的性能。
  8. If the focal point of the len shifts around the surface of the sample, the mass ablation, the temperature of the plasma and the spectral intensity appear asymmetric and their maximum occur at the location which is about 0. 4mm under the surface of the sample. ( 2 ) to the plasma of the aluminum alloy sample, when the operating voltage is 1600v, the height from the observed location of the plasma to the surface of the sample is 2mm and the argon pressure is 660 torr, the spectral intensity have the maximum values

    ( 2 )對于標準鋁樣品,在工作電壓為1600v 、等體觀測高度為2mm 、氬氣壓力為660乇時,其譜線強度最強;以al 308 . 22nm 、 al 309 . 27nm兩條譜線為分析線,發現隨著環境氣壓的增大,譜線自吸效應明顯增強,當環境氣壓達到600 - 700乇時,譜線幾乎產生自蝕。
  9. In this experiment, a neodymium glass laser is used to study the effects of the operating voltage, power density, the height from the observed location of the plasma to the surface of the sample, the location of the sample, the gas composition and the pressure on the intensity and quality of the spectrum

    本文採用高能量釹玻璃,研究了工作電壓、功率密度、等體的觀測高度、樣品位置、環境氣體及氣壓對等體的譜線強度及譜線質量的影響,獲得了最佳的實驗條件,並測量了金屬分析樣品中某些元素的含量。
  10. Due to great advantage of the excimer laser in photoelectron material, photoelectron technology research, so in this thesis, a xecl excimer laser is designed in order to solve some problem in semiconductor film, cmr film, quartz film and other kind of film application, optical etching field, interaction between laser and material, material plasma study. the parameters of the excimer laser is e also measured and analyzed

    因此本文以氣相沉積、外延生長、巨磁薄膜、金剛石及其它薄膜制備及后續的刻,與物質的相互作用,等體研究為目的,研製獲得了脈寬18ns ,單脈沖能量150mj ,矩形斑大小2cm 1cm ,束散角3mrad ,最高重復頻率5hz的xecl準分
  11. In this paper, some investigation and design as following. have been carried out on er - yb codoped phosphate glass waveguide laser first, three primary performance parameters of er - yb waveguide laser pump threshold power ; output power and slope efficiency have been commulated and analysed theoretically based on er ~ ( 3 + ) - yb ~ ( 3 + ) energy configuration ; rate equation of stable state and transmitting equation. the influences of er - yb ions concentration ; enabled waveguide length ; light dot radius of signal light and pump light ; reflectivity of output lens on three above parameters have been researched

    首先,從er ~ ( 3 + ) - yb ~ ( 3 + )能級結構出發,結合穩態速率方程與傳輸方程,對鉺鐿波導的三個主要性能參數:閾值功率、輸出功率、斜率效率作了理論計算分析,並研究了鉺、鐿濃度、波導活長度、信號與泵浦斑半徑比例、輸出耦合鏡反射率對這三個關鍵性能參數的影響。
  12. Firstly, the paper discusses the characters, principles of excimer laser, and study on pulse discharge process. secondly, for the purpose of designing excimer laser, i spent a lot of time to researsh and finish electrode designing, reducing circuit inductance, spark gap designing, ns discharge, uv preionization, glow discharge

    本論文首先對準分特點,原理,脈沖放電進行了評述,其次,以試制xecl準分為目的,探索並完成了電極設計、迴路電感減小方法、火花開關設計、 ns陡前沿放電、紫外預電、輝放電、脈沖功率技術研究。
  13. The output spot - size of our non - flowing tea co2 laser is quite large, only slightly smaller than the section of the excited media, this agrees with the calculated spatial distributions of the initial electron density for pre - ionization well

