離子電子法 的英文怎麼說

中文拼音 [lízidiànzifǎ]
離子電子法 英文
ion electron method
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 離子 : [物理學] ion
  • 電子 : [物理學] [電學] electron
  1. Removal and recovery chromic acid from electroplating waste by ion exchange

    離子交換法去除與回收電鍍廢水中鉻酸的實驗研究
  2. This paper describes a system for preignition in motorcycle engine using spark plus as a detecting probe, the author carries out researches on a method how the ionic current coins into being

    摘要本文描述了一種直接利用火花塞電極作為傳感器檢測南方摩托車發動機早燃的方法，作者在文章中詳細分析及討論了離子電流的產生機理。
  3. Standard test method for elements in water by inductively - coupled argon plasma atomic emission spectroscopy

    用電感耦合氬等離子原子發射光譜法對水中元素的標準測試方法
  4. In this article, the bellcore method was used to prepare polymer electrolyte membrane based on pvdf - hfp, and polymer electrolyte membranes under different conditions were prepared by changing sorts of solvents 、 ratio of dbp and solvent. effects of ratio of plasticizer and solvent on the liquid uptake 、 sem 、 mechanism capability 、 ionic conductivity 、 electrochemical stability window of polymer electrolyte membrane were also studied. through optimizing the preparation technics, the integrated effects of additives such as pc 、 ec 、 dbp and nanophase al2o3 on the ionic conductivity 、 liquid uptake were studied

    本文以聚偏氟乙烯-六氟丙烯共聚物pvdf - hfp為基質，採用bellcore制膜法制備了pvdf - hfp聚合物電解質膜，通過改變增塑劑dbp的含量、溶劑的種類及溶劑的含量制備了不同條件下的聚合物電解質膜，分別研究了增塑劑含量、溶劑含量等對聚合物電解質膜的吸液率、表面形貌、機械性能、離子電導率、電化學穩定窗口等的影響;對制備工藝進行了優化，研究了各種添加劑如pc 、 ec 、 dbp及納米al2o3對聚合物電解質膜的離子電導率、吸液率等性能的綜合影響。
  5. The analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail

    摘要採用氧彈燃燒法配合氟離子電極對有機濃劑型和水溶性氟碳漆中氟碳樹脂含量的分析方法進行了研究。
  6. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  7. The results show the ionic current signals can be used to detect the a / f ratio, which provide the basis investigation for the application of ionic current in engine

    分析了空燃比、預混壓力變化與離子電流信號的關系，試驗研究表明離子電流法可用來檢測空燃比，為在發動機上的應用提供了基礎性研究。
  8. Citing concerns about lithium - ion - battery reliability, toyota executives on monday said they are taking a cautious ' step - by - step ' approach to developing plug - in hybrid electric vehicles using lithium - ion technology

    豐田汽車管理人員周一談到了對鋰離子電池可靠性的擔憂，稱他們正在採取謹慎的「步步為營」的做法來開發採用鋰離子電池技術的可充電混合動力車。
  9. Standard practice for testing nitrogen phosphorus thermionic ionization detectors for use in gas chromatography

    氣相色譜法用氮磷熱離子電離探測器測試的標準實施規程
  10. Firstly, a situ - polymerization method as the preparation process of gplb is introduced and pmma as the polymer matrix of the gel electrolyte is selected. the thermal polymerization process of the gel electrolyte is also optimized

    首先，採用了現場聚合法制備凝膠聚合物鋰離子電池的工藝，根據該制備工藝選擇pmma基作為該凝膠聚合物電解質的聚合物體系，然後對凝膠的熱聚合工藝進行了優化，確定了最佳的熱聚合工藝。
  11. In the mean time, i test the separator ’ s performance, including the rate of hole 、 the performance of absorbing electrolyte and the conductance eletrochemical steady range 、 machine intensity test, and then make bettery to test its cycle performance. the test result show that, the spreading separator get better performance, when dbp ’ s percentum reach 50 %, and dry temperature reach 90, after ultraviolet radiation disposal. the test show that, the separator has high conductance reach 6. 1 10 - 3s / cm ( 25 ), and the machine intensity can reach 3. 92 mpa, this separator can meet the need of making bettery, the bettery capability will go down after 30 cycle. and the bettery show worse performance under high temperature, under 70, the bettery will get fire. making the intensified seprator, i find that when dbp % : pvdf % = 40 % : 60 %, dbp % + pvdf % : sio2 % = 70 % : 30 %, the separator get

    但用其制備的電池循環30周期后容量發生衰減，並且電池高溫性能差， 70下電池燃燒;強化聚合物膜的最佳制備配比條件為: dbp : pvdf為40mass % : 60mass % ， dbp含量與pvdf含量之和與納米sio2含量比值為70mass % : 30mass % ;強化電解質隔膜的室溫離子電導率也可達4 10 - 3s / cm左右，完全能滿足聚合物鋰離子電池的使用需要;機械強度遠遠大於流延法制得的隔膜，達到108 . 84mpa 。
  12. In this paper, pure and doped ktp crystals were grown from the flux using a top - seeded method, and special technique have been used to lower the electrical conductivity to three orders of magnitude than common flux ktp, the values is up to 10 - 10 ( cm ) - 1, this overcame the shortcoming that common flux ktp cannot be used in e - o application field because of having higher electrical conductivity. the growth condition, doped elements and annealing technology were investigated. single crystals of ktp with high quality and big z - cut cross section were obtained by optimizing the parameter of crystal growth

    本實驗採用頂部籽晶熔劑法生長了純的以及不同摻雜的ktp晶體，用特殊工藝處理技術將普通熔劑法ktp的電導率降低了三個數量級，達到了10 ~ （ - 10 ） （ cm ） ~ （ - 1 ） ，解決了普通熔劑法ktp晶體由於離子電導率太大而無法用於電光應用領域的困難；對ktp晶體的生長條件、摻雜元素以及退火工藝等進行了研究，通過優化生長工藝技術參數，突破了工藝技術生長難關，得到了高光學均勻性、具有大z切面的ktp單晶。
  13. Standard practice for oil spill source identification by gas chromatography and positive ion electron impact low resolution mass spectrometry

    用氣相色譜法和正離子電子沖擊低解析度質譜法識別溢油源的標準實施規程
  14. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  15. General rules for ion selective electrode method

    離子電極選擇法總則
  16. Solid mineral fuels. determination of total chlorine content by oxygen bomb combustion. method using a specific electrode for chloride ions

    固體礦物燃料.用氧彈燃燒對氯的總含量的測定.特殊氯離子電極法
  17. The results show that for organic solvent typed fluorocarbon lacquer and specially treated water soluable fluorocarbon lacquer, the content of fluorocarbon resin can be determined accurately with the above method

    結果表明，採用氧彈燃燒法配合氟離子電極對有機溶劑型氟碳漆及處理后水溶性氟碳漆的氟碳樹脂含量能夠進行準確測定。
  18. Iontophoresis is a technique which the permeation rate of ionic drugs into the body is enhanced by applying an electric field between viable tissues

    摘要離子電滲療法是一種依靠在身體不同組織間施加電場來增加離子藥物滲透率的技術。
  19. The recent developments in normal spinel limn2o4 were reviewed, in the process of the solid state synthesis, we researched the effect of materials and synthesis temperature on crystal structure and electrochemical performance, which were characterized by dta - tg, sem, xrd as well as electrochemical performance testing. the structure, electrochemical performance and the correlations between them were all discussed in detail for these doped samples

    本文在綜述國內外鋰離子電池尖晶石型材料limn _ 2o _ 4研究進展的基礎上，結合dta - tg 、 sem 、 xrd和電化學性能測試等手段，系統研究了固相法制備鋰離子電池正極材料摻鈷錳酸鋰合成原料、合成溫度對所得材料外觀形貌、晶體結構和電化學性能的影響。
  20. By using a carefully optimized form of iontophoresis, we are able to deliver specified profiles of neurotransmitter directly to single synapses

    並經由謹慎的利用離子電泳法，我們可以直接傳送特定型式的神經傳導物質到單一突觸。
分享友人
分享到 Line

分享到臉書