    由我們的非流動型teaco _ 2獲得的輸出斑相當大,僅比活區截面略小,這與理論計算的預電初始電密度空間分佈規律有較好的一致性。
  14. The optimized experimental conditions are determined and the densities of some elements in the mental alloy standard samples are measured. the experimental results shows that the spectral intensity of the plasma enhances significantly with the increase of the operating voltage and the power density. ( 1 ) to the steel ally sample, the emission intensities of the spectra reach to the maximum values when the laser operating voltage is 1600v and the argon pressure is 600 torr. under the same pressure, the spectral intensity of the plasma in the argon atmosphere is stronger than that in the air. when the argon pressure is 320 to rr, the signal - noise ration is about 5 times than that which the argon pressure is 700 torr, but the temperature of plasma is less about 1000k

    ( 1 )對于譜標鋼準樣品,當工作電壓為1600v 、氬氣壓力為600乇時,譜線強度達到最大,並且在相同壓強下,氬氣中的等體與空氣中的等體相比,其輻射強度明顯增強;氬氣壓力為320乇時的譜線信背比約為600乇條件下的5倍,而等體溫度卻下降了近1000k ,即等體溫度隨環境氣壓的增大而增大;當束的焦斑在樣品表面上下移動時,誘導量、等體的發溫度、譜線強度都呈不對稱性分佈,其最大值對應的焦斑位置都位於樣品表面之下0 . 4mm左右。
  15. The first ytterbium - doped yttrium - aluminum garnet ( yb : yag ) laser action was reported back in 1965 using a lamp - pumped rod at 77 k. because of poor spectral overlap of the lamp with the the trivalent ytterbium ion ( yb3 + ) absorption band, the efficiency was very low. lamp - pumped nd : yag lasers fared better due to the multiple pump bands of neodymium

    但yb3 +的泵浦吸收帶與閃譜匹配很差,導致其效率很低;而nd : yag的( nd3 + )有多個泵浦帶與閃譜匹配,較好適應了燈泵浦的需要,長期占據了固體的主導地位。
  16. Abstract : this paper describes the thermal effects of a coaxial rf - excitedco2 laser , based on the balance equations of electron density and energy , current continuity equation , and heat conduction equation. depende ncies of the spatial distributions of gas temperature on some discharge parameters arediscussed

    文摘:通過求解放電等體中的帶電粒密度和能量的平衡方程、電流連續性方程以及熱傳導方程,研究了同軸射頻( rf )勵co2中放電混合氣體的溫度效應,分析了有關放電參數對溫度分佈的影響。
  17. Study of passive q - switched unit of ndyag laser using ion - implanted gaas

    注入sigaas做被動調q元件的研究
  18. 2. considering the energy level structure and the spectrum characteristics of yb3 + ion, we deduce the relationships between laser performances of yb3 + - doped double clad fiber laser and parameters of laser cavity from the steady state rate equations with a new model

    2 .討論了yb3 +的能級結構和譜特性,並從穩態速率方程,結合諧振腔結構特點採用ido kelson和amos hardy的模型,給出了雙包層的輸出特性與諧振腔結構參數的關系準解析表達式。
  19. Abstract : a laser damage facilities, which has mm size spot and operates in tem00 mode , were achieved. in order to know the reasons of laser damage, the laser energy density was controlled near the damage threshold of the oxide thin films. according to the examined near - threshold damage morphology, the damage mechanisms of the optical coatings can be divided into two types. one was caused by melting of the coating materials, another by exploding, induced with the inner stress of the film. the plasma generated was an important reason to expand the damage area

    文摘:採用毫米量級大斑的近單模的,控制入射薄膜表面的能量,獲得了幾種常見單層膜和增透膜的損傷形貌,實驗結果表明,薄膜的損傷可區分為熔化型和應力型兩種,薄膜表面等體對損傷斑點的擴大有重要作用。
  20. When passed through the beam - splitter, a pulsed laser beam was split into 3 beams with an interpulse delay of 13 ns. these 3 separated laser pulses reach the m - z interferometer at different time and each laser pulse gave a snapshot of the implosion state. thus three different - time interferograms can be obtained in one shot of z - pinch

    發出的束經過分系統被分成時間間隔13ns的三束,它們于不同的時刻先後到達m - z干涉儀,每一束脈沖可以記錄下等的一個狀態,從而可以得到三幅不同時刻的干涉圖。
分享友人